Why Is My Airbag Light Flashing Nissan Altima?


This answer is provided because I occasionally see this topic asked when folks disassemble the center dash or work on their head units.

Here’s how to restart your passenger airbag warning light if you unplug the connector from your ac controls:

1. Start by turning the key from off to on.

2. Keep a watchful eye on the airbag light. It will remain on for a short while. switch the key off right away after it stops blinking (at the beginning of the flashing).

4. Continue to step 3 twice more to complete the cycle three times.

5. After turning the key, observe the light. It will then begin blinking in a new, slower pattern. In diagnostic mode now. No rush; you can watch this.

6. Turn the key off once more, count to five like you did in step 3 again, and then turn it back on. The airbag light should not be flashing any longer if the procedure was successful.


3) Count to five (1 Mississippi, 2 Mississippi . . . .)

4. Continue to step 3 twice more to complete the cycle three times.

5. After turning the key, observe the light. It will then begin blinking in a new, slower pattern. In diagnostic mode now. You can take a brief look at this.

6. Turn the key off once more, count to five like you did in step 3 again, and then turn it back on. If the process was successful, there would be no flashing of the airbag light.

I found it effective. After fixing, the air bag indication is now always on when I start the car.

of a second and fires. I don’t recall noticing this before to the problem. Can

Your airbag light is on for a number of reasons. You can adhere to this process to

– Turn the key to the ON position to start your ignition system, being careful not to crank the engine.

– As soon as the light turns off, turn the ignition system to the OFF position and remove your key.

– Two times through the first and second steps. Be aware that your blinking will change.

– Before starting the engine, make sure you’ve gone through steps 1 and 2 at least three times.

– Check to see whether the airbag light sign briefly illuminates before turning off permanently.

To get better results, repeat the preceding methods if the blinking doesn’t stop.

In reality, you should ascertain the causes before attempting to reset it to ensure there isn’t

First, the clock spring needs to be replaced.

The airbag clock spring’s primary job is to keep the electrical wiring and the driver’s airbag in sync by entwining in and out in relation to the steering wheel.

The airbag on the driver’s seat may send a Soft-code error to the airbag control module as a result of the thin circuit bands becoming worn or brittle. This may cause the airbag light to begin blinking. The circuit bands’ typical use is the cause of their deterioration.

Without the aid of a good OBD2 scan tool that helps identify the issue, it is impossible to diagnose the clock spring issue on your own. Even if you are certain that your clock spring is broken, we advise having it replaced by a professional.

If you replace parts of an airbag system on your own without taking the proper safety precautions, serious injury could result.

Why is the Nissan Maxima’s airbag light flashing?

If you’ve recently added a radio, new vehicle seats, or other electrical components in your Nissan Maxima, the airbag light might be blinking. Because your automobile believes there is a problem with the airbag deployment system, your airbag light is flashing.

What does the airbag light flashing indicate?

A flashing airbag warning light means there is a serious issue with the SRS system, therefore you should get it fixed right away.

Even while you should still take it to a repairman if the light remains on, there are a few things you may do first that might help.

If there is anything impeding the seatbelt sensor, such as dirt or anything else that may have fallen in there, start by looking at the seatbelt buckle.

If that doesn’t work, check to make sure the seatbelts aren’t tangled or trapped, then try giving them a vigorous tug to tighten them up. This could assist in resetting any tensioning sensor difficulties.

Grab a torch and perform a quick visual inspection under the seats, where the wiring to the seat and seatbelt sensors typically joins, to see if any wires or connectors have fallen loose.

A broken clockspring in the steering wheel is another probable factor. The clockspring serves as an electrical connection between the steering wheel and dashboard for features like the horn, radio and cruise control switches, and the airbag in addition to flicking the steering wheel back to the center after you turn.

The airbag and sensor circuit may momentarily open if the clockspring is somewhat worn, turning on the warning light. In some instances, reestablishing the connection can be done by simply spinning the steering wheel to full lock in each direction while still moving.

You should never inspect the airbag unit or disassemble it since it carries an explosive charge that might kill you.

How can I stop the flashing of my airbag light?

The airbag light connects the seat belt system and the airbag system as part of the Supplement Restraint System (SRS) in automobiles (and vice-versa). When you turn on your automobile, the airbag light comes on for around seven seconds before going out, signifying that the internal system check was successful and finished. When the airbag light either never turns on or stays on while blinking, an issue exists. The airbag light needs to be reset at this stage.

Examining seat belt components, fixing bad clock springs, and replacing faulty sensors are a few techniques for turning off an airbag light. New bulbs or a fully charged battery are other options. While most repairs can be done without a professional, others may.

The following 10 steps will reset your airbag light:

  • Turn on and off your ignition.
  • Test drive your car when it has been restarted.
  • Check the airbag switch for the passenger.
  • Check to see if the seat belts are in place and functioning properly.
  • Check to see if the passenger seat sensor is off.
  • Use a scanner with the ability to reset the SRS or airbag light.
  • Fix the broken airbag sensors.
  • Replace or repair a broken clock spring.
  • Check to see if the airbag is working properly.
  • seek for a specialist’s help.

Although not exhaustive, the list above includes tried-and-true methods for tackling the problem. Some of them might not apply to your vehicle because compatibility is always based on the year, make, and model. It is recommended that you have your service manual on hand when carrying out any of these fixes. Always follow the manufacturer’s recommendations, too. Let’s get started on resetting your airbag light right away.

On a Nissan, how do you reset the airbag?

  • Alternately turning the ignition on and off.
  • Air Bag warning lamp illuminates for 7 seconds before turning off, and ignition switch is turned OFF 1 second later.
  • Wait for more than three seconds after turning off the ignition switch.
  • Follow steps 1 through 3 twice.
  • Activate the ignition switch.
  • The SRS lamp has been turned back on.

Driving while the airbag light is flashing is it safe?

No, driving while the airbag light is on is not safe. When the airbag light comes on, the vehicle’s airbag system is malfunctioning. Due to this flaw, the airbag is unlikely to deploy after an accident. Therefore, it is not advised that you use the vehicle until the system has been fixed.

Never disregard the important caution. There’s no need to gamble with the car, even though it doesn’t make it unsafe to drive.

The light does, however, show that the SRS parts are not functioning properly. This may potentially indicate that the airbags won’t activate in the event of a collision. You shouldn’t wait until you are involved in an accident to determine whether the airbags will keep you safe.

Can an airbag light be caused by a low battery?

The backup battery is dead. It is the most frequent cause of an airbag light that won’t go off. It might take place if your car’s battery is running low or has been depleted for any other cause. When the battery is fully recharged, the issue will be resolved.

How is a Nissan airbag code read?

To read the codes, count the flashes the light makes, then count them again after the pause. For instance, two flashes, a pause, and four flashes indicate a code 24 issue with your airbag system. Code 12 indicates low battery voltage, while Code 13 indicates a shorted or grounded airbag circuit.

Can a blown fuse turn on the airbag light?

The car could have blown a fuse, for example. There are other fuses that could be to blame, but fuse #13 is most likely the one. You probably need to change fuse #13 and perhaps other fuses if your airbag light is on and your rear windshield wiper is not working. The airbag light can undoubtedly turn on as a result of blown fuses.

The airbag light may also abruptly turn on in a number of other situations. A mechanic or auto parts store should be able to decipher the code that the airbag system emits when it is acting up, which will give them a hint as to what specific issue the airbag is experiencing. There are numerous potential issues with the airbag because it is a complicated system of sensors, wiring, and programming that must suddenly activate during an accident after lying dormant for years. Check the fuse box to see whether you have a blown fuse first, but if not, you’ll likely need to take it to the dealer or a qualified mechanic for service.

What does it cost to repair the airbag light?

Reset Airbag Light, at No. 1 Although it typically costs a few hundred dollars and takes several hours, depending on the type of automobile it might cost as much as $600.

Are Nissan airbags subject to a recall?

The reason for the Nissan airbag recall is that the airbag’s inflator may react dangerously and explosively to moisture, heat, and aging in the environment. These airbags are extremely harmful and should be replaced as soon as possible in any vehicle that has them. Drivers shouldn’t seek other autos and buy any car with Takata airbags.

Nissan airbag recalls are the outcome of ongoing airbag defect investigations and enforcement following multiple injuries and even fatalities. In relation to this specific recall, the National Highway Traffic Safety Administration is now looking into more than 30 million automobiles.

Our online Nissan Recall Lookup tool can be useful if you need to replace your airbags or are unsure if your car has Takata airbags. You can use it to find out if this recall affects your car.

Speak to the knowledgeable mechanics at our service center if you want to upgrade anything in your car, including your airbags. They will look after you and ensure that you are driving a safe vehicle because they are experienced with the necessary part replacements for your vehicle. They are informed on all varieties of auto maintenance, auto repair, and our Nissan service discounts.

Driving with the airbag light on is it forbidden?

In some vehicles, it is even possible to turn off the passenger airbags, which will make your dashboard’s airbag light come on.

You should only deactivate the passenger airbag when absolutely necessary because, as was previously said, airbags are an essential safety element.

If your airbag light ever illuminates for no apparent reason, you should try to resolve the situation.