- Turn on the ignition.
- The glove box should be opened. You should be able to see a red-lit button within.
- Just press and hold it for two seconds.
- And there you have itthe tire pressure monitoring system light should be turned off.
In This Article...
How can the tire pressure warning light on a 2010 Volkswagen Jetta be reset?
Set the ignition to the “ON/RUN” position (engine off). For at least two seconds, depress the SET button in the glove box. An loud chime will follow the TPMS Telltale turning off.
Why, after filling the tires, is my tire pressure light still on, Jetta?
Try the following if your TPMS light is still on after you have inflated your tires to the recommended pressure: 10 minutes at a speed of 50 mph would be plenty. When you start the car again, the TPMS light ought to be off because this ought to reset the tire sensors.
Where is the button to reset my TPMS?
Tire pressure monitoring system is referred to as TPMS. The TPMS reset button is often located below the steering wheel. Your car’s TPMS needs to be electronically reset after you replace the tires in order to erase the error message. Hold the TPMS reset button down until the tire pressure light blinks three times, then let go of the button to complete the process. Your car should be started, and the sensor will refresh after 20 minutes.
Why won’t my tire pressure warning light turn on?
When the TPMS warning light illuminates, proceed with caution. This indicates that at least one of your tires may be at least 25% under-inflated.
*The best way to get the most accurate reading is to check the tire pressure before you drive on it when the tire is “cold.” If your TPMS light is on, first check that you have correctly reset your TPMS by following these instructions.
Will my TPMS light automatically turn off if I fill my tires with air after it illuminates?
Several minutes after reinflating the tires to the recommended pressure, the TPMS light ought to go out.
What happens if I adjust the tire pressure but the light on my tire pressure gauge still doesn’t go out?
The only place that can fix a computer issue that causes the TPMS warning light to turn ON and flash ON for one second and OFF for three seconds is the dealership service center. When the TPMS warning light illuminates and remains on, one or more tires may have low tire pressure. The light ought to go out once the tire is inflated to the recommended tire pressure listed on the door placard. Always check the pressure in all of your tires because one or more of them may not be at the proper pressure.
A 2008 Volkswagen Jetta’s TPMS sensor needs to be reset.
Procedure for Resetting the TPMS on a Volkswagen Jetta (20052011)
- Set all tires’ air pressure to the value listed on the tire placard.
- Put the parking brake on and switch the ignition to “ON” (engine off)
- Hold down the SET (or ESP) button (next to the gear shift) until you hear an audio signal. Successful relearn is confirmed by an audio signal.
How do you turn a 2008 Volkswagen Jetta’s tire pressure light back on?
Click setup, then tires, from the automobile menu on the right. Just click the set button next to Tire Pressure Monitoring System.
How can I turn off the tire pressure warning light?
How to Clear the Tire Pressure Indicator
- Don’t start the car; just turn the key to “on.”
- While the car is off, disconnect the positive battery cable.
- All tires, including the spare, should be 3 PSI overinflated before being entirely deflated.
- Bring your car to our service department for qualified help.
My tires are in good condition, so why is my low tire pressure sign on?
Typically, a tire with an air pressure that is 10% to 15% low will turn on the warning light. The air pressure inside the tires also tends to drop in cold or icy conditions. Short trips in the car will warm up the tires and raise the pressure in them.
In what location is the TPMS sensor?
Normally, a tire sensor is positioned on the inner of the tire on each of your car’s wheels. The sensor is placed into the tire valve used by many cars. The pressure sensor may be positioned on the inside of the wheel on other cars.
Tire pressure monitoring devices have gradually been included as standard equipment since the 2005 model year of vehicles and were required by legislation beginning on September 1st, 2007.
Start your car, then glance at the dashboard to see whether a TPMS light briefly comes on to determine quickly whether your car has a TPMS installed.
Should the TPMS be reset after purchasing new tires?
After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.
How is a service tire monitor cleared?
It must be stressful to assume your tire pressure is low all the time! Fortunately, there are quick fixes for service tire monitor systems.
Resetting the system is the simplest technique to repair the service tire monitor system in your car. When the sensors occasionally need extra assistance, there are two ways to reset the system.
Driving for at least 10 minutes at highway speeds is the first step towards resetting the system. When you start the car again or after your current drive, the light ought to go off.
You should reset the TPMS light if the approach described above doesn’t work. You can accomplish this by:
- without starting the engine, turning the ignition to the on position.
- Locate the TPMS button, then press and hold it until the alert flashes or goes away.
- driving around for a while, stopping, and then starting the car again.
The service tire monitor system should be maintained by a qualified technician if neither of the aforementioned approaches succeeds.
Download Jerry to save money on your auto insurance if you’re searching for something to do while you wait for the technician to finish the repairs. The Jerry app, a registered broker that provides end-to-end support, gathers reasonable rates, assists you in switching plans, and, once you’ve made a decision, will even assist you in canceling your old policy.
Is driving permitted while the tire pressure light is on?
You should be able to find our store or an air pump if the light just came on and you need to get there. However, it is unsafe to keep driving while the light is on. This is why: When you drive your car with low tire pressure, you accelerate the premature and severe tire wear.
Will the tire pressure light automatically turn off?
Tire pressure can be impacted by overnight temperature variations or by cold winter days. The low-pressure indicator may then display as a result of this. The pressure in your tires can change by up to 10 PSI when there are significant temperature changes between day and night.
After about 20 minutes of driving, the light may turn off on its own when the right inflation level stabilizes and the air in your tires warms and expands.
In any case, you ought to have your air checked immediately. Your tires are at least 25% underinflated, according to the TPMS light. This poses a risk to your safety, especially if the load is close to your vehicle’s maximum load capacity. There is a higher possibility of tire failure, degraded handling, and increased tire wear and tear. Your fuel economy may also suffer.