- Turn on the ignition.
- The glove box should be opened. You should be able to see a red-lit button within.
- Just press and hold it for two seconds.
- And there you have itthe tire pressure monitoring system light should be turned off.
In This Article...
Where is the button to reset my TPMS?
Tire pressure monitoring system is referred to as TPMS. The TPMS reset button is often located below the steering wheel. Your car’s TPMS needs to be electronically reset after you replace the tires in order to erase the error message. Hold the TPMS reset button down until the tire pressure light blinks three times, then let go of the button to complete the process. Your car should be started, and the sensor will refresh after 20 minutes.
How can I activate the TPMS light?
Turn the key to the “on” position with the car off, but don’t let it run. When the Toyota tire pressure sensor blinks three times, hold down the TPMS reset button until it stops blinking. Start the car, then let it run for 20 minutes to let the sensor reset. Under the steering wheel is typically where you’ll find the TPMS reset button.
Why, Volkswagen, does my tire pressure light remain on even when I fill my tires?
Try the following if your TPMS light is still on after you have inflated your tires to the recommended pressure: 10 minutes at a speed of 50 mph would be plenty. When you start the car again, the TPMS light ought to be off because this ought to reset the tire sensors.
Why are my tires in good condition but my tire pressure sign is on?
It’s likely that one or more of your tires have low air pressure if you see the tire pressure indicator turn on. However, even if your tires are in good condition, there are a number of things that could cause the sensors to go off, so you shouldn’t rely only on the data from the tire pressure monitoring system of your car.
We’ve talked about some additional aspects of automobile maintenance in this piece. Read these articles if you have some time:
My tires are in good condition, so why is my low tire pressure sign on?
Typically, a tire with an air pressure that is 10% to 15% low will turn on the warning light. The air pressure inside the tires also tends to drop in cold or icy conditions. Short trips in the car will warm up the tires and raise the pressure in them.
On a 2009 Volkswagen Jetta, how do you reset the low tire pressure indicator?
Set the ignition to the “ON/RUN” position (engine off). For at least two seconds, depress the SET button in the glove box. An loud chime will follow the TPMS Telltale turning off.
In what location is the TPMS sensor?
Normally, a tire sensor is positioned on the inner of the tire on each of your car’s wheels. The sensor is placed into the tire valve used by many cars. The pressure sensor may be positioned on the inside of the wheel on other cars.
Tire pressure monitoring devices have gradually been included as standard equipment since the 2005 model year of vehicles and were required by legislation beginning on September 1st, 2007.
Start your car, then glance at the dashboard to see whether a TPMS light briefly comes on to determine quickly whether your car has a TPMS installed.
Should the TPMS be reset after purchasing new tires?
After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.
Is my car safe to drive with the TPMS light on?
No, it is not safe to drive with the TPMS Light on. It indicates that one of your tires is either under- or over-inflated. The recommended tire pressure for your vehicle can be found in the owner’s manual or on a sticker on the door, trunk, or fuel door. This may result in excessive tire wear, perhaps result in tire failure, and result in a blowout that is hazardous to you and other motorists on the road. As different manufacturers may have configured their TPMS lights to trigger in a different way, always consult your owner’s manual for detailed information on how to monitor your TPMS system.
What could activate the TPMS light?
Do you know what to do when the TPMS symbol for low tire pressure illuminates? The first step is to physically gauge your tire pressures and add air as necessary to bring them up to the manufacturer’s recommended levels. (The owner’s handbook or the driver’s door jamb will have the proper pressure; the sidewall of the tire will only have the tire’s maximum pressure.) Remember that your TPMS does not substitute for regular tire pressure checks. It is a gadget that can assist in notifying you when pressure is low, but a tire may deflate below the recommended level long before the TPMS warning light illuminates. When the tire pressure is either too low or too high, the TPMS light illuminates.
TPMS LIGHT ILLUMINATES WHILE DRIVING
At least one of your tires has low air pressure if your TPMS light illuminates and stays lit. Utilizing a gauge, check the pressure in each tire, identify the reason for pressure loss, and repair or add air to the tire(s) as necessary.
TPMS LIGHT GOES ON AND OFF
Variable temperatures may be causing your TPMS light to turn on and off when your tire pressure(s) is/are close to the level that generates an alert. The indicator may turn out when pressure increases during the day due to rising ambient temperature and/or heat produced by operating the vehicle; this often happens when pressure lowers at night due to a drop in ambient temperature. Check the pressure in each tire using a gauge and add air to any that need it.
TPMS LIGHT FLASHES AND THEN STAYS ON
Every time you start your car, if the light flashes for 60 to 90 seconds before staying on, it signifies the TPMS isn’t working properly. You should take your automobile to an auto repair shop for a checkup. The TPMS is malfunctioning and unable to alert you to low tire pressure until it is fixed. Using a gauge, check the tire pressure on all of them, and add air to the ones that require it.
How long is low pressure safe to drive on?
A 50-mile drive at a top speed of 50 mph is conceivable in the event of complete pressure loss and limited mobility (no unexpected driving maneuvers). The type of driving, speed, type of road, weather, tire condition, and vehicle load will all have an impact on the run flat distance.
How does the TPMS identify each tire?
The anti-lock brake system’s wheel speed sensors are often used by an indirect TPMS. On-board computer systems can employ these sensors to compare wheel revolution rates between individual wheels as well as to other vehicle operation data, such as speed.
The computer can determine the relative size of the tires on your car based on how quickly each wheel rotates. The computer determines that a tire is underinflated when a wheel starts spinning more quickly than normal and warns the driver accordingly.
Therefore, a device for monitoring tire pressure indirectly does not truly measure tire pressure. The same kind of measurement you may observe with a tire gauge is not being processed electronically. An indirect tire pressure monitor only counts the rotational speed of your tires and sends instructions to the computer to activate the indication light when something seems off with the rotation.