Toyota Highlanders come with a tire pressure warning system that flashes an alert on the instrument panel whenever one of the tires’ pressure levels drop. Only when pressure is severely low, as determined by the sensors, will the low-pressure sign appear. When new tires are installed, the system needs to be reset so that the sensors can re-calibrate. The system must be reset in order to rotate the tires.
In This Article...
How can the tire pressure light on a Toyota Highlander be turned off?
Resetting the Tire Pressure Light on a Toyota Turn the key to the “On position when the car is off, but don’t let it run. When the tire pressure light blinks three times, release pressure on the TPMS reset button. Start the car and let it run for 20 minutes to let the sensor reset.
How can the tire pressure light be turned off on a 2013 Toyota Highlander?
1) As stated on the tire and loading information label, set the tires to the prescribed (cold) pressures. 2) Switch the ignition on. 3) When the tire pressure warning light blinks three times, press and hold the tire pressure warning reset switch for at least three seconds.
Why, Toyota, does my tire pressure light remain on even after filling the tires?
Try the following if your TPMS light is still on after you have inflated your tires to the recommended pressure: 10 minutes at a speed of 50 mph would be plenty. When you start the car again, the TPMS light ought to be off because this ought to reset the tire sensors.
The TPMS reset button is where?
Tire pressure monitoring system is referred to as TPMS. The TPMS reset button is often located below the steering wheel. Your car’s TPMS needs to be electronically reset after you replace the tires in order to erase the error message. Hold the TPMS reset button down until the tire pressure light blinks three times, then let go of the button to complete the process. Your car should be started, and the sensor will refresh after 20 minutes.
Why are my tires in good condition but my tire pressure sign is on?
It’s likely that one or more of your tires have low air pressure if you see the tire pressure indicator turn on. However, even if your tires are in good condition, there are a number of things that could cause the sensors to go off, so you shouldn’t rely only on the data from the tire pressure monitoring system of your car.
We’ve talked about some additional aspects of automobile maintenance in this piece. Read these articles if you have some time:
How can I disable the low tire pressure indicator?
Don’t start the car; just turn the key to “on.” Till the tire pressure light blinks three times, press and hold the TPMS reset button. Press the button again to start the vehicle. Within twenty minutes, the light ought to turn off.
How can I turn off the tire pressure warning light?
Try one of the following approaches to reset it if it remains on:
- 10 minutes of driving at 50 mph or more.
- Turn the key to the “on” position with the car off, but don’t let it run.
- All tires should be inflated to 3 PSI more than what is suggested, then completely deflated.
How much time does a TPMS reset take?
Holding down the TPMS reset button should cause the light to blink three times. Start the car and let it run for 20 minutes to reset the sensor. Under the steering wheel is where you’ll find the reset button for the tire pressure monitor.
How long before the tire pressure light appears?
After a few kilometers of driving, the light may turn off if the tires are adequately inflated. After around 10 miles, if the light still remains on, it may be necessary to reset the TPMS as instructed in the owner’s handbook of the car.
Should the TPMS be reset after purchasing new tires?
After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.
In what location is the TPMS sensor?
In the US, direct TPMS usage is more prevalent. The sensors are either housed in the tire pressure valve, which also serves as an antenna, or they are band-clamped to the wheel rim. These gadgets deliver the data to an on-board computer.
My TPMS light won’t turn off; why?
When the TPMS warning light illuminates, proceed with caution. This indicates that at least one of your tires may be at least 25% under-inflated.
*The simplest way to get the most accurate reading is to check the tire pressure before you drive on it when the tire is “cool.” If your TPMS light is on, first check that you have correctly reset your TPMS by following these instructions.
Will my TPMS light automatically turn off if I fill my tires with air after it illuminates?
Several minutes after reinflating the tires to the prescribed pressure, the TPMS light ought to go out.
What happens if I adjust the tire pressure but the light on my tire pressure gauge still doesn’t go out?
The only place that can fix a computer issue that causes the TPMS warning light to turn ON and flash ON for one second and OFF for three seconds is the dealership service center. When the TPMS warning light illuminates and remains on, one or more tires may have low tire pressure. The light ought to go out once the tire is inflated to the recommended tire pressure listed on the door placard. Always check the pressure in all of your tires because one or more of them may not be at the proper pressure.
Is it safe to operate a vehicle with the tire pressure light on?
You should be able to find our store or an air pump if the light just came on and you need to get there. However, it is unsafe to keep driving while the light is on. This is why: When you drive your car with low tire pressure, you accelerate the premature and severe tire wear.