Make sure your 2010 Toyota Prius is parked safely before attempting to reset the tire pressure sensor. The following step is to check that the tire pressure is set correctly for each tire. For the Prius, the front tires should be inflated to 35 pressure, and the rear tires to 33 psi. The TPMs reset button must then be located. It is adjacent to the obd port, which is above the brake pedal and below the steering wheel. Till the low pressure light blinks three times, press and hold the tpms reset button. Turn the vehicle off and back on after letting the engine run for around 20 minutes.
Press and hold the tpms reset button underneath the steering wheel to reset the tire pressure sensor on a Toyota Prius. When the low pressure light blinks three times, let go of the button. 20 minutes of engine running will allow the computer to calibrate the sensor. Next, switch the ignition off.
The tpms reset button under the steering wheel must be pressed and held down. After the low pressure light has flashed three times, hold the button before letting go. Turn on the ignition and let it run for around 20 minutes.
In This Article...
How can I turn off the tire pressure warning light?
How to Clear the Tire Pressure Indicator
- Don’t start the car; just turn the key to “on.”
- While the car is off, disconnect the positive battery cable.
- All tires, including the spare, should be 3 PSI overinflated before being entirely deflated.
- Bring your car to our service department for qualified help.
When my tires are in good condition, why is my tire pressure light on Prius?
What Does a Flashing TPMS Light Indicate? The tire pressure sensors are powered by a battery, thus if the TPMS indicator is blinking, the battery might need to be changed. It might potentially point to a sensor-related issue.
How can the TPMS be disabled on a Prius?
Resetting the Tire Pressure Light on a Toyota Turn the key to the “On position when the car is off, but don’t let it run. When the tire pressure light blinks three times, release pressure on the TPMS reset button. Start the car and let it run for 20 minutes to let the sensor reset.
Why won’t my tire pressure warning light turn on?
When the TPMS warning light illuminates, proceed with caution. This indicates that at least one of your tires may be at least 25% under-inflated.
*The simplest way to get the most accurate reading is to check the tire pressure before you drive on it when the tire is “cool.” If your TPMS light is on, first check that you have correctly reset your TPMS by following these instructions.
Will my TPMS light automatically turn off if I fill my tires with air after it illuminates?
Several minutes after reinflating the tires to the prescribed pressure, the TPMS light ought to go out.
What happens if I adjust the tire pressure but the light on my tire pressure gauge still doesn’t go out?
The only place that can fix a computer issue that causes the TPMS warning light to turn ON and flash ON for one second and OFF for three seconds is the dealership service center. When the TPMS warning light illuminates and remains on, one or more tires may have low tire pressure. The light ought to go out once the tire is inflated to the recommended tire pressure listed on the door placard. Always check the pressure in all of your tires because one or more of them may not be at the proper pressure.
Why, after filling the tires, is the tire pressure light still on?
If you’ve inflated your tires, but the air pressure warning light continues to flash, your tire pressure monitoring system is malfunctioning or you have a gradual leak. A bright TPMS warning light indicates a problem with a tire pressure sensor, assuming there isn’t a leak in your tire. One of them might be damaged, the lithium-ion battery might be dead, or the TPMS itself might have an internal problem. You’ll need to get your Tire Pressure Monitoring System repaired in any of these scenarios.
Quick Tip: Recheck the tire to ensure it is inflated to the correct air pressure if the TPMS warning light illuminates again after you have inflated it. Low tire pressure indicates an air leak, which requires repair or tire replacement.
How long before the tire pressure light appears?
After a few kilometers of driving, the light may turn off if the tires are adequately inflated. After around 10 miles, if the light still remains on, it may be necessary to reset the TPMS as instructed in the owner’s handbook of the car.
Will the tire pressure light automatically turn off?
Even when the tires are in good shape, the low tire pressure light may occasionally remain on. In such circumstances, you should manually check the tire pressure to make sure there is no issue. People frequently witness this light in the coldest part of the day, the morning. However, the light occasionally turns off when the temperature rises. In any case, until the air warms up and expands, your tires may still be a few PSI under-inflated in cool weather.
A defective tire pressure sensor often exhibits three symptoms. When you discover that your tires are flat but the sensor didn’t alert you, it is the first scenario. The second sign that anything is wrong with the sensors is when your ECU turns on the TPMS light on your dashboard. When the sensor suggests that you have a flat tire when you are aware that you don’t, it is the third indication of an inaccurate alert.
After a few kilometers of driving with properly inflated tires, the sensor light typically turns off. However, you should reset the TPMS in accordance with the directions in the owner’s manual if it doesn’t turn off automatically after traveling for around 10 miles.
In 2008, the U.S. Department of Transportation mandated that tire pressure monitoring systems be installed in all automobiles (TPMS). As a result, even if you can reset it, the TPMS in your car cannot be turned off.
Technically, driving with the TPMS light on is possible, but it is not recommended. The sensor alert indicates either an under- or over-inflated tire. Ignoring this warning could result in excessive tire wear or possibly a blowout, all of which could be dangerous for you and other road users.
The TPMS reset button is where?
Tire pressure monitoring system is referred to as TPMS. The TPMS reset button is often located below the steering wheel. Your car’s TPMS needs to be electronically reset after you replace the tires in order to erase the error message. Hold the TPMS reset button down until the tire pressure light blinks three times, then let go of the button to complete the process. Your car should be started, and the sensor will refresh after 20 minutes.
Where is the reset button for the Toyota tire pressure monitoring system hidden?
Hold down the TPMS reset button until the tire pressure warning light flashes three times. Release the reset button after that. Start the car, then wait for the sensor to refresh for around 20 minutes. Under the steering wheel is normally where you’ll find the reset button for the tire pressure monitor.
Should the TPMS be reset after purchasing new tires?
After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.
Is driving permitted while the tire pressure light is on?
You should be able to find our store or an air pump if the light just came on and you need to get there. However, it is unsafe to keep driving while the light is on. This is why: When you drive your car with low tire pressure, you accelerate the premature and severe tire wear.
How can I tell which tire needs air?
Do not freak out if you forgot your pressure gauge at home. You can also use your hands to check the pressure in your tires.
Put your hand on the tire and push down. Low tire pressure will result in a soft, mushy tire. The tire is overinflated if it feels like rock and you cannot apply any pressure to it at all.
Keep your touch on the tire and pump air into it if it seems too low. To feel the tire pressure, keep pushing down. If the tire is initially overinflated, gradually let some air out while checking for softness along the way. You need to be able to gently press into the tire.
Does Toyota alert you to a low tire?
Tire Pressure Monitoring Systems are standard on all new Toyota vehicles (TPMS). Essentially, the system’s function is to inform drivers when a tire or tires are in need of being refilled, repaired, or replaced. Any queries customers may have about the TPMS in their Toyota car can be addressed by the service team here at Toyota Palo Alto. Come see how the Tire Pressure Monitoring System in Your Toyota Vehicle operates with our team today!
What Should You Do When the Tire Pressure Monitoring System Warning Light is Active?
In order to measure the tire pressure for each of the car’s four tires, the Tire Pressure Monitoring System in your Toyota vehicle essentially uses sensors. The TPMS Warning Light and a warning message will both illuminate on your Toyota instrument panel when one or more of your tires have too little air in them. Now, drivers should check the pressure in each of their four tires, and if required, fill them. If, after doing so, the warning light and message still appear, you should contact your neighborhood mechanic or a Toyota dealership to have the problem further investigated.
How Do You Reset the Tire Pressure Monitoring System?
Sometimes the alert will also appear after you rotate your tires, change your tire size, or adjust the tire pressure. In these situations, all you have to do is reset the TPMS to account for the modifications you made to your car’s tires. Simply press and hold the while the engine is running to reset the TPMS “Most Toyota models include a reset button on the instrument panel to the right of the steering wheel. Keep the “Press the reset button three times until the TPMS Warning Light blinks slowly. To finish the reset procedure, let the engine run for a few more minutes and then shut it off again.
Visit us at Toyota Palo Alto right away if this procedure doesn’t work if you think your Toyota vehicle’s TPMS is seriously malfunctioning. Visit us as well to learn more about the service deals we have to offer!