You must replace the oil and use synthetic SAE 0W-20 if your Toyota Tacoma’s maintenance light illuminates. Here’s how to reset the maintenance light if You’ve already done that and need to. Don’t start the engine while you turn the ignition on. Make that the miles, not the trip meters, are displayed on the odometer. If so, press the trip meter reset button after turning the car back off. Hold it down and restart Your Toyota (Again, not starting the engine). If you keep holding the trip meter reset button while doing this, you should see the odometer begin to show a sequence of dashes on the screen. These will change to zeros. Release the reset button once those vanish and the regular odometer numbers appear on your screen. The maintenance button should have vanished by this time, and you shouldn’t see it again until you’ve covered another 5,000 miles.
The rest oil light shows that it’s time for an oil change. Turn the ignition to the on position without starting the engine to reset the light. Turn off the ignition, push and hold the trip odometer reset button, and then press the odometer to trip.
Your oil change reset is located on the multi-display screen in your dash. The factory recommends that Tacomas manufactured in 2016 and after have their oil changed every 5,000 miles. Your maintenance handbook and online resources contain every detail.
In This Article...
How can the maintenance needed light on a 2015 Toyota Tacoma be reset?
How Can the Maintenance Required Light Be Reset?
- Turn on your car. Look at your dashboard when your key is in the on position.
- Press the Trip Meter Reset Button after turning off the engine.
- Re-start the vehicle.
- Keep pressing the reset button.
- Reset button released
How do you turn off the maintenance light on a third-generation Toyota Tacoma?
Press and hold the trip meter reset nob (located next to your Toyota Tacoma’s odometer) to reset the light. Turn the ignition to “ON” while holding the trip meter reset knob, but do not start your Toyota Tacoma. Keep pressing the meter reset button until the MAINT REQD light goes off.
How can the oil life be checked on a 2017 Toyota Tacoma?
Oil Level Check 20162021 Toyota Tacoma SR Extended Cab Pickup 2.7L 4 Cyl.
- Remove Dipstick – Find the oil dipstick, take it out, and clean it.
- Reinstall the dipstick, take it out, and then check the oil level.
- More Information – More details regarding the oil level.
When should the oil be changed in a 2017 Toyota Tacoma?
For traditional oil, Toyota suggests changing your 2017 Toyota Tacoma’s oil and filter every 3,000 to 5,000 miles. One of the most important and expensive maintenance for your car is an oil change. Generally speaking, synthetic oil needs to be changed every 7,500 to 10,000 miles.
How can I turn off the Toyota maintenance is required light?
It only takes a few minutes to get the hang of turning off the maintenance light on a Toyota Camry, but you’ll need to act quickly! To be ready for each stepthe timing might be trickywe advise reading the instructions several times before you begin.
- Switch to position one after inserting your key into the ignition. The first set before starting the engine is this.
- Turn the key to position two while pressing and holding the odometer button on the dashboard.
- When the maintenance light begins to flash, keep holding the odometer button. There may even be beeping sounds. The light ought to dim.
- Pull back on the odometer button, then turn the key.
- When you turn on your automobile, if the light is off, the procedure is finished.
- If the light is still on, try it again.
How can I dim the maintenance is necessary light?
How do I turn the “Maint Reqd” light back on?
- Switch the ignition to the ON position.
- Set the trip display to TRIP A mode on the odometer.
- Activate the OFF position on the ignition switch.
- Turn the ignition switch to the ON position while pressing and holding the Trip Meter RESET button.
- It will do so via the service maintenance reminder light.
How often should I have my 2018 Toyota Tacoma’s oil changed?
How often should an oil change be performed on a 2018 Toyota Tacoma? One of the most crucial and important services for your car is an oil change. For traditional oil, Toyota advises having your 2018 Toyota Tacoma’s oil and filter replaced every 3,000 to 5,000 miles. Typically, synthetic oil needs to be changed every 7,500 to 10,000 miles.