Instructions for Toyota Camry to reset maintenance light
- Switch to position one after inserting your key into the ignition.
- Turn the key to position two while pressing and holding the odometer button on the dashboard.
- When the maintenance light begins to flash, keep holding the odometer button.
- Pull back on the odometer button, then turn the key.
In This Article...
How can you turn a Toyota’s oil change light back on?
In order to start the car, turn the ignition to position one after inserting your key. Turn your key to position two after pressing and holding the trip meter reset button on the dashboard. Hold the odometer button down for a further ten seconds. The light should then begin to flash and potentially beep before turning off.
How can the maintenance needed light on a 2016 Toyota Camry be reset?
Push the odometer button on the dashboard quickly and hold it there while turning the key to the second position. You should see the maintenance light blink if you hold down the odometer button for roughly 10 seconds. Also possible is a beeping sound. The light should then turn off at that point.
How do I stop the needed maintenance?
How do I turn the “Maint Reqd” light back on?
- Switch the ignition to the ON position.
- Set the trip display to TRIP A mode on the odometer.
- Activate the OFF position on the ignition switch.
- Turn the ignition switch to the ON position while pressing and holding the Trip Meter RESET button.
- It will do so via the service maintenance reminder light.