2. Turn the ignition off after increasing the odometer reading using the trip meter reset knob.
3. Keep the knob depressed while you turn the ignition key to the run position (one position before starting engine).
4. When the light turns off, keep turning the knob. It shines for three seconds, flashes for two seconds, and then turns off after one second. The LED will continue to flash if the system is unable to reset. In this situation, start over at step 1 and try again.
5. To make sure the indication has been reset, turn off the ignition and then turn on the engine.
In This Article...
How can I dim the maintenance is necessary light?
How do I turn the “Maint Reqd” light back on?
- Switch the ignition to the ON position.
- Set the trip display to TRIP A mode on the odometer.
- Activate the OFF position on the ignition switch.
- Turn the ignition switch to the ON position while pressing and holding the Trip Meter RESET button.
- It will do so via the service maintenance reminder light.
How is the mileage reset after an oil change?
Get behind the wheel of a pre-2005 GM vehicle, shut the door, turn the ignition to the auxiliary power position, wait for the lights to come on, then quickly depress the accelerator three times within five seconds after turning the key. When the counter has been reset, the oil light should flash.
Use this process on a GM model from 2006 or later, however keep in mind that some cars have slightly different button locations to hit to reset.
Turn the key to the auxiliary power position while sitting behind the wheel and with all the doors closed. After finding the oil life message by scrolling through the options on the Driver Information Center (DIC), press and hold the enter key for one second before letting go. There will be a reset notice on the DIC.
The amount of oil a V8 4runner consumes
According to the owner’s manual, the 4.7 V8 needs 6.2 liters (or 6.5 quarts) of oil. Personally, I always use 6 liters and consider it adequate. Overfilling it is preferable to having it register slightly lower on the dipstick. Buy that extra liter if it makes you feel better to add the exact amount that Toyota advises.
For each generation of 4runner, the oil type and interval are listed in a table in this post if you possess a different model.
Why does my maintenance light come on after I change the oil?
- If the car is on, turn it off.
- Now the light will read “MAINT REQD.”
- Turn the key in the ignition while maintaining pressure on the ODO button. till the dash lights turn on. Avoid starting the car.
- Release the ODO button once it starts to show zeros, then flip the key back to the “off” position.
- The ODO display will briefly flash before beginning to display only zeros.
- Press and hold the ODO reset / readout button while the engine is off.
- Verify that the odometer’s (ODO) total mileage displaytypically the ‘A’ displayis on.
What ‘MAINT REQD’ Means
Within 5000 miles of the last reset, the “MAINT REQD” indicator illuminates. It is merely a mileage counter meant to serve as a reminder to the user that an oil change is required and in no way indicates any system failure. If a specialist has always performed maintenance on your Toyota, they reset it after each oil change. It should be noted that the recommended oil change interval is not always 5000 miles. To find out how frequently the oil in your Camry needs to be changed, consult the owner’s manual and your usual technician.
Need Help?
Our service team would be delighted to assist you. Our entire staff of experts is Toyota-certified and adept in resolving even the most challenging problems with your Toyota. Make an appointment right away!
How can I clear the maintenance message on my Toyota?
A Toyota Maintenance Light Reset
- In order to start the car, turn the ignition to position one after inserting your key.
- Turn your key to position two after pressing and holding the trip meter reset button on the dashboard.
- Hold the odometer button down for a further ten seconds.
When your maintenance light illuminates, what should you do?
Simply put, the flashing maintenance required light is alerting you that maintenance on your car is necessary. The indicator will come on when a predetermined period of time has passed since your car’s last service or based on how far you’ve driven it.
This light typically indicates that you should change the oil in your car. The maintenance data will be reset for you when your car has been taken in for service.
To manually reset the system to turn off the light, however, follow these instructions:
When the maintenance light comes on, you can continue to drive, but bear in mind that you are doing so at your own risk if the required or scheduled repair is skipped.
What does it imply if your Toyota has a maintenance required light on?
On your dashboard, the Toyota maintenance light may read “MAINT REQD. It’s a light that is always on and alerts you when you require an oil change at a licensed auto shop. Your Toyota will run more smoothly and efficiently if you change the oil in your car.
How long is a maintenance light good for?
The oil light suddenly came on. You’re clueless as to why. And to make matters worse, you don’t really have a lot of time right now to worry about it.
How long can you drive with this object is in your face, you ponder. wonderful question We’ll respond to it and explain why it could have initially surfaced. Move along!
How Long Can You Drive With Oil Light On?
If the oil light comes on, you should try to get a repair to look at your car as soon as possible. However, keep in mind that a little more driving around won’t harm anything.
Typically, it takes about two weeks or 500 miles of driving before a flashing oil light becomes a serious issue. However, once that happens, things can quickly deteriorate and cause significant mechanical damage. Therefore, attempt to get your car serviced as soon as possible.
There’s Not Enough Oil in the Car
Numerous issues, including blown head gaskets and broken valves, can cause engines to leak oil. Whatever the case, if oil leaks from your car, it will begin to suffer and may eventually sustain catastrophic damage. As a result, the oil light will turn on when there isn’t enough oil in the vehicle.
The Vehicle’s Oil Pressure Is Low
A vehicle needs enough oil pressure to operate at peak performance. However, keep in mind that a number of things (such as an obstructed oil filter, a broken pressure gauge, insufficient engine oil, etc.) could cause the oil pressure to go too low. This will cause the oil light to come on.
The Oil Pressure Sensor is Malfunctioning
The malfunction of your oil pressure sensor may also cause your oil light to come on. Randomly, this happens, usually as a result of normal wear and tear. If the problem is not corrected, your car won’t have enough oil pressure, which will eventually cause more harm.
The Oil Pump Is Bad
A car’s oil pump may eventually fail as a result of wear and tear on the vehicle. The oil light will unquestionably respond to this. The only option at that point would be to replace the pump since if you don’t, your engine would experience increased friction and end its life much earlier than it should.
Is Your Oil Light Still On?
We have a group of expert vehicle repair specialists who will locate the cause of your check engine light before taking steps to fix it.
How can I turn off the Toyota Tacoma’s maintenance is required light?
The convenience of having a car-savvy family member must be incredible! Yes, you can manually reset your light as you are aware that your car is in good condition.
Turn off your vehicle, then push and hold the odometer reset button to turn off the maintenance light on a Toyota Tacoma. Odo/Trip is the typical label for this button. Hold the button down as you restart the ignition of your car.
Your maintenance light ought to be back on now! By starting your car as usual and waiting a few seconds, you can ensure that the light remains off. Visit a professional to ensure that your automobile and your sensors are in good working order if the light does indeed come back on.
Although automobile repairs might be expensive, Jerry can help you save money on other auto-related costs. Jerry is a free insurance comparison software that checks around for the best deals with more than 50 different insurance providers. You may make adjustments at any time, receive prices instantly, and text an agent with any queries you may have. Every year, the typical Jerry user saves $879.
The amount of oil that a 2007 Toyota 4runner needs.
6.5 quarts of 5W-30 motor oil should be added to the engine. To assist avoid spillage, steady the funnel with one hand. If you believe your operating circumstances require a different oil viscosity, see your owner’s manual.
What distinguishes a maintenance requirement from a check engine light?
Many people are unsure of what each of these lights means, and the check engine light and the service engine soon light are frequently confused for one another. We’ll describe how distinct they actually are despite the fact that they appear to be similar.
Authored by: Bradley Hayes, Director of Marketing at Autoscope European Car Repair and Automotive Blogger
Since Karl Benz originally unveiled his Benz Patent Motorwagen, automotive technology has advanced significantly. In fact, the notion that computers are essentially controlling our cars in today’s computer-driven society shouldn’t be shocking. In order to assure the precise right operation of your vehicle’s numerous systems and components, they regulate and track their performance. They even notify the driver when the automobile needs repair or maintenance. While technology hasn’t yet given our cars voices (like Kitt from Knight Rider), it has made it possible for them to communicate in other ways, such as through a series of backlit symbols that show up in your instrument cluster, such as a “check engine” and a “service engine” light.