A 2012 Toyota Camry Hybrid’s maintenance light can be reset more easily than most cars. The first step is to turn the key in the ignition and supply electricity; do not, however, start the engine. Hold down the odometer reset button while turning off the car’s power. The light should now be turned off by just giving the car electricity once again while keeping the button depressed. If the first time you tried these instructions, you should give it another go. If that still doesn’t work, you can try removing the battery from the car for 20 minutes, which will restore everything to its factory settings.
Holding down the odometer reset button while turning the car from the on position to the off position and back to the on position will reset the maintenance light on a 2012 Toyota Camry hybrid.
In This Article...
How can you turn a Toyota Camry hybrid’s maintenance light back on?
It only takes a few minutes to get the hang of turning off the maintenance light on a Toyota Camry, but you’ll need to act quickly! To be ready for each stepthe timing might be trickywe advise reading the instructions several times before you begin.
- Switch to position one after inserting your key into the ignition. The first set before starting the engine is this.
- Turn the key to position two while pressing and holding the odometer button on the dashboard.
- When the maintenance light begins to flash, keep holding the odometer button. There may even be beeping sounds. The light ought to dim.
- Pull back on the odometer button, then turn the key.
- When you turn on your automobile, if the light is off, the procedure is finished.
- If the light is still on, try it again.
Why does my maintenance light come on after I change the oil?
- Press and hold the ODO reset / readout button while the engine is off.
- If the car is on, turn it off.
- Release the ODO button once it starts to show zeros, then flip the key back to the “off” position.
- Now the light will read “MAINT REQD.”
- Verify that the odometer’s (ODO) total mileage displaytypically the ‘A’ displayis on.
- The ODO display will briefly flash before beginning to display only zeros.
- Turn the key in the ignition while maintaining pressure on the ODO button. till the dash lights turn on. Avoid starting the car.
What ‘MAINT REQD’ Means
Within 5000 miles of the last reset, the “MAINT REQD” indicator illuminates. It is merely a mileage counter meant to serve as a reminder to the user that an oil change is required and in no way indicates any system failure. If a specialist has always performed maintenance on your Toyota, they reset it after each oil change. It should be noted that the recommended oil change interval is not always 5000 miles. To find out how frequently the oil in your Camry needs to be changed, consult the owner’s manual and your usual technician.
Need Help?
Our service team would be delighted to assist you. Our entire staff of experts is Toyota-certified and adept in resolving even the most challenging problems with your Toyota. Make an appointment right away!
When your maintenance light illuminates, what should you do?
Simply put, the flashing maintenance required light is alerting you that maintenance on your car is necessary. The indicator will come on when a predetermined period of time has passed since your car’s last service or based on how far you’ve driven it.
This light typically indicates that you should change the oil in your car. The maintenance data will be reset for you when your car has been taken in for service.
To manually reset the system to turn off the light, however, follow these instructions:
When the maintenance light comes on, you can continue to drive, but bear in mind that you are doing so at your own risk if the required or scheduled repair is skipped.
How can I clear the maintenance message on my Toyota?
A Toyota Maintenance Light Reset
- In order to start the car, turn the ignition to position one after inserting your key.
- Turn your key to position two after pressing and holding the trip meter reset button on the dashboard.
- Hold the odometer button down for a further ten seconds.
How can I turn my car’s service light back on?
First, turn on the engine. Step 2: The display will say “Service required” if a service is overdue. Locate and press the OK button at the top right of the steering wheel for longer than one second to clear this message. The service interval will be reset to its default value in Step 3.
Why does my car indicate that maintenance is due soon?
Every 4,500 miles, once the maintenance has been reset, the light turns on for around 3 seconds before flashing for approximately 15 seconds. The majority of the time, this merely indicates that your car may need an oil change. After the maintenance data has been reset, the light will turn on and stay on if more than 5,000 miles have been driven.
How to Reset Maintenance Data on Toyota Corolla
You can easily reset your maintenance data. After the necessary maintenance has been carried out in accordance with the maintenance schedule, proceed as follows:
1. Switch the “engine start/stop switch or trip meter-activated engine shutoff a reading appeared,
2. Turn the trip meter reset switch while pressing the “engine switch ON, engine START STOP switch, etc.
3. Hold the button down while continuing to push it until the trip meter reads 000000.
When you understand what each warning light on your Toyota indicates, maintaining it is easy. Never be afraid to call the service staff at Toyota Palo Alto if you ever wonder whether your car needs any type of maintenance. You can ask our helpful staff for assistance in determining what’s wrong with your car and whether you need to schedule a service appointment.
What does “maintenance necessary” on my car mean?
The mileage is the only factor that activates the maintenance required light, also known as the service required light. When this light turns on, different automakers have different standards. For instance, the maintenance needed light on a car might turn on once every 10,000 lights and stay lit until it is manually turned off.
The oil change, spark plug replacement, new tire, etc. are just a few examples of the routine maintenance that should be performed on a vehicle.
When servicing your vehicle, mechanics typically reset the maintenance required light. The process for resetting the maintenance required light varies depending on the make and model of the vehicle, though, if they don’t, you can do it yourself.
What does it imply when your automobile indicates maint reqd?
The significance of the emblem MAINT REQD is significant. The MAINT REQD light indicates when the vehicle’s scheduled maintenance is due when it illuminates. If your car is under two years old, this service can be covered by your ToyotaCare plan.
Why does my Toyota’s maintenance indicator constantly flashing?
Toyota’s maintenance reminder system only serves to remind the motorist to have their car’s oil changed. The engine light will turn on after 5,000 miles of driving since the computer counts the engine’s mileage from the time it was reset. The system does not account for the changes between mild and extreme driving situations, load weight, towing, or weather conditions, all of which are significant factors that affect oil life because it is not algorithm driven, unlike other more sophisticated maintenance reminder systems.
Because of this, people who regularly tow or drive in adverse weather conditions and require more frequent oil changes may find the maintenance light ineffective. However, for individuals who frequently use the motorway in good weather, it might not be practical. This is not to suggest that a driver should completely ignore the maintenance light. Keep an eye on your driving circumstances throughout the year and, if necessary, have a professional assess your unique, most frequent driving conditions to determine whether or not your car need servicing.
The table below can help you estimate how frequently you would need to change the oil in a current car (earlier cars typically require more regular oil changes):