In your own garage, you can manually reset the airbag or SRS light on a Toyota. It indicates an issue with the Supplemental Restrain System when it illuminates (SRS). You need to get it fixed right away if you don’t want your airbag to inflate while you’re on the road. You should reset and turn off the airbag light when it has been corrected. No specialized equipment is required for this.
In This Article...
How can you turn a Toyota’s airbag light back on?
When you experience the same problem, you should start by following this technique, which is identical to resetting the airbag light on a Toyota Camry. It needs timing the airbag light and has four straightforward stages that are simple to complete.
First, activate the ignition. Wait for the airbag light to turn on next; it typically illuminates for seven seconds before turning off automatically. After waiting three seconds, immediately flip the ignition switch off. Before starting the engine, go through the basic procedures a couple of times. Your car’s airbag light should illuminate for seven seconds before turning off permanently if everything is done correctly.
How can the airbag light be turned off?
You can avoid a trip to the dealer or mechanic by resetting the airbag light on your car in the garage at your house. The SRS light (supplemental restraint system), commonly known as the airbag light, illuminates on the instrument panel of the car typically only after an accident and after the airbag has been deployed. However, there are other situations that could set off the SRS light, like when a new radio is installed or when there is a problem with the airbag system itself. You can reset the airbag light yourself using a handheld computer tool that you can get from an auto parts store once all repairs have been made.
Pay attention for the airbag light to activate. It will remain lit for seven seconds before turning off on its own. Turn the switch off right away and wait three seconds after it shuts off.
Start the car. The SRS light should illuminate for seven seconds before going out completely. Resetting the airbag light was done.
- Martin; 2008, “How To Use Automotive Diagnostic Scanners (Motorbooks Workshop)”
- David; 2003. “OBD II Fault Codes Reference Guide”
- clock or watch with a second hand
- You run the danger of the airbag inflating unintentionally if you keep driving while the SRS light is on.
Can the airbag light be reset without a tool?
Without a scanner, most automobile models make it difficult to reset the airbag light. This is a safety warning since, when the airbag light appeared, you should always fix the problem. Fortunately, if you fix the issue, the airbag light will typically also turn off by itself in many automobile models.
However, in some older vehicles, the airbag light can be reset without a scanner by disconnecting the battery wires.
Make that there are no loose wires or rust in the connector plugs in the wiring system under the driver’s or passenger’s seat. Restart your car after spraying an electronic cleaner on the connecting plugs.
If you can’t detect any issues there, you should really invest in an OBD2 scanner or have a shop interpret the codes because otherwise you’ll have to guess what the issue is.
Headlight indicator (U.S.A.)
Lets you know that the side marker lights, parking lights, taillights, instrument panel lights, license plate lights and headlights have all been turned on.
Low fuel level warning light
notifies you when the fuel is running low. For more detailed information on how much petrol is left in your Toyota, consult the owner’s manual.
Maintenance required reminder
At our Toyota dealership in Morrow, many of the new Toyota models we have available for sale are equipped with a maintenance-required reminder light to make sure you perform the needed maintenance.
Security indicator
When the ENGINE START STOP switch is turned off in a car equipped with a smart key system, the light flashes to indicate that the system is working. The light will flash on Toyota vehicles without a Smart Key System once the key is taken out of the ignition.
Slip indicator
The slip indicator will light up when your car starts to lose traction and slide. You will be informed that the VSC/TRAC systems are operational via this.
SRS airbag on-off indicator
You can tell if the passenger air bag is on or off by looking at the AIRBAG ON and AIRBAG OFF light, which lights. To properly activate or deactivate the airbag, this device senses the conditions of the front passenger seat.
TRAC OFF Indicator & VSC Off Indicator
informs you whether TRAC and/or VSC have been turned off. TRAC and BSC can reduce engine output to the wheels if your Toyota becomes stuck in fresh snow or mud. When the system is turned off, you might be able to liberate the car by rocking it back and forth. For information on how to disable this function in your individual model, contact our Toyota service team.
What does it imply if the airbag light is on indefinitely?
A problem with the seatbelts or airbags is indicated by the airbag light. Therefore, it’s usually not a good idea to drive when the airbag light is on. We advise having it towed to the dealership rather than driving it yourself if it continues to flash inside your car.
When the airbag light is on, can you drive?
The airbag light may have illuminated for any number of reasons, just like other warning lights. Here are a few of the most frequent causes:
The airbag needs resetting
The airbag light will turn on if there has been a collision but it wasn’t serious enough for the airbags to deploy. At your neighborhood garage, the airbag needs to be reset.
Corroded sensors
The sensors in your automobile may have deteriorated if it has water damage. This would lead to a malfunction in the system and turn on the airbag light.
Dislodged wiring
If your car has side airbags, the passenger side airbag may occasionally malfunction. When the passenger seat is shifted back and forth, the wires for that airbag may become damaged or displaced. We caution against attempting to reconnect a detached plug because you risk setting off the airbag. Make an appointment for your car at a nearby garage and ask them to check it.
Faulty seat belt
Your seat belt sensor can be the cause of the problem. The sensor that determines whether or not you have buckled up can malfunction occasionally. When this occurs, the airbag light can start to illuminate.
Your airbag clock spring may need replacing
The spring is intended to preserve continuity between the wiring and the driver’s airbag and coils throughout your steering wheel. The spring may wear out and fail over time, turning on the airbag warning light. Older autos are more likely to have this flaw.
The important line is that you must stop driving as soon as your airbag light illuminates and have your automobile inspected by a repair as soon as possible. Your airbags won’t activate until the issue is identified and remedied. Never disregard your airbag light since your safety and the safety of your passengers are top priorities.
Can a blown fuse turn on the airbag light?
The car could have blown a fuse, for example. There are other fuses that could be to blame, but fuse #13 is most likely the one. You probably need to change fuse #13 and perhaps other fuses if your airbag light is on and your rear windshield wiper is not working. The airbag light can undoubtedly turn on as a result of blown fuses.
The airbag light may also abruptly turn on in a number of other situations. A mechanic or auto parts store should be able to decipher the code that the airbag system emits when it is acting up, which will give them a hint as to what specific issue the airbag is experiencing. There are numerous potential issues with the airbag because it is a complicated system of sensors, wiring, and programming that must suddenly activate during an accident after lying dormant for years. Check the fuse box to see whether you have a blown fuse first, but if not, you’ll likely need to take it to the dealer or a qualified mechanic for service.
What is the cost of turning the airbag light back on?
Reset Airbag Light, at No. 1 This procedure typically takes several hours and costs a few hundred dollars, though depending on the car, it might cost as much as $600.
How are Toyota airbags turned off?
Congratulations on your new Toyota Tacoma! Although airbags are intended to save lives, those whose heights are significantly different from the average may experience more negative effects than positive ones.
Simply follow these easy steps to disable the passenger side airbag in your Toyota Tacoma.
- Open the door on the passenger side.
- Pull out your key fob’s manual key.
- The airbag setting slot is on the side of the dash; insert the key there.
- To activate the airbag, turn the key to the right; to deactivate it, turn the key to the left.
Your passenger-side airbag is instantly turned off! Once you’ve done this, make sure you declare any modifications you’ve made to your Tacoma so that your auto insurance policy will legally cover them. The Jerry app can be useful if you discover that these alterations are not covered or they result in a sharp increase in your premium.