A Toyota Prius’ maintenance light can be reset easily and quickly in a matter of minutes. Start by parking the car and closing all of the doors. Don’t start the engine while turning the ignition key to the ON position. If your ignition is a push button, you must press the start/stop button twice without applying the brake. To access the settings menu, use the arrow navigation buttons in the left cluster of steering wheel controls. Select OK once you’ve navigated to the menu for the car settings. Select MAINTENANCE SYSTEM, then hit OK. Look for OIL MAINTENANCE on that menu, then hit OK once again. When a confirmation notice appears, choose YES, and then click OK. To confirm that the reset has been retained, turn off the ignition and then start the car.
Toyota Priuses’ “maintenance required” light can be reset by pressing the power button twice, the odometer button, which is located below the multifunction display, once to turn the vehicle off, the odometer button, while holding it down, and the power button twice (2 times), all while keeping your foot off the brake. Hold the odometer button down while you wait for the flashing dashes to stop and the reading to return.
For a 2014 Prius, turn the trip odometer to “trip A,” start the vehicle, push and hold the MPH/KMH button, turn the ignition off while holding the button, turn the ignition back on while holding the button, and watch the reset take place.
Thank you for your clear instructions; I was able to accomplish what the Toyota Service Department failed to do.
In This Article...
How can I erase the maintenance reminder on my Toyota?
In order to start the car, turn the ignition to position one after inserting your key. Turn your key to position two after pressing and holding the trip meter reset button on the dashboard. Hold the odometer button down for a further ten seconds. The light should then begin to flash and potentially beep before turning off.
What should I do to remove the maintenance is required light?
How do I turn the “Maint Reqd” light back on?
- Switch the ignition to the ON position.
- Set the trip display to TRIP A mode on the odometer.
- Activate the OFF position on the ignition switch.
- Turn the ignition switch to the ON position while pressing and holding the Trip Meter RESET button.
- It will do so via the service maintenance reminder light.
How can I turn off the Toyota maintenance is required light?
Turn the key to position two while pressing and holding the odometer button on the dashboard. When the maintenance light begins to flash, keep holding the odometer button. There may even be beeping sounds. The light ought to dim.
On a 2010 Prius, how do you reset the oil maintenance light?
If you often perform maintenance on your 2010 Toyota Prius, the tiny maintenance required light might become very aggravating. It will only take a few minutes to correct, though, and is extremely simple. Follow these steps to reset the oil maintenance light on a 2010 Toyota Prius:
- As you double-tap the start button, keep your foot off the brake.
- The primary display should turn on in the center of the dashboard.
- To get to Trip A, push the Trip button on the steering wheel.
- Press the push-button start once to turn the car off.
- While pushing the push-button start twice, press and hold the mph button that is immediately above it.
- Resetting oil maintenance data should be visible on the display.
It’s best to get regular oil changes to keep your Prius in good condition. You may also reset the maintenance light in a matter of minutes. But did you know that by downloading the Jerry app and comparing prices, you can also save hundreds on auto insurance in only a few minutes?
Jerry is a certified insurance broker who offers estimates from numerous reputable and highly rated auto insurance providers. Jerry can assist you in purchasing insurance and terminating your current policy after you discover a fantastic cost for your Toyota Prius. Customers often save close to $900 annually!
Why does my maintenance light come on after I change the oil?
Second, restarting the counter after changing the oil involves resetting the maintenance required light. As a consequence, you may travel securely on roads and you won’t need to manually count the miles since after 5,000 miles, this light will alert you that it’s time for a fresh oil change.