You need a flat-head screwdriver to open a Toyota Highlander key fob.
Your key fob may feature a little switch at the bottom or back to release the internal key if you drive a more recent Highlander. All you need is a flathead screwdriver if you have an older Highlander.
Now, slide the flat-head screwdriver’s tip into the minuscule gap that exists between the two plastic pieces. To reach the battery compartment and open the fob, gently twist it. Now that the battery has been changed, your key fob issue should be resolved.
Now can be an excellent moment to correct your car insurance status in addition to your key fob. Many drivers are overpaying for insurance they don’t require. With the Jerry app, you can check your coverage in 45 seconds, gain access to discounts, and switch to a less expensive carrier.
In This Article...
Without a key, how do you unlock a Toyota Highlander?
I’m sorry to hear that the key gave you trouble. Your Toyota Highlander key fob most likely has a dead battery. But don’t worry! I’m glad to assist you.
Just follow these steps to start a Toyota Highlander without a key:
- On the side of the key fob, look for a push button.
- The physical key will come out when you press the button firmly.
- You can enter the car by physically opening the doors with the physical key.
- At this point, you might have noticed that the car lacks an ignition key slot.
- However, the car will start without any problems if you take the key fob and put it right on the push-button start as you press it in.
When you can, visit a store and purchase a CR2032 battery, which is what practically every key fob, including those for Toyotas, uses.
Did you know that you can save about $900 annually on auto insurance by installing the Jerry app for free in the time it takes to get back into your car?
Jerry assists you in comparing rates from more than 50 leading suppliers in minutes as a licensed broker. Jerry can assist you with purchasing new coverage and even canceling your existing policy when you discover a lower rate for your Toyota Highlander.
The battery in my Toyota key fob has to be changed.
How to Replace the Battery in a Toyota Key Fob.
- Take the key out of the fob. Over the key portion of your key fob is a tiny metal button.
- Unlock the fob.
- Dispense with the green circuit board.
- Switch out the battery.
- Place the key inside the fob after putting the fob back together.
What kind of battery does a key fob for a 2015 Toyota Highlander take?
How to change the battery in the Toyota Highlander “Tombstone key fob” (2014, 2015, 2016, 2017, 2018, 2019) For a step-by-step demonstration on how to replace the battery in your key fob, see the video below. What you’ll require is: a single CR2032 battery.
How can I program the key fob for my 2017 Toyota Highlander?
How to Set Up a Toyota Car Remote
- Within five seconds, turn your ignition key from “off” to “on” again.
- Close and reopen the driver door twice in the following 40 seconds. Then, put the key in and take it out of the ignition once again.
- Once more, make sure you finish steps 1 and 2 within 40 seconds.
How long does the battery in a Toyota key fob last?
When your Toyota key fob’s battery is running lowthe typical battery life is one to two yearsan alert will sound when the engine is turned off.