To clean the weld nuts of all debris and corrosion, use the battery terminal. On either side of the car, there are three. The underbody panel that came with your Toyota Sienna will need to be removed and trimmed in order to complete the installation. For more details, consult the hitch’s instructions that came with it.
In This Article...
Lower the exhaust
To remove the isolator rod from the rubber exhaust hanger, use the exhaust removal wrench. The rod might need to be loosened with soapy water. On the passenger side, above the exhaust muffler, is where you’ll find the rubber hanger.
Position the hitch
To position the lift, hoist it with the aid of additional hands. Align the six attachment holes before sliding the right hitch bracket over the exhaust pipe. The conical washers and six M12 bolts should be installed with the teeth facing the hitch. Before using the 19mm socket with the 5-inch extension to fasten the bolts, tighten them by hand first.
Torque the hitch
To torque each M12 bolt to 75 ft-lb, use a torque wrench with a 19mm socket and a 5-inch extension. Once the proper amount of torque has been applied, you should hear a clicking sound.
Raise the exhaust
When assembled, the hitch should be fitted at:
- The receiver’s height from the ground is 11 3/4 inches.
- From the pinhole to the end of the bumper, it is 4 1/2 in.
Your Toyota Sienna should now be equipped with the Draw-Tite 75237 trailer hitch.
How much does it cost to have a minivan’s trailer hitch installed?
The short answer is that it depends on the sort of tow hitch you have, the make and model of your automobile, and how much work it will take to install it. For instance, while some vehicles don’t require drilling to attach a tow hitch, some must.
Hitch installation costs typically range from $100 to $800. Remember that you’ll also need to purchase the tow hitch and other components individually, which can easily cost an additional $150 to $200.
The following vehicle parts are necessary for tow hitch installation, along with our recommended Amazon selections for each:
How much time is required to attach a hitch to a van?
Depending on the labor rates charged by the auto shop and the complexity of the installation, a professional hitch installation may cost $50 or more. The cost rises since more time is needed for some hitch installations than for others due to their greater complexity.
Depending on the installer’s level of experience, the tools being used, the state of the vehicle, and other factors, installing a hitch can take anywhere from 30 minutes to several hours or more. Check the installation instructions for your particular hitch for a useful guidance.
A trailer hitch installation does not void a car’s warranty. The 1975 Magnuson-Moss Warranty Act ensures that consumers can install aftermarket parts without worrying that doing so will void their warranty. The installation has to be done correctly, for example. Any installation done incorrectly won’t be supported (e.g. bolt holes drilled too close together, different hardware used, etc).
How big of a trailer can the Toyota Sienna tow?
The Toyota Sienna can pull how much weight? With a 3,500-pound towing capacity, the 2017 Toyota Sienna is ideal for hauling small boats, trailers, and all of your other gear for your excursions in Palm Beach Gardens!
Tow Rating
The maximum towing capacity of a Toyota Sienna is detailed in the owner’s manual. The model and accessibility of the towing package affect the towing rate. Models of the Toyota Sienna without a tow kit have a lesser towing capacity of 2000 lbs.
The towing capacity of the models with a tow prep package, however, is 3500 lbs. The 2021 Toyota Sienna, which can tow 3500 lbs, is a nice example.
Trailer Brakes
The maximum weight for the unbraked trailer, according to the Toyota manual, is 1000 pounds. To keep a trailer over 1000 lbs on the road, trailer brakes are required. Additionally, if you’re hauling hefty weights, your car will need a trailer brake controller to govern the trailer’s linked braking inputs.
It’s crucial to verify the weight restriction for an unbraked trailer on your specific Toyota Sienna model. You may determine your car’s maximum towing capability without trailer brakes with the aid of the analysis. A significant braking input should be present on both your automobile and the trailer if the weight restriction is incompatible with your model.
How big of a camper can the Toyota Sienna tow?
A Toyota Sienna can in fact tow a camper. Since the 1997 model year debut, the Toyota Sienna has been able to tow up to 3500 lbs. Please consider the following when towing a camper with a Toyota Sienna:
- To prevent excessive wear between the hitch and the coupling unit, always make sure the ball is oiled.
- Place the heaviest goods on the trailer in front of the trailer axle to prevent the camper from rocking back and forth, which could be hazardous for you and other vehicles.
- It’s a good idea to practice in a local parking lot before heading out on the open road if you’re towing a camper with your Sienna for the first time. With the additional weight behind it, the Sienna will handle differently in addition to being more difficult to turn and back up.
- Never attempt to haul a load weighing more than 3,500 pounds with a Toyota Sienna. The additional weight may prevent your brakes from stopping your car in time, in addition to putting greater strain on your engine and transmission.
How to tow with a Toyota Sienna?
The payload capability of a Sienna with basic equipment is 3,500 pounds, but with the towing kit installed, it can pull 2,000 pounds. A small boat or travel trailer will be under the 3,500-pound restriction. There are several crucial safety measures you should take when towing a trailer in your Sienna to make sure that you, your passengers, and your trailer arrive at your destination safely.
How to hitch a camper to your Toyota Sienna is as follows:
- Put the trailer coupler on top of the Sienna’s hitch ball and lock it in place by pulling the lever on the coupler.
- Connect the Sienna to the trailer’s safety chains. To the sienna drawbar holes, the trailer chains ought to be crisscrossed.
- Make sure that all of the lights and signals are operational on both the trailer and the Sienna by connecting the wiring harnesses of the two vehicles.
- Verify the trailer’s tires’ air pressure. The recommended pressure will change depending on the particular trailer and a set of tires, but the tires will be marked on the sidewall with the recommended pressure.
Precautions while towing with a Toyota Sienna
When towing a camper behind a Toyota Sienna, allow extra space between your car and the car in front of you. This is because the Sienna will need more room to stop due to the added weight.
When pulling uphill, pay close attention to the engine temperature indicator. Although it is usual for the engine temperature to be a little higher when towing because the engine is under more stress, if the car starts to overheat, pull over immediately and let the engine cool. Driving with an overheated engine might permanently harm it and result in expensive repairs.
When coming to a halt, reduce your speed gradually to avoid overheating the brakes. When brakes overheat, they may malfunction.
Prevent abrupt accelerations. They not only have the potential to drastically lower fuel consumption than the typical 19 miles per gallon, but they also have the potential to make the trailer unstable and swing.
Keep your balance and control, as if you don’t the trailer may become unstable and perhaps veer into another lane of traffic.
Does your car’s hitch increase its value?
If your car doesn’t already have a hitch, you’ll need to purchase one if you’re going to be towing anything soon.
No need to worry if you’re not an expert at towing!
Here is all the information you require regarding hitch installation.
What Is a Hitch?
A hitch is a vehicle accessory that is frequently mounted on the rear of your car and serves as the link between the car and the trailer. In other words, it establishes a safe and secure connection between your car, van, or truck and the object you are towing. Once installed, hitches boost the utilitarian value of your car and are typically regarded as permanent.
Types of Hitches
A receiver hitch, also referred to as a trailer hitch, is the type of hitch you’ll use to tow a trailer. The best hitch for you will depend on your vehicle and the type of trailer you’re towing. Because there are so many different vehicles that hitches can be installed onto, the design and installation process of your hitch will vary.
rely upon
- ratings for weight (maximum tow capacity)
- Bumper designs
- access to the appropriate mounting locations on your car
- Appearance
There are three sizes for receiver hitches:
- 1-1/4 (for lighter loads like a bike rack)
- 2 (most common hitch size)
- 2-1/2 (for very heavy duty loads)
A variety of various weights can be towed by receiver or trailer hitches. Gross trailer weight (GTW) and tongue weight are the two weights to be concerned about (TW). The weight of the trailer while it is really being towed, fully loaded, is its gross trailer weight. The trailer’s downward strain on the hitch ball is known as the tongue weight. Typically, the TW represents 1015% of the GTW. Learn how to calculate your gross trailer weight and tongue weight capacities here. Based on your requirements and the towing capacity of your vehicle, U-Haul installs hitches with trailer weight ratings ranging from 2,000 lbs to 17,000 lbs.
Check out our towing dictionary for a detailed explanation of all hitch types as well as other towing jargon.
What to Expect
Don’t try to choose a hitch by yourself at a U-Haul location if that’s what you’re imagining. You won’t have to choose the hitch yourself, and you won’t have to put it on by yourself either. You can be confident that you are buying the appropriate hitch with the assistance of a specialist from the moment you enter one of the U-Haul locations. The hitch installation method involves the following variables:
1. U-Haul hitches are manufactured specifically for your car.
The majority of hitches are fastened utilizing pre-existing bolt holes and nuts and bolts.
When installing, a U-Haul Hitch Professional will inspect the area of your vehicle where the hitch will be mounted. If there are no existing attachment points, they are trained to construct ones using unique tools.
If any vehicle parts are blocking a hitch connection point, they will likely merely need to be temporarily detached and reinstalled after the hitch is in place.
The following components could be taken out and put back in:
- Fascia
- coverings for the body
- Brake beams
- a blow-bar
- Rear lights
- Muffler or an exhaust
- Extra tire
Sit back and unwind; any brief adjustments being made to your car will be explained to you along the way.
2. U-Haul is currently offering the appropriate pricing at the perfect hitchat. In most sites, U-Haul keeps more than 85 hitches on hand for popular vehicle applications. However, if your vehicle’s hitch isn’t in stock, don’t worry; we have more than 1400 locations across North America and 30+ warehouses to ensure prompt delivery of your hitch. You could even be able to go in and get your hitch put right away.
Online Scheduling
You can schedule an installation from your desktop or mobile device, if you’d like. In fact, booking an online hitch installation will get you a $10 discount. You can acquire the ideal hitch for your needs by just responding to a few questions about your car. From there, you can also choose whether you want your hitch fitted at a U-Haul facility close by or mailed to you. For only $5, U-Haul also offers an exclusive lifetime unlimited warranty on your hitch. For $10 more, the installed wire is covered for two years under our trailer wiring warrantyeven if the dog chews it off!