It couldn’t be any simpler to take the antenna off the Tacoma. Use an open-end wrench to gradually loosen the antenna until the base’s threaded rod can be separated from it. The antenna should then be removed.
In This Article...
Antenna Installation
An aftermarket antenna can be set up just as easily. The antenna is simply threaded into position. I won’t lie; I don’t have much to say about each antenna because, aside from size and design, they aren’t all that different.
AntennaMastsRus6 3/4 Antenna
This antenna was the tallest, so I assumed it would perform the best. That wasn’t the situation.
Performance was comparable to that of the other antennas. All of the antennas tested here today in fact performed identically. Every antenna present had numerous instances of that “underwater sound,” while some antennas functioned better in haphazard locations on the road. It was annoying that not a single antenna worked perfectly from home to the office.
No antenna outperformed the others in terms of producing any mind-blowing outcomes. It was no clearer than any other antenna in areas where audio was actually coming in.
I spent a week driving around, switching between antennas, and using each one of these antennas to listen to AM and FM radio. Between these three antennas, I didn’t observe any performance differences.
I won’t argue that every antenna is bad; perhaps I should have purchased the Bullet and a few others to try out first. I’m now intrigued.
In regards to the aftermarket antennas I examined, appearance is the only factor that matters, so let’s avoid discussing performance.
CravenSpeed Stubby Jr Antenna
Short and chubby, the CravenSpeed Stubby Jr Antenna. Cool looks, ok performance. I do not like the stubby appearance. After using it for a week, I expected to like it the most but find that I loathe it the most.
KEYO1E 4.9 Short Antenna
My favorite antenna in terms of layout, dimension, and look is the KEYO1E 4.9 Short Antenna. No mention of “improved performance” was made once more. If anything, this one performed better, which may be why, after experiencing so much antenna annoyance, I was drawn to it. It all comes down to taste and appearance in the end.
Final thoughts
I’m not going to lie. Compared to the factory antenna, pretty much every antenna performs horribly. There are almost no dead spots in the original antenna that Toyota provides. The sound usually comes through clear and sharp when linked to AM and FM radio.
On the other side, the audio quality will unquestionably suffer if you install an aftermarket antenna. Since I don’t usually listen to AM or FM radio, it doesn’t matter to me, but if you regularly listen to the radio, getting an aftermarket antenna might not be the best choice for you.
Additionally, every aftermarket antenna we examined included built-in threaded rods. When threaded and unthreaded, each threaded rod would separate from the actual antenna. Although not a deal-breaker, repeatedly screwing and unscrewing the antenna is kind of bothersome.
Aftermarket antennas are only useful for the aesthetics and the practicality of not covering everything with a short overhang that they offer.
How can a broken antenna be repaired?
An item in EarthBound is called The Broken Antenna. Jeff Andonuts can fix it to create his ultimate weapon, the Gaia Beam. This calls for a 65 IQ. Uncontrollable Spheres drop Broken Antennas 1/128 of the time. By scrolling to a specific location of the screen where the enemies reset, you can re-spawn the Uncontrollable Spheres between two specific areas, increasing the frequency with which the opponent appears and increasing your chances of getting the Broken Antenna.
What is the price of a new automobile antenna?
Depending on the style, replacing an antenna should cost between $100 and $150. Think it’s too expensive? Instead, purchase a used antenna from a junkyard.
Installing the antenna yourself will save on labor costs. If you’re unsure of how to do it, expert installation will likely cost $50 to $100, adding up to a total of $200 or less.
However, you shouldn’t bother replacing your antenna if you seldom listen to the radio anyhow. (Awesome, Spotify!)
Spend less on auto insurance to save even more money in your pocket. In less than a minute, the Jerry app will produce comparative quotations from leading suppliers. Nothing lengthy. No contacting anyone. zero effort merely savings
Fixed mast
Use the corresponding base stud from the kit to replace the old one. The replacement mast is then screwed in.
Fixed-mast antenna replacement is more simpler. Purchase a universal kit from any car parts retailer (around $15). Installing the replacement mast only requires unscrewing the damaged mast with an adjustable wrench. To match the thread size, you might need to install an adaptor (part of the kit).
Should I take the antenna off before I wash the car?
It could seem simple and quick to maintain your automobile appearing clean and new by using an automatic car wash. However, if it sustains damage, it can look worse than when it first arrived.
Although an antenna can be used in a car wash, it is typically better to retract or remove it before entering to prevent damage. Your antenna could be damaged by the moving parts of a car wash, such as rotating brushes, mechanical arms, and blower housings.
This article will address how to avoid damage and what to do if your car receives any, in addition to detailing the potential harm automatic car washes can make to your vehicle’s antenna. I’ll also discuss the various car washes and let you know which one is the least damaging to your automobile.
What happens if the antenna on your car breaks?
Car antennas frequently break or sustain damage since they protrude from the surface of a car’s exterior and stand there.
If you don’t have an antenna, your radio may be off. With a damaged radio antenna, reception will be problematic.
Can I get a shark fin for my automobile antenna?
Modern shark-fin antennas are available from NEXA, however they seem extremely strange because they are installed at the back of the roof while the antenna in the XL6 is at the front.
How is a stubby antenna installed?
1. Remove the stock antenna’s screws. You might need to use a small open end wrench if you can’t complete the task by hand. The majority of factory antennas feature flats for a wrench at the base.
Continue to step 2 if your antenna already has the adapter installed (most do). Go directly to step 3 if your antenna arrived with two adapters.
2. The antenna is simply screwed onto the antenna base. Hand-in should be used. If not, proceed to step 4. If it does, kudos to you! You’ve finished!
3. Some automobiles (particularly Ford trucks) frequently employ one of two antenna sizes. To ensure that your antenna will fit the first time, we have included two adapters for these circumstances. Simply select the adapter that matches your stock antenna, place it into our mast, and tighten it down using an allen wrench. Once the adaptor is installed, all that’s left to do is mount the new antenna to the car. See step 4 if you’re having problems getting the antenna inside the car.
4. Having trouble getting the antenna to screw into the vehicle all the way is the installation’s most frequent problem. Usually, corrosion buildup or debris becoming caught in the threads of the antenna base is the culprit. The Stubby Antenna shouldn’t ever need to be installed using tools! Installing the antenna with pliers is NOT recommended. The stainless adapter can be removed from the antenna using an allen wrench, which is the simplest fix for this issue. The adaptor can then be first installed in the car. The allen wrench will offer you leverage and should make it easier for you to install the adapter completely.