Here is the process from the owner’s manual for the 2010 Vibe (similar to the Matrix/Corolla). Drive a short distance, then check the fluids while the engine is in park.
(At least on my Vibe, the handle is not orange as described. Additionally, the procedure is not “tough.” The instructions even suggests using the incorrect fluid following several cautions against doing so. However, that is unimportant to your objectives.)
Because this procedure can be challenging, you might decide to have it done at the dealer’s or retailer’s service center. To avoid getting a misleading reading on the dipstick if you attempt to do it yourself, make sure to carefully follow these steps.
Warning: Using the wrong automatic transmission fluid might cause damage to your car that could not be covered by your warranty. Use the recommended automatic transmission fluid on pages 1118’s Part D: Recommended Fluids and Lubricants at all times.
If you have been driving, wait at least 30 minutes before checking the gearbox fluid level:
- when the temperature outside exceeds 90F (32C).
- long period of time at fast pace.
- especially in hot weather and heavy traffic.
- if you’re towing a trailer.
The fluid must be at normal working temperature, which is 158F to 176F, to obtain the proper reading (70C to 80C).
When it is over 50F outside, warm the car up by traveling about 15 miles (24 km) (10C). It could take longer to travel if the temperature is below 50F (10C).
Get your car ready as follows:
1. Always park your car on a flat surface. Continue running the engine.
2. Put the gear lever in P while the parking brake is engaged (Park).
3. Shift through each gear range with your foot on the brake pedal, waiting for around three seconds in each. Next, set the shift lever to P. (Park).
4. Allow three to five minutes for the engine to idle.
Then, without turning off the engine, carry out the following:
The dipstick for the automatic transmission is close to the front of the engine compartment and has an orange handle.
1. Pull out the dipstick by releasing the tab, then clean it with a fresh cloth or paper towel.
2. Completely push it back in, wait three seconds, and then draw it out once again.
3. Examine the dipstick’s two sides and read the bottom level. The fluid level must be in the hot range, halfway between the two dimples.
4. If the fluid level is within the permitted range, fully re-insert the dipstick and then depress the tab to secure it.
In This Article...
How can the gearbox fluid in a Toyota Corolla be checked?
response given by
- Turn on your car if it isn’t already.
- Locate the transmission fluid dipstick on the driver’s side of your automobile by opening the hood and looking toward the front.
- Take the dipstick out.
- The dipstick should then be cleaned and properly reinserted.
- Removing the dipstick gently will allow you to check the fluid level.
What type of transmission fluid is required for a 2010 Toyota Corolla?
Full Synthetic Dexron VI Automatic Transmission Fluid, 1 Quart, FRAM Transmission Fluid (Part No. F426)
Do you examine your Toyota’s gearbox fluid while it is moving?
It only takes a few minutes to check your car’s transmission fluid, which should be done around once a month. You should inspect the transmission when the engine is running and adequately warmed up, on a level service, to get the most accurate result.
- First, take out the dipstick from inside the hood (see your owner’s manual if you’re not sure where it is).
- Typically, the handle is brightly colored (generally yellow or red).
- The stick should be taken out, cleaned, replaced, and then taken out once more.
- Check the warm readings. “Warm” and “Cold” labels are there.
- If it isn’t full, gradually top it off while continuing to use the dipstick to monitor the amount of liquid.
- Use a funnel to pour the liquid into the hole created when you removed the dipstick. Replace the dipstick after filling, then take it out after a little while to make sure you did it right.
Make sure to look at the color of your transmission fluid when examining it. The color of transmission fluid is pinkish/red. Brown fluid is a warning indicator that there might be a problem with the car. If this is the case, make a service appointment so that our knowledgeable specialists can assist you.
In a Toyota Corolla, where do you put the gearbox fluid?
The ability to perform simple auto repairs on your own is undoubtedly valuable. Follow these instructions to replace the automatic gearbox fluid in a Toyota Corolla:
- Put your car in a level spot. You can also put your automobile on jack stands if you’d want to make it simpler to reach the transmission fluid drain pan.
- Find the transmission fluid filler tube under the hood and take the dipstick out. Change it out for a funnel.
- Use a socket wrench to remove the drain plug after positioning a drip pan beneath the transmission fluid drain pan.
- Give the pan time to fill up with the used transmission fluid.
- Carefully unfasten the bolts holding the fluid pan in place using your socket wrench.
- The strainer’s bolts should be removed after you remove the fluid pan. After that, cautiously take out the strainer as well.
- Remove any extra liquid, clean the fluid pan and strainer, and then reinstall them where they belonged. Make sure you also replace the drain stopper.
- The moment has come to add more liquid. Fill the filler tube with new transmission fluid, carefully pouring it in while monitoring the level with your dipstick.
- Turn on your car and let it idle for three to five minutes after filling the transmission fluid reservoir to the correct amount.
- Check the amount of your transmission fluid after restarting your car. If more liquid is required, add it.
What signs indicate low transmission fluid?
While you wait, it’s a good idea to become aware with the warning indications that your transmission fluid may be running low.
- Noises.
- Burning odor
- Leaky transmissions.
- Gears That Slip.
- Slow Engagement of Gears.
- Poor Vehicle Acceleration
- The warning light for the check engine or transmission is on.
A transmission filter is there in a 2010 Toyota Corolla?
It’s possible that your 2010 Toyota Corolla is the best car you’ve ever owned. Or perhaps you’re just having trouble keeping it highway-legal. Whatever the circumstance, Advance Auto Parts carries the Automatic Transmission Filter item you frantically require.
How frequently should a Toyota Corolla’s gearbox fluid be changed?
Because automatic transmissions are standard on most current cars, little maintenance is normally required. Nevertheless, depending on how much you drive, you should replace the transmission fluid in your Toyota Corolla after 90,000 miles or every seven to eight years.
You may have a variety of performance issues if you don’t have your transmission fluid replaced, such as:
- Overheating
- changing gears
- a challenging or delayed shift
The cost to change your transmission fluid is estimated to be roughly $150. But doing so will ensure that your car is in good form for many years to come.
Make sure you have excellent auto insurance as this is another strategy to safeguard your vehicle for the long run. Using the Jerry app, getting the coverage you require without paying too much for it is simple.
Even once Jerry finds you fantastic insurance at a low cost, the discounts keep coming. You’ll receive fresh, competitive quotations prior to each policy renewal period, ensuring that you always have the finest coverage at the lowest cost. It’s okay if you wish to change policies! Jerry can assist in terminating your old coverage.
Does Toyota advise changing the gearbox fluid?
Your Toyota car depends on a few essential components to function at its best. The transmission in your Toyota is one of its most crucial aspects, as you are well aware. Consequently, the transmission fluid that the car utilizes is crucial! Today, the crew at Toyota Palo Alto will discuss how frequently you should check or replace the gearbox fluid in your Toyota car.
Replacing and Inspecting Your Toyota Vehicle’s Transmission Fluid
The Owner’s Manual for your Toyota outlines how frequently you should change and check the gearbox fluid in your car. In general, the intervals between changing the transmission fluid and inspecting it are between 15,000 and 100,000 kilometers.
Toyota advises changing the fluid in automatic transmission-equipped cars every 60,000 to 100,000 kilometers. Fluid changes for manual gearbox vehicles should be performed every 30,000 to 60,000 miles.
Importance of Replacing and Inspecting Your Toyota Vehicle’s Transmission Fluid
It is crucial to change or check the transmission fluid in your Toyota car at the recommended intervals. This will enable the fluid to provide improved lubrication and heat dissipation, which results in significantly improved performance and stability. Additionally, changing out old fluid cleans out any extra particles and debris that may have accumulated inside the transmission system!
Come see us at Toyota Palo Alto today to have the transmission fluid in your car examined or changed! By doing this, you can be confident that your Toyota is performing at its best! If you have any questions, get in touch with our staff!
In a Toyota Corolla, how much does it cost to change the gearbox fluid?
Cost of changing the transmission fluid Even though it usually depends on the car, the majority of gearbox services cost between $100 and $300. In general, if you have a vehicle that requires a lot of a certain fluid or a particularly specific one, the majority of this cost may not always be in the work but rather in the price of the fluid.
Is there a transmission dipstick on a Toyota?
Fluid Inspection in a Sealed Transmission You won’t have a dipstick to monitor the amount of transmission fluid if your Toyota has a sealed transmission.
How do I check the transmission fluid in my Toyota?
Guidelines for Checking Transmission Fluid
- Start the vehicle.
- Find the dipstick for the transmission fluid.
- Touch the liquid with the dipstick while rubbing your thumb and forefinger together.
- To clean the dipstick, use a rag.
- To raise the fluid level to the proper level, use a funnel.
The dipstick for the gearbox fluid is where?
- Start the engine after parking the car on a flat area. Park or leave the car in neutral. If the owner’s manual for your car doesn’t specify differently, let the engine warm up and run all the way through operation. (Keep in mind that certain automatic transmission fluid level checks are done with the engine off. Consult the owner’s manual.)
- Where the transmission or transaxle meets the back of the engine is normally where you may find the automatic transmission fluid dipstick. It resembles an oil dipstick in appearance.