Start on the Tundra’s driver side. Two tiny wings at the back and a tab in the front keep the wiper in place, respectively. To get the tab to come out of the slot, push the front of the wiper down. Note that OEM blades on your car will release in reverse; to disengage the wings, push down on the back of the blade.
In This Article...
For a Toyota Tundra, what size windshield wipers am I going to need?
Depending on the model year, the Toyota Tundra requires a different size wiper blade.
In contrast to the 2013 Toyota Tundra, which needs a 24″ driver’s side blade and a 22″ passenger’s side blade, the 2021 Toyota Tundra needs a 26″ driver’s side blade and a 22″ passenger’s side blade.
The Toyota Tundra’s wiper blades are a crucial safety feature and should be routinely inspected, cleaned, and replaced as needed.
Check your blades once a week or anytime you find that they are not preserving the visibility of your windshield.
It’s crucial to utilize the proper Toyota Tundra sizes when it comes time to change the wiper blades.
For thorough information about your specific Toyota Tundra model year, scroll down or quickly jump.
What size wipers are on a 2020 Tundra’s windshield?
The size of the driver-side wiper blade on the 2020 Toyota Tundra is 26 inches, while the passenger-side wiper blade is 22 inches.
Lift your wipers up from the windshield
It should be simple to lift your wipers up and away from your windshield once they are stopped halfway on your windshield. The old wipers on your windshield should protrude and point away from you. Now providing for simple access throughout the remaining modifying procedure.
Before you remove old wiper blades
Make sure to note which side the new blade length belongs on. Measure the previous blades’ length or simply compare it to the new Trico wiper blades. Then, position the fresh blades on the appropriate side.
Remove old wiper blades
The wipers on your 2020 Toyota Tundra are attached using a pinch tab. Click the button or tab. To remove it from the old wiper, tilt or slide it.
The pinch tab attachments used by different wiper manufacturers vary in style.
Connect the new Trico Tech Beam Blade wipers
When using this arm type, the preattached adaptor on the wiper blade must be removed and replaced as shown with the adapter (BC)
1. Move the tiny adapter lever in the direction of the blade’s center.
2. As you complete step 1, remove the factory-installed adaptor from the blade and throw it away.
3. Locate the BC adaptor and place it in the blade’s middle. the two protrusions inside the adaptor onto the “X”-marked region of the blade.
4. Push the tab on the adaptor’s front (B).
5. Remove shim (C) from adaptor (B) and throw it away. Tip: To remove shim (C) more easily, press down on the top edge of adaptor B.
6. Raise the back end of the adaptor while maintaining a tight grip on the front.
7. Raising the blade into the bottom of the arm, line up the side arm tabs with the side tabs on the adaptor’s back end.
8. Extend the blade’s rotation until the arm’s tip latches beneath the adaptor tab.
9. Where indicated, the adaptor must lock onto the arm.