The 3.5L V6 engine of the 2GR-FE needs 6.4 US
Depending on how much time was spent draining the old oil, use U.S. quarts of fresh SAE 0W-20 oil.
In This Article...
Exactly how much oil does a 2013 Toyota Highlander require?
The 2.7L 4-cylinder engine in a 2013 Toyota Highlander has a capacity of 4.6 quarts, whereas the 3.5L V6 engine has a capacity of 6.4 quarts. Both engines are available, however they each have different oil capacities.
When it’s time for an oil change, keep in mind that synthetic oil is recommended for both of these engines!
While you’re hunting for your new car, check your auto insurance to make sure you aren’t losing out on any coverage (or discounts!).
The quickest and best approach to get a vehicle insurance plan that is tailored to your needs if you don’t like what you see is to use Jerry.
Jerry, a certified broker, undertakes all the legwork involved in obtaining affordable estimates from the most well-known insurance providers and purchasing new auto insurance. Even better, Jerry will do it for you and assist you terminate your old coverage!
Exactly how much oil does a Toyota Highlander require?
These guidelines were developed using an oil change on a 2018 Highlander XLE 3.5L V6. While you can apply the fundamentals to different models and years, you should always reference your owner’s handbook for details particular to your car.
Warm up the engine
Start your engine and let it run for a while in cold weather to thin out the air and improve oil flow. A level space is recommended for parking your Toyota Highlander. Once the engine has warmed up, shut it off.
Drain the old oil
The drain bolt can then be removed by crawling underneath your Highlander. Allow the oil to drain for at least 15 minutes into your drain pan or another suitable container.
To stop leaks, replace the washer in your drain bolt. The oil drain bolt should then be installed once more and tightened.
Remove the filter
A 2018 Toyota Highlander’s oil filter is located underneath the vehicle. Utilizing the Toyota Highlander oil filter wrench, remove the filter housing. Take off the O-rings and old filter from the housing. Verify that the engine surface is free of any adhesion to the filter gasket.
Install the new oil filter
Before installing the replacement filter, clean the engine block of any debris and residue. Place the replacement filter and O-rings inside the housing after lubricating them.
Put new oil in the engine
5.8 quarts of engine oil should be poured into the oil fill hole. Start the engine after replacing the fill cap and making sure it is properly screwed in. Time you let the engine run for a while, look for leaks from the oil filter and drain bolt.
Stop the engine and check the oil level
Stop and wait for three minutes after running the engine for a while. Check the oil level with the dipstick and add extra if necessary.
Dispose of the old oil according to regulations
Never dispose of used oil in the trash or on the ground. The environment could be harmed if this is done. The majority of states require businesses that sell motor oil to accept your used oil, as do service centers and establishments that change oil (like Jiffy Lube). For information on additional locations to recycle your oil, consult the websites of your state or municipal government.
How often should the oil be changed in a Toyota Highlander?
One of the most fundamental and important maintenance for your car is an oil change. For conventional oil, Toyota suggests changing your 2021 Toyota Highlander’s oil and filter every 3,000 to 5,000 miles. Normally, synthetic oil needs to be changed every 7,500 to 10,000 miles.
What type of oil should I use for my 2013 Toyota Highlander?
The optimum option for efficient fuel use and starting in cold weather is engine oil 0W-20. In the absence of 0W-20, 5W-20 may be utilized. However, the following oil change requires that it be swapped out with 0W-20.
What type of oil does a 2013 Toyota Highlander take?
High Mileage 5W-20 Full Synthetic Motor Oil, 5 Quart, from Mobil 1 (Part No. 120768) Product attributes: For engines with more than 75,000 miles, Mobil 1 High Mileage full-synthetic motor oil 5W-20 is made to allow up to 10,000 miles between oil changes.
Where is the oil filter located?
What location does the oil filter have? Different cars have different locations for the oil filter. It is frequently only reachable from below and may be protected by the undertray, which must first be removed. On some automobiles, the filter is accessible from above.
How can you turn a Toyota Highlander’s maintenance light back on?
Toyota Highlander Maintenance Light Reset Press the odometer button on your dashboard quickly, hold it there while turning the key to the second position. Hold the odometer button down for another 10 seconds or so. You can hear a beeping noise in addition to the maintenance light beginning to flash. The light ought should thereafter go out.
A 3.5 L Toyota Highlander uses how much oil?
The 2.7L 4-cylinder engine consumes 4.6 quarts of oil, while the 3.5L V6 engine requires 5.8 quarts. Both engine options are available for the 2018 Toyota Highlander.
Keep in mind that synthetic oil is recommended for both of these engines whenever you need to replace the oil!
It can be enjoyable to shop for a new automobile, but it’s not necessarily the best to do the same for your auto insurance. Thank goodness, the Jerry app has made it simpler than ever to compare prices on vehicle insurance.
The Jerry app, a registered broker that provides end-to-end support, compiles reasonable rates, assists you in switching plans, and even assists you in terminating your old policy. Jerry will even assist you in combining your auto and house insurance for the greatest savings!
Uses synthetic oil in the Toyota Highlander 2021?
There are two sorts of oil in the world, regular and synthetic, apart from different viscosities. Although there is a third variety that combines the first two, you often deal with either one or the other. The best option for your Toyota? What kind of oil is used in your Toyota? We offer all the solutions you require.
Does a Toyota need a specific kind of oil?
At this point, all current Toyota vehicles either require synthetic oil or at least recommend it. You must reference your manual to be certain. However, if you only decide to use synthetic oil, it will be far better for your engine and will simplify everything.