High Mileage 5W-20 Full Synthetic Motor Oil, 5 Quart, from Mobil 1 (Part No. 120768)
In This Article...
How frequently should a 2010 Toyota Highlander have its oil changed?
For traditional oil, Toyota suggests changing your Toyota Highlander’s oil and filter every 3,000 to 5,000 miles. Generally speaking, synthetic oil needs to be changed every 7,500 to 10,000 miles.
A 3.5 L Toyota Highlander uses how much oil?
The 2.7L 4-cylinder engine consumes 4.6 quarts of oil, while the 3.5L V6 engine requires 5.8 quarts. Both engine options are available for the 2018 Toyota Highlander.
Keep in mind that synthetic oil is recommended for both of these engines whenever you need to replace the oil!
It can be enjoyable to shop for a new automobile, but it’s not necessarily the best to do the same for your auto insurance. Thank goodness, the Jerry app has made it simpler than ever to compare prices on vehicle insurance.
The Jerry app, a registered broker that provides end-to-end support, compiles reasonable rates, assists you in switching plans, and even assists you in terminating your old policy. Jerry will even assist you in combining your auto and house insurance for the greatest savings!
How much oil does a Toyota Highlander use, in quarts?
These guidelines were developed using an oil change on a 2018 Highlander XLE 3.5L V6. While you can apply the fundamentals to different models and years, you should always reference your owner’s handbook for details particular to your car.
Warm up the engine
Start your engine and let it run for a while in cold weather to thin out the air and improve oil flow. A level space is recommended for parking your Toyota Highlander. Once the engine has warmed up, shut it off.
Drain the old oil
The drain bolt can then be removed by crawling underneath your Highlander. Allow the oil to drain for at least 15 minutes into your drain pan or another suitable container.
To stop leaks, replace the washer in your drain bolt. The oil drain bolt should then be installed once more and tightened.
Remove the filter
A 2018 Toyota Highlander’s oil filter is located underneath the vehicle. Utilizing the Toyota Highlander oil filter wrench, remove the filter housing. Take off the O-rings and old filter from the housing. Verify that the engine surface is free of any adhesion to the filter gasket.
Install the new oil filter
Before installing the replacement filter, clean the engine block of any debris and residue. Place the replacement filter and O-rings inside the housing after lubricating them.
Put new oil in the engine
5.8 quarts of engine oil should be poured into the oil fill hole. Start the engine after replacing the fill cap and making sure it is properly screwed in. Time you let the engine run for a while, look for leaks from the oil filter and drain bolt.
Stop the engine and check the oil level
Stop and wait for three minutes after running the engine for a while. Check the oil level with the dipstick and add extra if necessary.
Dispose of the old oil according to regulations
Never dispose of used oil in the trash or on the ground. The environment could be harmed if this is done. The majority of states require businesses that sell motor oil to accept your used oil, as do service centers and establishments that change oil (like Jiffy Lube). For information on additional locations to recycle your oil, consult the websites of your state or municipal government.
How frequently should I have my Toyota Highlander’s oil changed?
One of the most important and crucial procedures for your car is an oil change. Generally speaking, synthetic oil needs to be changed every 7,500 to 10,000 miles. For traditional oil, Toyota suggests changing your 2020 Toyota Highlander’s oil and filter every 3,000 to 5,000 miles.