The 2021 Toyota Corolla has an interference engine with a timing chain in every variant. Check out the information in the table below.
In This Article...
When should a Toyota Corolla’s timing belt be changed?
Timing belts are important, but unless your Toyota owner’s handbook specifically advises it, they don’t need to be replaced on a regular basis. Between 60,000 and 100,000 miles, some automakers advise changing the timing belt, while others don’t. Many timing belts available now can last 100,000 miles or more before they need to be replaced.
How long do Toyota Corolla timing chains last?
The timing chain should be changed between 80,000 and 120,000 miles, barring a specific defect. Chain issues are common in vehicles with higher mileage. Watch for indications that the timing chain is failing if you have an older or high-mileage vehicle.
What are the Toyota Corolla’s worst years?
Since its introduction in 1966, the Toyota Corolla has purportedly sold more than 44 million vehicles worldwide (though some will argue that since there are multiple different Corolla models, not all of those sales should be included). It has been successful in establishing a reputation as a reliable, inexpensive car.
Despite living up to this reputation, the model has some drawbacks. While some years have considerably better service histories, some have seen their fair share of problems. CoPilot will therefore inform you of the model years to steer clear of if you’re looking to buy a secondhand Toyota Corolla.
Quick Answer: Avoid 2000, 2001, 2002, 2003, 2009, and 2014 Toyota Corollas
Excessive oil consumption in the engine has been one of the Toyota Corolla’s most frequently encountered issues over its lifetime. Although it did occur in other years like 2014, these model years saw a higher prevalence of it: 2000, 2001, 2002, and 2009. The 2003 and 2009 models, however, were plagued by transmission issues. Particularly in 2009, cooling issues as a result of water pump failure were frequently reported. These model years had more minor difficulties than others, like body/paint and interior accent problems.
Is the 2008 Toyota Corolla a good car?
The 2008 Toyota Corolla offers excellent fuel efficiency and simple handling at a cheap initial cost. Due to some of its rivals’ more distinctive design features and sportier driving characteristics, the Corolla is rated in the center of its class.
Is there a timing belt or chain on a 2009 Corolla?
Timing belt vs. chain: There is no timing belt; the 1.8L and 2.4L engines both have a timing chain. If the timing chain is functioning properly, there is no need to replace it.
Timing belts or chains: which is superior?
Prior to making a purchase decision, you may be examining the specifications of various cars. What is the displacement of the engine? What type of brakes is it equipped with? How is the transmission handled? Exists a long-range AEB with it? Before making a decision, there are several factors you can compare between each car. We’ll be discussing timing chains and belts today.
The camshaft and crankshaft rotations are synchronized using timing chains or belts. As a result of the Overhead Cam (OHC) arrangement used by the majority of modern engines, the crankshaft and camshaft must be connected by a belt or chain. Timing belts or timing chains are also necessary for engines with push rod configurations (although shorter in length).
Some contend that the greater lifespan of timing chains makes them superior. Some contend that the cheaper replacement costs and quieter operation of timing belts make them superior. The problem is that when buying a car, you cannot select whether it will have a timing chain or belt. If you liked one timing system over the other, you’d have to purchase a new vehicle.
Consider a Perodua Myvi and a Proton Iriz as examples. An Iriz has a timing belt, whereas a Myvi has a timing chain. Does that mean that one car is better than the other? Does one require less upkeep than the other?
A: Timing chains outperform timing belts in strength. Timing links are also more durable. Timing belts are more affordable, simpler to replace, and quieter than timing chains.
A: Yes. usually only slightly. Since the gear teeth are worn out as well, fixing the timing chain also necessitates changing certain gears. Timing chains, however, do not require as frequent replacement as timing belts.
A: Yes. The engine oil must lubricate the timing chains. As a result, they live in a more contained structure. Consequently, it will take more effort to reach the timing chain. Timing belts are easier to service because they often only have a plastic cover to protect them.
A: Yes. The sprockets and gear teeth mesh. Over time, the chain stretch lengthens and the gear teeth begin to wear out. They eventually need to be replaced. A timing chain replacement does not, however, have a set replacement interval.
When the timing chain stretch could potentially harm the engine, the engine warning light will typically on. If that happens, turn off the engine. Chain strain could result in the chain jumping a gear tooth, throwing off the timing of the pistons and valves and resulting in some rough idling.
A: Yes. They must be replaced as a result around every 100,000 kilometers. Timing belts that aren’t maintained could rupture and seriously harm the engine (especially interference engines). Teeth that are worn down could potentially cause timing belts to slip.
What is the worst thing that could happen if the timing chain or belt breaks?
This is the case with interference engines that are more efficient and smaller in design. Timing belts tend to snap more frequently, although in most cases, if you change them on schedule, this issue shouldn’t arise.
A combination. A timing belt is used by an earlier RB26DETT. A timing chain is used by more recent VR38DETTs.
Timing belts and chains aren’t even used in some vehicles, like the Ferrari Enzo. Instead, they synchronize the valves with the engine rotation using a number of timing gears. Compared to timing chains, timing gears are louder.
To sum up:
- Timing chains are more expensive than timing belts but have a longer lifespan.
- Using one over the other has no impact on performance or fuel economy.
- Timing belts were mostly used in autos due to their lower cost. They function just as well.
- Timing chains may sag over time, resulting in gear teeth that “jump.”
- Teeth on timing belts can wear out and move. Timing belts are also more susceptible to breaking.
- Timing belt or timing chain failure can have disastrous effects on the engine.
- The lower operating noise of timing belts is an additional advantage.
No matter what type of timing system your car has, you should undertake routine maintenance to keep an eye on the condition of your timing belt or chain.
What happens if a Toyota’s timing belt snaps?
An engine that is freewheeling will simply stop running if the timing belt fails. But interference engines are used in several other Toyota motors. In other words, the pistons take up the same amount of space in the cylinders as the open valves do.
Will my engine be destroyed if my timing belt breaks?
Your vehicle’s timing belt deteriorates and becomes degraded as it ages and accrues miles. Although changing a timing belt is a straightforward procedure, a worn-out timing belt that snaps can badly harm your engine and cost you thousands of dollars.
The camshaft and crankshaft are connected by a small rubber belt called the timing belt, which regulates when the valves open and close. Despite the fact that timing belts are made to be sturdy and resilient, they will ultimately wear out. When the belt snaps, the valves fail to close in time, resulting in instant engine damage from the pistons slamming into them.
Timing belt replacement is one of the routine auto maintenance procedures that the manufacturer advises. Typically, timing belt replacement should be performed every 70,000 to 110,000 miles. For more particular advice, consult your owner’s handbook. The cost of replacement varies depending on the vehicle, but it is always far less expensive than the cost of an engine repair.
Your car may sometimes show these symptoms if the timing belt is compromised:
- significant exhaust that is visible The fuel isn’t burning properly if there is thick smoke coming from the tailpipe, which could be a sign that the valves aren’t opening or shutting properly.
- Engine vibrations that seem odd
- The engine rhythm can be impacted by a stretched or toothless timing belt, which can make the car tremble or shake.
Timing belts can often fail without any preceding signs, so if your car needs a new timing belt, schedule it right away.