Where To Put Transmission Fluid In 2006 Nissan Altima?

Nissan’s crowning success in the early 1990s, as it started to advance into the future, was to replace the outdated Stanza with the Altima. Nissan drastically changed the Altima’s style in 2002, abandoning the iconic bubble design in favor of sweeping body lines and acute edges. The 2006 Altima, the final model of this recently updated generation, uses a RE4F04B automatic transmission, or a four-speed automatic in non-Nissan jargon. In some ways, replacing the transmission fluid is easier than changing the engine oil.

Once the temperature gauge is about halfway up, turn on the Altima’s engine and let it idle for a while. Reverse the engine. Slide jack stands beneath the subframe of the Altima and lift the front of the car with a floor jack. Onto the jack stands, lower the Nissan.

Locate the transmission drain plug on the bottom of the transmission by crawling underneath the front of the car on the driver’s side.

Put a measured drain pan under the drain plug and use a ratchet and socket to release it. Remove the drain plug by hand while protecting your hands from burns by wrapping them in a thick shop cloth. Remove the washer from the drain plug, then throw it away.

Ladder the liquid into the drain pan. Once the fluid has stopped dripping, slide a fresh washer onto the drain plug. Drain plug should be manually threaded into the transmission and then tightened using a ratchet and socket.

Use a floor jack to lift the car off the jack stands, then take them off. To the ground, lower the car.

Check the measuring drain pan to determine how much transmission fluid you have removed. Nearly 9 3/4 gallons of liquid should be present in the drain pan. Take out the dipstick for the automatic transmission, clean it with a lint-free cloth, and set it away. Fill the ATF dipstick tube with a funnel. Fill the transmission with 9 3/4 quarts of Genuine Nissan Matic D ATF.

As soon as the engine is running, let it idle until the temperature indicator is halfway up. Stop the engine and wait about two minutes for the transmission fluid to settle after shifting through each gear in the transmission while waiting for about five seconds at each.

Remove the gearbox dipstick, then clean it with a lint-free, clean cloth. Put the dipstick back in and take it out once more. Check to see if the fluid level is inside the crosshatched area on the dipstick’s “Hot” side. As required, add extra Genuine Nissan Matic D ATF.

Fill a transmission fluid bottle with oil from the drain pan using the funnel and an empty bottle of transmission fluid. Close the fluid bottle’s cap after removing the funnel. Until all of the liquid has been transferred to the empty bottles, repeat this step. Take the now-empty bottles to a facility that recycles spent vehicle fluid. Many auto parts retailers offer free pickup of used transmission fluid.


I apologize for the stupid question. My Nissan Altima 06 had 2.5 liters of transmission fluid, so I drained and refilled it, and I had the impression that I hadn’t checked the fluid level correctly.

I could see the fluid just above the full mark of both the cold and hot scales while the engine was cold and not yet ignited. I had the impression I could have loaded the fluid too much. After that, I reviewed the owner’s manual for the automobile, which stated that the fluid level should be checked when the engine is still running and at operating temperature. I therefore did as it instructed. To make sure the engine was really hot, I ran it for ten minutes. I took the dipstick out to check the level while the engine was still running. I was astonished to see the fluid slightly below the low threshold at the coldest point on the hot scale. However, when I immediately shut off the engine and checked the fluid level, I could see that it had returned to the hot scale’s full mark.

Now, I’m really perplexed. How exactly should the transmission fluid level be checked? Should I examine the engine when it’s incredibly hot but still operating normally? Does this indicate that my transmission fluid is low?

How can the gearbox fluid in a Nissan Altima be checked?

  • Access location for transmission fluid: remove dipstick.
  • Check Level: To check the level, insert the dipstick and remove it.
  • Add Fluid – Select the proper type of fluid and add it.
  • Replace the dipstick by repositioning the dipstick and cap.

Does a running Nissan Altima have to be checked for transmission fluid?

Start the engine of your car and let it idle for a while. To check the amount of your Nissan gearbox fluid, the engine needs to be warmed up. the dipstick for the transmission fluid.

Has a 2006 Nissan Altima has a dipstick for the transmission?

Locate the dipstick for the transmission, which is typically brightly colored and located behind the engine. While removing the dipstick, take care not to drop or spill any liquid. Like when checking the engine oil, wipe out the dipstick with a clean rag.

How is transmission fluid topped off?

Using a little funnel, top off the fluid levels through the dipstick tube. To avoid overfilling, add a bit at a time and check the level often.

Most gearbox dipsticks have a variation between low and full marks of around 1/2 liter (about 1 pint). Therefore, approximately 1 pint) is required if the reading is in the middle of them.

When topping off the fluid level on a cold engine, fill to 1/2 inch. Below the dipstick full mark, by (13 mm). If not, the temperature will be excessively high at operating temperature and overheating may result.

At specific defined mileages, several car manuals advise emptying and refilling automatic gears.

Draining them requires removing the gearbox sump and dipstick tube, which is a challenging and filthy task.

, a job requiring meticulously clean workspaces and garage facilities. In the owner’s manual or service manual, follow the manufacturer’s instructions.

There are drain plugs on the smaller automatic transmissions, and the fluid needs to be replaced according to the intervals suggested in the car manual.

When the engine oil is changed, those installed in BL automobiles that use the same oil as the engine receive new oil. Others, like those installed in some Volkswagen and Renault vehicles, have their own unique fluid supply.

While the fluid is still at its usual operating temperature, the transmission should be emptied. Be careful since it will be hot enough to result in severe burns.

Most of the time, draining requires lifting the car and carefully securing it to

Put the drain tray under the sump and remove the plug while avoiding getting hot oil on your hands and arms when it gushes out.

Replace the drain plug after the oil has been completely drained, then add new fluid or oil of the kind that the owner’s manual or service manual recommends.

Recheck the level and top it off if necessary after adding the recommended amount of fluid and driving the vehicle until the fresh fluid reaches the proper operating temperature.

Pouring the used fluid down the drain will contaminate the water supply. Find the closest oil disposal landfill by contacting your local authority, then transport the oil there.

Is a Nissan Altima from 2006 a CVT?

Making the best purchase option for you requires knowing everything about the potential new or used car you are considering. In addition to the engine type, many customers are curious about the transmission. You won’t have to look much further to learn whether a Nissan Altima is something you should think about. To ensure that you know what gearbox this well-known mid-sized automobile has, we did extensive study on it from a variety of authoritative sources.

The continuously variable gearbox, or CVT, is a feature of the Nissan Altima. In the early 2000s, this innovation was added to a few Nissan vehicles, and since 2007, CVT gearboxes have been available for the Altima. Since then, every Altima model year has included the CVT as standard equipment.

We’ll examine the various auto gearboxes now that we are aware that the Nissan Altima has a CVT transmission. You might also be curious as to when the CVT transmission was first installed in the Altima or how to detect whether another Nissan model has the same transmission design. How long do the Altima’s CVT transmissions last? What years did the Altima have issues with the CVT transmission? Continue reading to find out what our study has shown in order to get the answers to these and other questions.

Let us first state that we hope you find the links provided here beneficial before you continue reading. We may receive a commission if you buy something after clicking on one of the links on this page, so thank you!

Just add the transmission fluid, please.

  • Start the engine after parking the car on a flat area. Park or leave the car in neutral. If the owner’s manual for your car doesn’t specify differently, let the engine warm up and run all the way through operation. (Check the owner’s manual; be mindful that some automatic gearbox fluid levels are tested with the engine off.)
  • Where the transmission or transaxle meets the back of the engine is normally where you may find the automatic transmission fluid dipstick. It resembles an oil dipstick in appearance.
  • Look at the markings on the dipstick’s end. One warm and one cold marking for “full” may be present on your dipstick. You will need to add automatic transmission fluid if the level does not rise to the “warm” line.
  • Long funnel should be inserted into dipstick hole for automatic transmission fluid. Add automatic transmission fluid gradually, checking the level after each addition to ensure that it reaches the “warm” line. WARNING: A/T fluid should not be spilled or overfilled on hot engine components!
  • Fully reinstall the dipstick for the automatic transmission fluid. You’re finished!

Can I simply refuel the transmission?

You can refill the transmission fluid if necessary if the fluid’s quality is sound. Pour the fluid in gradually, using a funnel to prevent spills, and check the dipstick tube often until you reach the desired level. Make that the reservoir is not overfilled. Both having too little and too much fluid can be harmful.

Not sure what type of transmission fluid to use? You can choose from a variety of gearbox types, so check your owner’s handbook to learn what kind of fluid your car needs.

Your car’s transmission fluid is crucial to its effective operation. As a result, it must be replenished frequently. To make sure the fluid is in good condition, we advise you to perform a dipstick test at least once every month. You should also review the maintenance schedule suggested in your car’s manual.

Can I fill my own transmission fluid?

You can save time and money while changing transmission fluid if you use this transmission fluid pump.

Whether the manufacturer advises changing your automatic gearbox fluid after 30,000 or 100,000 miles, you should follow their advice. A transmission fluid replacement will extend its life expectancy by tens of thousands of miles, which is equivalent to years of service, and avert costly repairs in the future. To learn how to replace transmission fluid, continue reading.

You will pay between $149 and $199 for a transmission flush and fill at a shop. However, if you do it yourself, you can save approximately $100. A nasty, unsightly task, draining the old fluid has always been. This is due to the fact that it has required lying below the car, “dropping” the pan, and then being covered with liquid. However, there is a new method for changing fluid that doesn’t involve getting under the car and doesn’t spill a drop. Less than 30 minutes are needed for the operation.