What Size Wiper Blades For 2014 Nissan Frontier?

For your 2014 Nissan Frontier, we now offer 49 different wiper blade products, with prices starting at just $5.

24A*24″ Driver side wiper, filter

Windshield wiper blade for the 2014 Nissan Frontier; Bosch Focus 18-inch and 24-inch wiper blades; and Rain-X Silicone AdvantEdge 18-inch wiper blade

Which cars use wiper blades that are 21 inches long?

21-inch wiper blades fit most vehicles. Dodge Durango 2020-2001, Toyota Camry 2001-1992, Honda Civic 2005-2001, Jeep Grand Cherokee 2020-1999, Toyota Tacoma 2015-2005, Honda Pilot 2015-2003

Which car is compatible with a 28-inch wiper blade?

28-inch wiper blades fit most vehicles. Honda Civic 2015–2012, Hyundai Elantra 2016–2011, Toyota Sienna 2020–2011, Nissan Altima 2018–2007, Nissan Sentra 2019–2013, and Dodge Grand Caravan 2007–1996

How do I determine the size of windshield wiper I require?

Verify Your Manual The owner’s manual for your car should specify what size wiper blades you need for each side and might even suggest a particular brand. Before replacing the blades, check the vehicle’s manual carefully because some have varying size requirements for the driver and passenger sides.

Do you purchase wiper blades in two sizes?

Vehicle-specific wiper blades are used for windshields. On some cars, the size of both wiper blades is the same. The two wiper blades are different diameters on various automobiles. In order to clear as much of the windshield as possible, the manufacturer chooses the best-fitting wiper blade size. You will discover that one or both wiper blades will hang over the side or touch the top of the windshield trim while upright if you change your wiper blades with a larger size blade in an effort to clear more space on the windshield. Furthermore, if both windshield wipers are overly lengthy, they could bump into each other and harm the wiper motor, arms, and blades. When the wiper blade isn’t flush with the windshield, this will result in excessive wear on the wiper blades and areas that don’t get cleared.

You will discover that some parts of the windshield are not cleaned if you change your wipers with smaller-sized blades. And some of these locations can be essential for the car to run safely.

Only replace your wiper blades with those of the size recommended by the manufacturer after consulting your owner’s handbook. This will provide a good fit and guard against damage. If you cannot find your owner’s handbook, a blade size finder can be used to quickly determine the wiper blade size.

Can the wiper blade size be increased?

For the wiper blade upsizing trend that many of us think about, some simple physics applied to the windshield wiper blade does not provide encouraging results.

Consider the wiper assembly on any car. A spring attached to the wiper arm pushes the arm up against the windshield. The spring is a component that gives the wiper arm a steady force.

Let’s keep the strain in mind. This represents a point on the edge and a cross section of the edge. Source

This steady force is applied to the wiper blade assembly (the one with the rubber edge). Call it F for short. The blade is L in length. This force has a component that would be the pressure = F / L at each location on the edge that is in contact with the windshield ( Considering line contact for simplicity).

An application of elementary physics to a wiper blade. According to conventional wisdom, applying more pressure causes the edge to push against the windshield more firmly, which should result in superior wiping performance.

Upsizing results in less pressure being applied to the edge of the windshield. which should lead to both longer life and diminished performance.

The only justification for upsizing that I could think of was the improved sweep coverage, keeping comparisons apples to apples (same style of blade). Is it really more crucial than making a clean sweep? Therefore, why do we still upsize the wipers and why should we?

What GTO had to say about it was as follows:

I’ve always used OEM measurements. This looks to be a fix for an issue nobody had!

What BHPian Dr.AD had to say about it is as follows:

Your analysis is accurate, in my opinion. The pressure (or force per unit length in this example of linear contact) will drop as the wiper blade size increases, reducing the performance of the wiper while increasing the sweep area. However, increasing the sweep area can be tricky because modern cars have complicated windshield shapes. Attempting to do so may cause the two blades to interfere with one another (I have seen this happen on a few cars), or the blades may touch the edge of the windshield and make a loud thudding noise (I have seen this happening on a few cars too).

Frequently, there isn’t enough space all the way around the windshield to simply utilize a wider blade to increase the sweep area without causing any hindrance. Most automakers would have started with a larger blade if it was really possible.

The majority of OEMs make a tight fit based on the forms, sizes, and maximum coverage area without any interference of windshields, despite the complexity of wiper designs. When you try to muck something up, you frequently create needless issues that weren’t there to begin with.

What BHPian dhanushs have to say about it is as follows:

Water is removed off the windshield with a specified level of pressure. Any further pressure is essentially meaningless after that.

Every part of a car is manufactured with a certain degree of tolerance, and when we upgrade, we take use of that. Similar to how we exploit the driveshaft and gearbox torque rating tolerances when remapping, in this instance we exploit the spring stiffness to extend the wiping area.

Therefore, if you can increase the wiping area of a blade without compromising the functionality of other blades or wind shield beadings, do so.

Do 22 inch wiper blades work?

My current wipers had failed while I was in the midst of a long journey and in the pouring rain. I quickly bought a new set of wipers, but the seller gave me the incorrect size.

It should be 24-inch and 16-inch for the Hyundai Verna Fluidic, but he put 22-inch and 17-inch (Minda). He also said that I had been using the incorrect size earlier.

I didn’t realize he had given me the wrong size until I got home and looked up the specifications online.

Just curious, what damage might these wipers cause to the windshield of the automobile (apart from the 22 “a 17-inch wiper would cover more ground than a 16-inch wiper, and a 24-inch blade would cover less ground)?

What BHPian self driven has to say about it is as follows:

Almost nothing. It won’t be a problem going from 24″ to 22″, as the latter is obviously shorter. If it had been the other way around, there might have been an issue. Again, the difference between 16″ and 17″ is too slight to cause any problems.

There is no need to replace wipers if they are operating smoothly without rubbing against one another.

What BHPian abhishek46 has to say about it is as follows:

Return to the original configuration if it is significantly less than it was originally and is obstructing your field of vision.

Using 22″ instead of 24″ won’t cause any harm. You will only experience reduced wiping area. But there is no cause for concern.

The only possibility for the second 17″ wiper in place of the 16″ wiper is that the increases 1 “The other wiper or the windshield’s margins may be hampered by length. If that is taking place, you will be able to tell by loud noises and a jerky movement of the wiper. You are alright and need not worry if this interference does not occur.

In conclusion, choosing the incorrect wiper size is not a good idea, but it won’t result in any immediate or significant harm that you should be concerned about.

What occurs if the wiper blades are too large?

Finding the right replacement wipers when your current ones are worn, brittle, and need to be replaced may occasionally be a difficult chore.

You might have forgotten the brand, size, or fitting you needed after a year or two.

Fortunately, we have one of the best wiper bulb finders in the UK that you can use to quickly locate the appropriate wiper blades for your car.

To get the ideal blades for you, simply enter your registration number or the make, model, and year of your car.

The “Wiper Blades” tab must be chosen on the following page after you land there.

Then, our blade discovery tool will provide you a number of options to select from while outlining just the blade you need for each application. According to the information we have about your car, the drivers’ side may be 24 inches and the passengers’ side may be 17 inches.

To get the most clearance for when it rains, make sure to purchase wiper blades that are the proper size and the closest size to your original wiper blades.

Size does matter, but only to the extent that you are around an inch larger or smaller than the size of your current wiper blades. If you purchase wiper blades that are too large, they could overlap or touch and break.

Some producers choose not to make specific sizes of wiper blades due to a lack of demand from automakers.

For instance, buying a 16″ or 18″ wiper blade is perfectly acceptable because Bosch does not produce 17″ wiper blades. The influence on the size difference will be minimal because there will only be a half-inch variation on either side.

Your wiper arms and the way that connection fits into the blades will be entirely responsible for this.

Remove your current wiper blade from the wiper arm and check the connection to make sure it is installed correctly.

A great pair from Bosch should accommodate almost all of your wiper blade fittings. Anything marked as “Multi-Clip” will have 4 adaptors, making it more adaptable to a larger range of vehicles.

Simply attach the wiper blade arm and the necessary adaptor by placing the adaptor on the wiper blade arm.

Your car’s rear wiper blade is unique, therefore it can be challenging to find the proper replacement.

To determine the size wiper blade you require, it is advisable to utilize our wiper blade finder or consult your vehicle’s manual.

If such data isn’t available, try removing the current rear wiper blade, taking a picture of it, and emailing it. You will be able to get help from one of our highly qualified staff members as soon as possible.

What happens if I use windshield wipers that are the incorrect size?

If you install wiper blades on your car that are longer than what is advised, the wipers may collide and harm the wiper motor or the blades themselves. Additionally, a blade that is too large could not adequately fit the window’s design, leading to visibility loss and uncleared areas. Or the windshield trim may be struck by the blade.

Loss of visibility results from blades that are too narrow for the car to clear the entire windscreen. Always use wiper blades that are the proper size for your vehicle’s make, model, and year.