When the tire pressure light blinks three times, release pressure on the TPMS reset button. Start the car and let it run for 20 minutes to let the sensor reset. Under the steering wheel is typically where you’ll find the reset button for the tire pressure monitor. If you still can’t find it, look in the owner’s manual of your car.
In This Article...
Nissan, where is the TPMS reset button?
There is a TPMS reset button, which you can press. The specific placement is specified in your owner’s manual, however it is typically found underneath the steering wheel. By turning your keys to the “on” position while keeping your engine off, you can operate this. Hold the button down until three flashes of the TPMS light appear.
In what location on a 2009 Nissan Maxima is the TPMS button?
- OBD module application to the DLC
- Remove the OBD module from the DLC.
- Make that the TPMS sensors are placed correctly.
- Hold the TPMS tool on the sidewall of the valve stem of the left front tire.
- Switch the ignition on and off.
- For up to 20 minutes, drive
- To transfer sensor data to the ECU, press OK on the TPMS tool.
- Set tire pressures according to the placard value.
- ON the ignition
- A OBDII dongle is necessary.
- Repeat for the left rear, left front, and right rear tires.
The OBD procedure is described in the videos below on several Nissan models, but it also applies to the Nissan Maxima.
How is the check tire pressure light reset?
While the car is off, disconnect the positive battery cable. To release the last of the power, start the automobile and press the horn for three seconds. The tire pressure light should turn off after you reconnect the battery. All tires, including the spare, should be 3 PSI overinflated before being entirely deflated.
Why are my tires fine but my TPMS light is on?
It’s likely that one or more of your tires have low air pressure if you see the tire pressure indicator turn on. However, even if your tires are in good condition, there are a number of things that could cause the sensors to go off, so you shouldn’t rely only on the data from the tire pressure monitoring system of your car.
We’ve talked about some additional aspects of automobile maintenance in this piece. Read these articles if you have some time:
On a 2009 Nissan Altima, how do you reset the tire pressure light?
This is what? Front left tire comes first, followed by front right, rear right, then rear left tires. To reset the TPMS light after completing this process, drive for ten or more minutes at 16 mph or faster. This will fix the Nissan Altima TPMS fault.
How much does it cost to repair a TPMS sensor?
Replacement of a TPMS sensor typically costs between $208 and $250. Between $55 and $69 is the expected range for labor costs, while $153 to $181 is the range for part costs. Taxes and other costs are not included in this range, nor are your particular vehicle or geographic area taken into account. There might be more repairs required.
What does 2016 Nissan Maxima tire maintenance entail?
When your Nissan’s tire maintenance light comes on, it’s time to rotate the tires as part of your normal maintenance program. (This warning light has nothing to do with tire pressure.) Fortunately, there is no need to be alarmed by the tire maintenance light.
Should the TPMS be reset after purchasing new tires?
After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.
Can the tire pressure monitoring system be turned off?
On the gauge cluster of your car’s dashboard, a horseshoe-shaped emblem with an exclamation point lights when your tire is underinflated. The tire pressure monitoring system is the piece of equipment that generates this signal (TPMS).
Sensors provide the TPMS with data on the air pressure level. The air pressure sensors inside your tires or the anti-lock brake system’s wheel speed sensors may be used by your car’s TPMS, depending on the model.
What malfunctions the tire pressure sensor?
A problem with the tire pressure monitoring system is indicated by the message “Tire Pressure Sensor Fault” (TPMS). Most likely, a tire pressure sensor or the connection to the sensor has a problem.
The air pressure in the tires may be too low or high, or one of the tire pressure sensors may be broken, according to the error code.
Incorrect wiring, a malfunctioning TPMS control unit, or a TPMS reset could potentially be at blame. The quickest approach to learn is to use an OBD2 scanner to read the fault codes from your TPMS control unit.
AutoZone is able to check TPMS sensors.
You can determine if your tire pressure monitoring system is corroding or failing within your wheel with routine inspection; if so, you will need to replace it. Every tire pressure monitoring system item you require for your repair is available at AutoZone, guaranteeing that you can drive again efficiently and safely.
I have a low tire pressure light on. Can I drive?
You should be able to continue driving safely for a few more miles until you can add air if your tire pressure is only slightly low. Extremely low tire pressure can cause tires to fail. A blowout could happen from this, which is quite risky. Additionally, you’ll have poor traction and your automobile won’t be able to adequately cushion the effects of the road. This is quite risky when it’s raining or snowing since your tires won’t be able to obtain a good grip on the road when you’re driving and making turns.
You should not disregard the tire pressure light because it is intended to notify you to an air pressure problem. You run the danger of getting a flat tire if you don’t check the air. A blowout can have major consequences that could endanger your safety, the safety of your passengers, and the safety of other road users. As soon as you can, stop at a gas station and top off the tires’ air pressure till it is appropriate. It offers the best protection against excessive tread wear and potential accidents.
How much does resetting a TPMS cost?
On most automobiles, the service kit ranges from $5 to $10 per wheel. To examine and reset the sensor system, you also need a special TPMS tool and more time. Depending on the type of car, pressure sensors can be replaced for between $50 and $250 each.
What does a tire pressure light that is solid mean?
It usually indicates that one or more tires need to be inflated to the recommended placard pressure if the TPMS warning light glows solidly and stays solid.
The TPMS system, however, is malfunctioning if a light flashes for 60–90 seconds before going solid. Most likely, there is a communication problem between the vehicle and one or more of the sensors. Many different problems may be the root of this. The sensor may need to be changed if it is broken, missing, or has a dead battery, according to the flashing light. It can also imply that the tire’s sensor is placed incorrectly.
You must investigate these potential problems until you identify the source if you want to ensure that you service the TPMS systems correctly.
When your customer visits for servicing, bear in mind the following extra advice:
Every time a customer’s car pulls into your service bay, check the Telltale/MIL and note the presence of any lit or blinking lights before starting any work.
Visually check the stems, hex nut, seal, and cap while servicing the TPMS. Replace with a fresh service kit is the advised best practice.
Whether or not there is a chance for a sale, always let the customer know the advantages of TPMS.
On a Nissan Sentra, where is the TPMS button located?
Depending on the year of manufacturing, you can find the TPMS reset button under the left side of the dashboard or under the steering wheel. Please follow the detailed procedures below to perform a reset.
How To Reset the TPMS on a Nissan Sentra 2007-2019?
Follow these simple instructions to reset the tire pressure monitoring light if your Nissan Sentra was manufactured between 2007 and 2019:
- Make sure the car is stopped and the engine is off.
- Make that the tire pressure is set properly in each tire. Make careful to verify the tire pressure in the manual or on the door panel.
- It is advised that you drive the vehicle to calibrate the monitoring system at a speed between 16 and 25 mph when this is finished.
Congratulations if you find that this works. If not, you must undertake the following instructions at your own risk or with the help of an auto expert, who may charge a fee.
- Verify that the tire pressure is at the proper PSI.
- Finding the TPMS interface plug is the next step. This can be found in your car under the dashboard. The OBD II wire loom should be connected to the white female plug. You might need to cut the plug off if it is taped in place.
- You must insert a paper clip or wire into the interface once you have located the right plug.
- Make sure to not start your engine after turning on the ignition.
- You must tap the ground six times with the paper clip or any other metal you used.
- Your management light will begin to blink if the connections mentioned above are secure.
- You need to understand that the light is blinking slowly. You may need to check the plug’s connection and repeat the following steps if it is flashing rapidly.
- Once you are certain that the light is flashing slowly, you should resume driving the vehicle between the speeds of 16 and 25 mph. By doing so, the internal computer’s calibration and adjustment will begin.
- Only if your tires have low pressure will the light turn back on. Check the condition of your tires and reflate them according to the recommended specifications.