You must restart the tire pressure monitoring system after adjusting the tire pressure or rotation (TPMS). The 2016 2017 2018 2019 2020 2021 Mitsubishi Mirage’s tire pressure warning light can be reset as follows:
In This Article...
Verify that the car is totally stopped
Put the gearshift lever in the N position (M/T) or the P position (A/T) while using the hand brake.
- Always adjust the tire pressure as directed by the tire placard.
- Without starting the engine, turn the ignition to the ON position.
Press the Engine Start/Stop button twice without touching the brake pedal if your car has one.
- TPMS SET will appear on the cluster display after several presses of the INFO button.
- In order to perform the TPMS reset, press and hold the INFO button.
Press the button until a buzzer sounds and a slow flashing warning light appears.
Drive your vehicle until the warning light turns off after starting the engine.
The TPMS reset button is where?
Tire pressure monitoring system is referred to as TPMS. The TPMS reset button is often located below the steering wheel. Your car’s TPMS needs to be electronically reset after you replace the tires in order to erase the error message. Hold the TPMS reset button down until the tire pressure light blinks three times, then let go of the button to complete the process. Your car should be started, and the sensor will refresh after 20 minutes.
Why are my tires full but my tire light is on?
It’s likely that one or more of your tires have low air pressure if you see the tire pressure indicator turn on. However, even if your tires are in good condition, there are a number of things that could cause the sensors to go off, so you shouldn’t rely only on the data from the tire pressure monitoring system of your car.
We’ve talked about some additional aspects of automobile maintenance in this piece. Read these articles if you have some time:
Why, after filling the tires, is the tire pressure light still on?
If you’ve inflated your tires, but the air pressure warning light continues to flash, your tire pressure monitoring system is malfunctioning or you have a gradual leak. A bright TPMS warning light indicates a problem with a tire pressure sensor, assuming there isn’t a leak in your tire. One of them might be damaged, the lithium-ion battery might be dead, or the TPMS itself might have an internal problem. You’ll need to get your Tire Pressure Monitoring System repaired in any of these scenarios.
Quick Tip: Recheck the tire to ensure it is inflated to the correct air pressure if the TPMS warning light illuminates again after you have inflated it. Low tire pressure indicates an air leak, which requires repair or tire replacement.
Where are TPMS installed?
In the US, direct TPMS usage is more prevalent. The sensors are either housed in the tire pressure valve, which also serves as an antenna, or they are band-clamped to the wheel rim. These gadgets deliver the data to an on-board computer.
Should the TPMS be reset after purchasing new tires?
After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.
How to reset your TPMS after tire service can be found in your vehicle’s manual or by asking your neighborhood Midas mechanic.
- Visual inspections of the brakes, battery, air filter, fluids, belts, and hoses are all included in the Midas Touch Courtesy Check.
Why won’t the tire pressure warning light come on?
Try the following if your TPMS light is still on after you have inflated your tires to the recommended pressure: 10 minutes at a speed of 50 mph would be plenty. When you start the car again, the TPMS light ought to be off because this ought to reset the tire sensors.