You can either use a battery charger, drive or idle for at least 20 minutes to charge the battery, or receive a jump start from another vehicle.
- You will need jumper cables and a car whose battery is not dead in order to jump-start your vehicle.
- Find a driver whose car’s battery is still good. Check to see if they have jumper cables. Find someone with jumper cables if they don’t.
- Place a working vehicle with a booster battery next to the vehicle with a dead battery, being careful to keep the two vehicles apart.
- Make that the booster battery is 12-volts and has the grounding wire attached to the negative terminal.
- Unnecessary electrical loads should be turned off.
- Remove the service cover from the engine compartment’s front passenger seat side by opening the engine hood.
- The make and model of your car determines how easily you can access your battery. Some might even be hidden behind the seats or in the boot.
- Take off the fuse box lid. Open the negative terminal cap near the car body and the positive terminal cap within the engine room fuse box.
- Connect the positive end of the discharged battery to the red, positive clamped end of a jumper cable.
- Connect the other end (red positive clamp) to the booster battery’s positive terminal.
- The other jumper cable’s (black, negative clamp) other end should be connected to the negative terminal of the booster battery, and the other end should be connected to a stationary, solid metallic object far from the battery.
- Start the engine of the working vehicle and let it run for a few seconds to start charging the dead vehicle’s battery with the jumper cables.
- When the dead car starts, unplug the jumper wires in the opposite order (first the black, negative clamps, then the red, positive clamps), being careful to avoid touching the clamps.
- To build up the charge, take a little drive or leave it idle for at least 20 minutes.
To charge your battery, adhere to the simple directions below:
- Make sure you turn off the battery charger.
- Connect the charger’s positive and negative cables to the appropriate ends of the battery.
- Turn on the charger when it is charging at its slowest rate, and then set the timer. It should take 6 to 12 hours to fully charge, depending on the battery voltage and cold cranking amps (CCA).
- After finishing, switch off the main battery charger.
- Negative and positive clamps should be disconnected from the corresponding battery terminals in that order.
In This Article...
How can a Kia vehicle be jumpstarted?
Connect the red clamp to the dead battery’s positive post. Hook the other red clamp to the positive terminal of the charged battery after uncoiling the battery line. Connect the black clamp to the good battery’s negative post.
Why won’t my Kia Sportage crank over?
Are you experiencing difficulties starting your Kia Sportage? When you turn the key in your automobile and nothing occurs, it is a frustrating experience. You are aware that you have fuel, so what’s going on? Your Kia Sportage probably won’t start due to one of numerous potential reasons.
We will go through some of the most typical causes of your Kia Sportage not starting in this blog post, along with solutions. We’ll also provide you some useful pointers for maintaining your Sportage in good working order.
The most frequent causes of a Kia Sportage not starting are a dead battery, an alternator issue, or a faulty starter.
Tip #2:
When jumpstarting your car, be careful to adhere to the owner’s manual’s directions. Every automobile is unique. Believe us. We’re experts.
Attention: Under no circumstances should you attempt to connect any unsecured wires. Leave the dangerous stuff to us unless you are a trained technician. It’s incredibly simple to short out pricey computer components and put yourself in danger if the wiring is handled improperly.
What is the proper method for connecting jumper cables?
Once the two cars are in position, switch them both off and raise the hoods. First, connect the red jumper cables. One red cable should be clamped to the positive side of the battery that won’t start to begin with. Then, secure the other red clamp to the working battery’s positive side.
Next, secure a single black cable to the functional battery’s negative terminal. Don’t connect the other black clamp to the dead battery when you’re ready to attach it. Instead, look for a metal piece in the engine block of your car where you may securely fasten it.
How can a 2016 Kia Sportage be jumpstarted?
How to Jumpstart a Kia Sportage EX 2.4L 4 Cyl., 20112016
- Access the battery to find out where it is.
- Jump Points: Find the ground and the positive terminal.
- Jumping Procedure: After properly connecting the jumper cables, jump.
- Replace the lid, being sure to do so correctly.
When jumping, which battery terminal should you attach first?
All you need to jump start a dead battery is another car, some cables, and a dead battery to jump start it. In case you or someone else needs a jump, it is recommended to maintain a pair of cables with you at all times in your car. Here’s how you jump your automobile once you have both of these ready to go:
Bring the Engines Close
- First, get the running car engine as close to yours as possible. While parking parallel to your automobile or facing it is acceptable, it is preferable for the two engines to be no more than two feet apart.
Connect Positive to Positive:
- Start by attaching the jumper cables’ positive (typically red) clamps to the positive terminals of your battery. Although frequently indicated, these can be challenging to see. Make sure you are connecting to the correct area of the battery by paying great attention.
Connect Negative to Negative:
- Connect the jumper cable’s negative (typically black) clamps to the live battery’s negative terminal. Attach the negative terminal to an unpainted metal surface in your car.
Safety First:
- Keep in mind that you should always connect the dead battery first when connecting the positive connections to the batteries. You run the risk of creating a safety issue if you power the cables before they are attached to your battery. It’s crucial to contact for professional assistance if you ever feel uncertain or insecure rather than putting your safety at danger.
Disconnect the Cables:
- Reverse the order in which the cables were installed in the vehicles and carefully remove them. Disconnect your car’s negative cable first, then the other car’s negative cable, your car’s positive cable, and then the positive cable from the other car.
Remember that when you’re driving, your battery charges. Consider taking the long route to your destination after starting your car to allow your battery the time it needs to recharge. This initial dead battery is an indication that you need a replacement even if your battery jumps and recharges. As soon as possible, take your car to a nearby repair.
How can I jump-start a dead battery in my car?
- Place the vehicle you’ll be using for a jumpstart next to the vehicle with a dead battery, close enough for the cables to reach. The cars shouldn’t be in contact with one another.
- Switch off the engines of both vehicles.
- Clamp the positive cable’s first end to the positive clamp on the dead battery.
- Now have a buddy attach the other end of that cable to the positive clamp of the other battery.
- Next, attach the negative cable to the good battery’s negative terminal.
- The other end of the negative line should then be connected to a ground on the car that has the dead battery. The engine block or similar metal surface far from the battery can serve as this. While doing this, take care not to touch the cable’s two ends together.
- Launch the emergency vehicle that is supplying the electricity.
- With the weak battery, start the vehicle. Check your connections and tighten or clean them as necessary if it won’t start.
- If the problem vehicle does manage to start, let it run for at least 20 minutes to give the battery time to recharge before turning it off.
- If it still won’t start, there might be an additional issue. For assistance, dial a nearby service station.
- Reverse the order of the cables’ disconnection.
How do I charge the battery in my car?
Observe the directions for the charger you have. The most common chargers’ basic instructions are as follows:
Connect the charger’s positive cable to the battery’s positive terminal.
Connect the charger’s negative cable to the battery’s negative terminal.
First switch off the charger before removing the positive and negative cables.
How long does the battery last on a Kia Sportage?
The normal battery life of a 2020 Kia Sportage is 3 to 5 years, although actual battery life might vary greatly depending on driving behavior, weather, and battery type.
It might be a battery or alternator problem.
When trying to start your car, a loud clicking sound may indicate an issue with the electrical system. It’s possible that your battery is dead or that the alternator, which charges the battery, is malfunctioning.
The starter, a small motor powered by the battery that starts the engine, is unable to maintain power if the clicking noise is electrical in origin. Instead, it makes a clicking sound and switches on and off quickly.
Remember that in situations like this, a starter that doesn’t work properly is only a sign of the problem. Your automobile’s electrical system is probably to blame, which is why a jumpstart could briefly move your car.
Once it’s operating, have an experienced technician inspect the entire electrical system. Your alternator or battery might need to be replaced. Alternately, the issue might be resolved by simply cleaning the battery terminals of corrosion to improve the battery’s connection.
You’re not the only one having issues with your automobile battery. According to AAA, among the top three reasons members call for roadside assistance are battery issues, with the majority of those calls occurring in the summer.
With a Courtesy Check and free battery test* at Firestone Complete Auto Care, you can prevent a failed battery or an electrical problem.
No battery is included.