If the system notices a decline in psi, the flat tire warning light on your dashboard will turn on.
It is crucial that you pull over as soon as this light illuminates on your dashboard to examine your tires for any holes or deflation. If you wait until the light is on as a maintenance reminder, it may cause hazardous driving conditions.
Driving on a flat tire is risky since it increases the tire’s internal structural deterioration, which can result in poor handling, accidents, and even damage to the rims and suspension.
1) If your Q50 has a Smart Key Button, push the start button twice without touching the brake pedal. Turn the key to start the ignition but do not fully start the engine.
2) Press the Menu button on the center console. The Menu button is next to the screen panel in the bottom row.
3) Choose the Settings Menu – From the touchscreen, choose the settings menu.
4) Choose Meter from the list of menus that show on the screen.
5) Choose Maintenance – Once more, a number of selections will show up.
6) Choose Tire. From here, you can reset the one that is now shown in your car and create reminders for intervals of time.
Keep in mind that you should always check your car’s tires on a frequent basis, especially before any lengthy trips, as your car won’t prompt you to do so as often as necessary if the gap between reminders is increased.
If your car has just undergone maintenance, the mechanic will probably take care of this for you, but now that you know how, you’ll be prepared if this problem ever occurs.
In This Article...
How can I reset the flat tire on my INFINITI Q50?
It’s quite simple to reset the flat tire alert on Your INFINITIQ50. You won’t need to spend more than 10 to 15 minutes on it. The first thing you must do is unlock the door on the driver’s side and enter the car. The ignition should now be in the on position. Always be careful not to actually start the engine when doing this. Locate and press the TPMS, or tire pressure monitoring system, button. Hold the button down until three consecutive flashes of light are seen. Start the engine of Your car at this point. The alarm should be reset after waiting between 22 and 25 minutes before attempting to drive.
Click the “On” switch to turn off the INFINITI Q50 flat tire alert without starting the car. When the light pulses three times, click the TPMS reset button and hold it there until you can unlock it. Turn on the engine and give the sensor 20 minutes to run. The tire pressure control reset button is often located under the steering wheel.
How do I reset my flat tire light? wouldn’t be a question if we were aware that there was a TPMS Reset Button and where it was. If someone asks how to change a flat tire, telling them it’s simple—just replace the flat tire with a tire that isn’t flat—is about as helpful as telling them to hit the tire reset button without explaining where it is. Please provide a detailed response that includes both what to do and where to do it, step by step.
The screen’s rpm button serves as the only button on the newer Q50. A light will blink on your dash if you select Settings, then Meter, and then just keep the TPMs option pushed.
I’ve really looked under the steering wheel, but I can’t find the reset button.
This solution is not available online. Every website I’ve looked at just says to press the button without ever mentioning where the f**king thing is, so apparently it’s some type of secret.
A trip to the dealer is necessary to reset the flat tire warning. For some reason, they had to connect the automobile to reset. Only because I had to have it done twice do I know.
A scan tool is required to reset infinity. Dealer will do it at no cost. I left $2 for the service department employee. Spend no time messing around with the dash’s buttons and display.
After having a run-flat tire fixed there, I returned my Q50 to Discount Tire. In just a few minutes, they were able to reset the car’s computer using a hand-held electrical gadget.
This short tutorial will show you how to reset the flat tire warning.
1. Start by turning the ignition on in your Q50.
2. Next, once the Tire Pressure Monitoring System (TPMS) light illuminates, press and hold the “Trip” button on the steering wheel of your Q50.
3. After the TPMS light turns on, push and hold the “Trip” button while waiting for the light to flash. This will show that you are currently resetting the system.
4. When the TPMS light turns solid, press and hold the “Trip” button one more. The flat tire warning system on your Q50 is now working, indicating that the reset is finished.
5. If you have any queries about how to reset the flat tire warning system on your Q50, make sure to refer to your owner’s manual or get in touch with an experienced auto specialist.
Person Name
I replaced all of my tires with Michelin Pilot Sport after getting a flat. I continue to receive a red tire alert on the dash and tire pressure screen. Can you reset this without going to Infiniti? The idea that I would have to drive 40 minutes to the dealer for a reset irritates me much.
As long as your vehicle is still covered by warranty, taking it to the shop is your best option.
You could have just driven to the dealership and given them the opportunity to fix it instead of spending more than 40 minutes trying to figure it out.
Infiniti Q50 Maintenance Tire Rotation Light: Tire Reset (2014-2021)
Tire Resetting: Infiniti Q50 Upkeep Light for Tire Rotation (2014-2021) The Infiniti Q50 is a mid-range passenger automobile that has been in production since the spring of 2013 and is the G37’s replacement. At the Detroit Auto Show in January 2013, the car made its public debut.
The first Infiniti to receive the new designation, which consists of a Q and a two-digit production number, is the Q50. The entire model line was given a new nomenclature by Infiniti when the Q50 was introduced in 2013.
Answers
I tried ODBII, but I couldn’t locate any failure codes. When I received another low battery warning, it was resolved.
I filled the tank with fuel without turning off the vehicle (not recommended). The tire-flat warning
I’m not sure if it’s a correlation or a cause-and-effect relationship, but it just so happened to work. Hoping that
Recently, this happened to my wife’s Q50. After being driven for about a week, it reset on its own.
A few days ago, I had a “run flat” tire repaired, and I returned it to Discount Tire after the
not clear on the computer. They possess a hand-held, plugged-in portable electronic device.
In less than 5 minutes, the problem was resolved under the driver’s side dashboard.
On a 2016 Infiniti Q50, how do you turn off the flat tire warning?
Without OBD2, you can reset the flat tire. Reduce the pressure in the troubled tire to the minimum amount advised. Without starting the engine, turn the ignition to the “on” position. When the tire is inflated to the necessary pressure, the automobile will blow its horn to let you know. Inflate the tire that is malfunctioning. Simply keep your speed above 16 mph and the notice will soon disappear. That’s how I eventually made mine disappear. 2016 Q50 Silver Sport that I own.
How is a Q50 flat tire warning reset?
Tire Pressure Warning Light 1) Press the start button twice on your Q50’s Smart Key Button to turn the ignition on without fully starting the engine. Avoid pressing the brake pedal.
On an Infiniti, how do you reset the tire-pressure warning light?
When the tire pressure light blinks three times, release pressure on the TPMS reset button. For the sensors to reset, start the car and let it run for 20 minutes. The button to reset the tire pressure monitor is under the steering wheel.
How can I check the tire pressure on my Infiniti?
- You must first measure each tire in order to set the tire pressure correctly.
- Remove the valve caps from each tire, then push the pressure gauge on the valve stem.
- Make sure you hold on firmly and securely, and the tool should display the pressure right now.
Where is the reset button for tire pressure?
Under the steering wheel is typically where you’ll find the TPMS reset button. Consult the owner’s manual for your car if you can’t find it. All tires should be inflated to 3 PSI more than what is suggested, then completely deflated. Include the spare tire as well, as it can feature a sensor.
Why, Infiniti, does my tire pressure light remain on even when I fill my tires?
If you’ve inflated your tires, but the air pressure warning light continues to flash, your tire pressure monitoring system is malfunctioning or you have a gradual leak. A bright TPMS warning light indicates a problem with a tire pressure sensor, assuming there isn’t a leak in your tire. One of them might be damaged, the lithium-ion battery might be dead, or the TPMS itself might have an internal problem. You’ll need to get your Tire Pressure Monitoring System repaired in any of these scenarios.
Quick Tip: Recheck the tire to ensure it is inflated to the correct air pressure if the TPMS warning light illuminates again after you have inflated it. Low tire pressure indicates an air leak, which requires repair or tire replacement.
What tires are included with the Infiniti Q50?
Regular tire sizes for the Infiniti Q50 are 225/55R17 tires, 225/50R18 tires, and 245/40/19 tires. Sporty all-season tires, like the Bridgestone Potenza RE97 A/S, are usually fitted to your Q50.
Is a spare tire included with the Infiniti Q50?
You’re already aware that your Q50 lacks a spare tire. Like many automakers, Infiniti does not offer this crucial lifesaving feature. Modern Spare aspires to unquestionably be the top manufacturer and supplier of full spare tire kits. We have considered every factor when creating our Modern Spare designs.
After a tire rotation, does the TPMS need to be reset?
These sensors measure the air pressure and transmit the information to the dashboard of your car. The batteries can last up to 10 years, and there is no need to reset them after rotating tires or making inflation changes. They provide precise pressure readings.
How can I disable the tire pressure indicator?
- Don’t start the car; just turn the key to “on.”
- While the car is off, disconnect the positive battery cable.
- All tires, including the spare, should be 3 PSI overinflated before being entirely deflated.
- Bring your car to our service center for qualified help.
Should the TPMS be reset after purchasing new tires?
After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.
Why are my tires full but my tire light is on?
It’s likely that one or more of your tires have low air pressure if you see the tire pressure indicator turn on. However, even if your tires are in good condition, there are a number of things that could cause the sensors to go off, so you shouldn’t rely only on the data from the tire pressure monitoring system of your car.