A dead battery, an alternator issue, or a bad starter are the three most frequent causes of a Hyundai Elantra not starting.
In This Article...
Your Elantra Won’t Start in Two Ways
There are often two main reasons why a car, like a Hyundai Elantra, won’t start. The vehicle won’t start, which is the first sign. In other words, after you turn the key, the Elantra’s engine won’t start. The second reason your Hyundai Elantra won’t start is that after the engine starts turning when the starter is engaged, it will not ignite and continue to run on its own. What about that annoying clicking sound, though?
It should always serve as a caution to you that there is a problem if you hear an unusual car sound. If your automobile won’t start when you try to start it, there are many potential causes for this bothersome clicking sound. Once the engine is turned on, your Elantra needs a boosting thrust from the flywheel of the car. The starter motor of the vehicle controls the flywheel. Everything we have said is powered by the battery in your car. Therefore, as you try to start your car but all you hear is clicking, you consider a number of potential causes. Let’s look at a few of them.
In the morning, the engine rotates but won’t start.
The cold morning can’t get my car to start. Engine spins but doesn’t ignite. I reasoned that the issue might have to do with the oil pressure sensor connector since when I spray WD40 on all of the connectors for the air flow, oil pressure, and other components, the issue starts, but it returns after a short while.
Must maintain the oil at a specific temperature; otherwise, the oil won’t reach the block. Spraying WD40 heats up those connections to allow for easy movement. My recommendation is to use a Benson burner or perhaps thicker oil during the winter months to prevent freezing. oil change for the season, haha. Additionally, this lessens the risk of the oil and sludge burning.
Hyundai’s Push-Button Start Issue Is Still Present
Is your Hyundai’s push-button start malfunctioning? Have you been left stranded by your Hyundai’s keyless start issues because it won’t start?
We routinely write about the problems Hyundai drivers face, including vehicle alignment problems and transmission problems.
A new issue with the Hyundai push button start is already approaching.
People who are been left stranded by the Hyundai push button start issue are flooding the message boards in droves.
The problem is caused by the brake pedal sensor failing. A driver should ideally depress the button while keeping their foot on the brake. The Hyundai should start without a hitch as long as it detects a key fob nearby (in a pocket or handbag). However, it appears that the brake pedal’s sensor is broken. Due to the car’s inability to recognize that the driver has their foot on the accelerator, it won’t start.
Many of the drivers we are aware of are returning to their Hyundai dealer on a frequent basis to address this issue, and some people have been informed there is no cure because it is intermittent. Some people have been told that the issue would resolve itself. This is not true.
We think that because the manufacturer has not yet found a suitable solution, many more Hyundai drivers may experience the push-button start issue in the future. Numerous drivers can end up stranded in driveways, parking lots, and petrol stations as a result of this problem.
It’s crucial to maintain track of your repair bills if you’re experiencing Hyundai push-button start issues and to continue receiving warranty service until the problem is fixed. If you discover that you have visited the shop numerous times to address the issue, research your rights under state lemon laws (including those in New York and New Jersey) and federal warranty regulations, and then get in touch with a lemon law attorney in your state who might be able to help.
Rickthestick25
Hello, I’m aware that this article is old, but my 2018 Elantra GT has begun experiencing the same problem. According to the study I’ve done, a bad brake sensor is to blame. Although it is bothersome, you may disable the braking sensor by pressing the start button once, then holding it for another 30 seconds. Ensure that the door on the driver’s side is shut. I was really almost 1500 miles from home the first time I got lost!
I can’t get my Hyundai Elantra to start.
Press and hold the remote start button for four seconds after pushing the lock button. The button must be depressed for at least two seconds. A
After itas successfully receives the command, the car should start and the parking lights should flash.
The Hyundai will run for 15 minutes before turning off automatically. If you intend to use your remote start feature, you might want to make sure the temperature is set where you want it beforehand because the climate control will operate at whatever setting it was on previously. A A
How much does a Hyundai Elantra starter cost?
Estimated cost to replace the starter on a Hyundai Elantra. Replacement starters for Hyundai Elantras typically cost between $427 and $498. While parts are priced between $346 and $396, labor costs are expected to be between $80 and $102
Why won’t my car start even though the battery is fine?
If your car’s battery is in good condition but it still won’t start, there may be a problem with the fuel or ignition systems. Insufficient gasoline, a bad starter, a bad ignition switch, a blocked fuel filter, a poor fuel pump, a worn timing belt, or a weak ignition coil are a few more typical causes.
Be sure to try one of the straightforward solutions described above to get your car started and on the road to the mechanic, even though a jumpstart is not a cure for any of these problems and some of them are probably going to require an expensive repair!
My car won’t start, but the battery is fine. Why?
Your starter may be the issue if the battery appears to be in good condition. A starter is a little motor that uses battery power to pull current in order to start an engine. When you turn the key in the ignition, you can hear a clicking sound if the starter fails or malfunctions. In some cases, loose connections are the issue, while in others, a new starter may be required. There is no assurance that jumping a car will fix starter issues.
A Hyundai Elantra battery cost?
A Hyundai Elantra battery replacement typically costs between $299 and $306. While parts are priced at $272, labor costs are predicted to be between $27 and $34.
Do Hyundai Elantras have a recall?
There is a recall on some 2022 Elantra N and 2022–2023 Elantra automobiles from Hyundai Motor America (Hyundai). It’s possible that the insignia on the driver’s front air bag cover wasn’t correctly welded, which could cause the emblem to come loose during deployment.
An air bag cover insignia that has come loose could hit a car occupant, increasing the possibility of injury.
The air bag will be replaced at no cost by the dealer. On October 17, 2022, owner notice letters are anticipated to be mailed. Customers of Hyundai can reach them at 1-855-371-9460. The Hyundai recall number is 234.
When your car won’t start but the battery is still functional, what does it mean?
The car may not start even when it clicks when attempting to start due to a weak battery, filthy battery terminals, a damaged starter motor, or a blocked solenoid. There are a few techniques to try before using the jumper cables or electric jump starter even if it could just need a jump start.
How come my car only clicks when I try to start it?
When you turn the key in the ignition, does your car make a succession of quick clicks similar to this?
The good news is that this issue might be easily resolved. A loud, quick clicking sound is typically a sign that your starter motor isn’t receiving enough electrical current to engage; in other words, your solenoid is trying to connect but failing. A deteriorating battery, a faulty connection at the battery, or even a defective alternator that isn’t adequately charging your battery could all be to blame for this lack of electrical current. In the best case situation, you should clean your battery or posts.
Are the Hyundai Elantra engines subject to a recall?
With the 2.0L Nu MPI engine, Hyundai Motor America (Hyundai) is recalling 158,493 2019–2021 Elantra vehicles. The 2.0L Nu MPI-powered 2019–2021 Veloster and Kona models are also included in the recall. You can input your vehicle’s VIN on the NHTSA website to find out if it is affected.
A similar recall from Hyundai was previously issued for almost 150,000 2021 Seltos cars using the same engine. Kia Souls from 2020 and 2021 were also recalled.
What might prevent a starter from turning over?
A defective starter motor, a poor battery-to-starter motor connection, or a blown fuse (if present) in the circuit between the starter and the battery are the typical causes of this issue.
What could prevent an automobile from starting?
A dead or malfunctioning battery is the most typical cause of car starting problems.
1 Despite the fact that most cars are fuel-powered, all vehicles need electricity to function. Your engine’s starter needs an electrical signal to fire in order to crank it. 2 Your car’s engine won’t start if your battery has a problem. Although there are other signs that could point to a dead battery, it is always a good idea to see if your engine even turns over.
Dead batteries have the advantage that you can restart your car without the help of a mechanic. Anyone with a basic understanding of mechanics can jump start a car battery. The best course of action is to simply take good care of your battery because battery jumps are only short-term fixes and new batteries can be pricey. Check out these suggestions for preventing a dead battery for more information on how to achieve that.
How can I tell if my starter is defective?
- #1: The Engine Won’t Start.
- #2: Loud, grinding, or whirring noise.
- #3: Occasional Trouble Starting the Car.
- #4: The Starter Continues After the Start.
- #5: Smoke.
- #6: The starter engages but the engine won’t turn over.
- Seven: Battery
How can I determine whether the starter fuse is blown?
Put the probes of your multimeter on the ignition circuit terminal and ground lead to test the electrical resistance. The starting relay fuse needs to be replaced if the multimeter value is greater than 5 Ohms.
If you don’t have a multimeter, you can measure electrical resistance using a wire. The wire should have one end on the battery lead and the other on the ignition circuit. The starting relay does not need to be replaced if you hear a loud click. However, a weak click is a good indication that the fuse is bad if there is one.