I unintentionally activated my parking brake, and I’m unable to turn it off at the moment. How does a 2020 Hyundai Sonata’s emergency brake work?
In less than two minutes, find out if your auto insurance is being overcharged.
The electronic parking brake (EPB) is located in the buttons right below the vent to the left of the steering wheel on the 2020 Hyundai Sonata.
As soon as the engine is turned on, press and hold the brake pedal while holding down the EPB switch to release the parking brake. Your dashboard’s parking brake warning light ought to turn off.
If the EPB light continues to illuminate after it ought to have been turned off, there might be a brake system fault, which could be a significant safety risk. In this situation, you should refrain from driving and seek immediate assistance from a professional.
Is it time to put the breaks on your current auto insurance policy or does it provide you with the protection your 2020 Hyundai Sonata deserves? Jerry has got you covered if you’re seeking for a more effective approach to shop for auto insurance.
Shopping for auto insurance is more efficient and simple than ever with Jerry. Simply respond to a few brief questions, and Jerry will present you with a collection of customised quotations from the best auto insurance companies. You can then choose the appropriate level of coverage at the appropriate cost.
Starting up with Jerry takes less than a minute, and the typical user saves $887 annually on auto insurance!
In This Article...
Driving your car, using the brakes, and using the parking brake
On manual transaxle cars, the shift lever should be in the appropriate low gear or
- Driving with the parking brake engaged will result in an abundance of brake pad wear.
- When the car is moving, never use the parking brake unless
Press the parking brake pedal a second time while in order to release the parking brake.
the foot brake is being applied. The pedal will stretch to the fully released position automatically.
Apply the foot brake then raise the parking brake to release the parking brake.
brake lever a tiny bit. After that, use the release button (1) to retract the parking
- When stopped and getting out of the car, avoid unintended movement.
- Never let anyone touch the vehicle who is unfamiliar with it.
- The parking brake should always be fully applied in all automobiles.
the motor). When you apply the parking brake, this light will turn on.
the START or ON position of the ignition switch. Check the parking before you start your car.
If the engine is running, the brake system could be acting up. Immediate
If at all feasible, put the car in park right away. Unless that is feasible,
Whenever operating the vehicle, proceed with utmost caution and only do it once.
The Parking Brake System: How Does It Operate?
Parking brakes come in a few different varieties, but they are always activated in the same way. When a lever or electronic switch in the car is pulled or depressed, the parking brake wire is either released or the parking brake motor is instructed to engage the brakes. Using the lever or button will cause the park brake to secure the brakes, often at the rear wheels, regardless of whether the car employs a park brake cable or park brake motor. Vehicles with drum brakes and auxiliary drum brakes push the brake pads against the brake rotor, while disc brakes without auxiliary drum brakes squeeze the brake shoes out against the inner liner of the brake drum.
Common causes of this include:
Bad Switch: A faulty or failed switch is a typical cause of the Parking Brake light remaining on. You may quickly verify this by jiggling the handle once it has been lowered. The switch is most likely to be the problem and needs to be replaced if the light goes out (or goes out and comes back on).
If the brake handle is not fully down, there is another factor that could cause the light to remain on. Verify again that the parking brake is released and that the handle is fully lowered. The light will remain on if the parking brake cable is under any stress.
Parking Brake Not Disengaging: Occasionally, the parking brake itself is the source of the issue rather than the switch or the wires. The dash warning light will remain on if the brake does not release when the handle is dropped.
Low Brake Fluid: Your Parking Brake light is a multipurpose device that is intended to turn on when the reservoir’s fluid level falls below a specific level. As the fluid level fluctuates, you might see the light turning on or off when making turns.
The brake fluid level sensor in your master cylinder is malfunctioning. It is sometimes integrated into the reservoir cap, and other times it is positioned on the side of the sensor. The Parking Brake light will come on if the sensor malfunctions or becomes faulty.
Uneven Fluid Pressure: If your automobile has uneven brake fluid pressure in one or more lines, it may influence how well it can stop and may even cause it to pull to one side or the other. The parking brake light in your dash can also be activated by it.
How is the parking brake deactivated on a 2022 Hyundai Santa Fe?
- When the car is moving, never use the parking brake unless absolutely necessary.
- Never let someone who doesn’t know the car touch the parking sensors.
Make sure the parking brake is fully disengaged and the brake warning light is off prior to driving.
If the engine is operating, the brake system can be broken. Prompt attentiveness
The parking brake is where, exactly?
A parking brake is a mechanical hand lever or foot-operated brake that serves as a backup braking device. It is also known as an emergency brake or an e-brake. Either between the front two seats or to the left of the gas and brake pedals is where it is positioned.
How do you activate the parking brake?
While the engine is still running, follow these four steps:
- Completely depress the brake pedal.
- To use the parking brake, pull the lever, depress the pedal, or depress the button (your owner’s handbook will detail how to do this for your individual vehicle).
- Put your manual transmission in gear or the “Park” position on your automatic transmission.
- Push the brake pedal back.