Hyundai vehicles are equipped with TPMS, or tire pressure monitoring systems, which may detect low tire pressure in any of the car’s four tires and issue an alert. According to the table below, a TPMS from one of two manufacturers is installed as a component of the valve assembly in every Hyundai vehicle.
According to the table below, a TPMS from one of two manufacturers is installed as a component of the valve assembly in every Hyundai vehicle. The tire pressure monitor ECU/receiver receives the data from the sensor, which detects the pressure and temperature inside the tire, together with the TPMS’s distinctive ID.
If the TPMS ID is stored with the ECU, the placard pressure is checked with it, and if there is a pressure difference, a warning light is illuminated on the dash-mounted display.
In This Article...
Emergency procedures and tire pressure monitoring systems (TPMS)
chilled and inflated to the manufacturer’s suggested inflation pressure
on the tire inflation pressure label or vehicle placard. (If you have tires on your car
not as specified on the vehicle placard or tire inflation, or both, of the size indicated
based on the recommended tire inflation pressure listed on the pressure label.
Your tires’ air pressure is seriously low on one or more of them. hence, when the low
When the tire pressure indicator lights up, you should immediately stop and examine your tires.
and fill them with the correct amount of pressure. Taking a much longer
A tire that is under-inflated overheats and may eventually fail. Under-inflation
also decreases tire tread life and fuel efficiency, which could impact how well a vehicle handles.
Even if the tires are underinflated, it is the driver’s obligation to maintain the recommended tire pressure.
A TPMS malfunction indication has also been installed in your car to let you know when it
when the system isn’t functioning correctly. Combining the TPMS malfunction indicator
The telltale will flash for about a minute before staying on all the time.
When the vehicle starts up again, this process will keep happening as long as the problem
exists. The system may not function properly while the malfunction indicator is illuminated.
to correctly detect or alert low tire pressure. The reasons for TPMS issues include
a number of factors, such as the installation of substitute or additional tires.
or wheels on the car that stop the TPMS from working correctly. Always
on your car to make sure the new or different tires and wheels allow
while the engine is running, the switch is in the ON position, or if it turns on after
Can I drive with a faulty TPMS?
Even though the TPMS warning light is constantly on, it should not be disregarded. The light is intended to prevent risky driving when a tire goes flat by giving you adequate warning of deflation before harm is done to the tire or wheel. Pull over whenever the light illuminates and check the air pressure as soon as it is secure to do so. Regular tire inspections ensure that the TPMS system never needs to be fixed, but if it is used to direct maintenance, failing to act could result in a flat tire.
How Do I Interpret a TPMS Warning Light?
There are several possible meanings when you see that silly little light with the exclamation point glaring back at you. It’s frequently anything as harmless as temperature changes that result in a change in the tire’s air pressure. In more severe situations, a puncture or other damage has caused the tire to lose pressure. The sensor can also be activated and result in the light coming on if your tires are overinflated.
How can my tire icon be reset?
When the tire pressure light blinks three times, release pressure on the TPMS reset button. Start the car and let it run for 20 minutes to let the sensor reset. Under the steering wheel is typically where you’ll find the TPMS reset button. Consult the owner’s manual for your car if you can’t find it.
Your car features a tire pressure monitoring system (TPMS) that detects when one or more of your tires are considerably under-inflated and glows a low tire pressure warning as an added safety measure. …
Reset your Hyundai Accent’s TPMS
When your tire pressure is excessively high or low, the TPMS warning light will flash. Neglecting the TPMS warning and operating a vehicle with under-inflated tires increases tire wear and tear because they produce too much heat.
Adjust tire pressure before using the detailed instructions below to reset the TPMS on your Hyundai Accent rather than ignoring the alert.
Hyundai Accent: Warning sign for low tire pressure
If the warning lights up, immediately reduce your speed and steer clear of sharp turns.
and plan for longer stopping distances. You ought to pause and inspect your tires.
as soon as is practical. Tires should be inflated to the recommended pressure as noted on the
Replace the low pressure tire with the spare if it cannot retain the newly added air.
After about a minute, the Low Tire Pressure warning may stop flashing.
after resuming and for roughly 20 minutes after continuous illumination
driving before the vehicle’s low pressure tire is fixed and replaced.
a warm day. The decreasing pressure does not indicate a TPMS issue.
should check the tire pressure and set the tires’ recommended air pressure.
After about five blinks, the TPMS malfunction indication will turn on.
Replace the flat or have it fixed as soon as possible by a certified Hyundai dealer.
We want to make sure your car gives you the best driving experience possible.
Where are TPMS installed?
In the US, direct TPMS usage is more prevalent. The sensors are either housed in the tire pressure valve, which also serves as an antenna, or they are band-clamped to the wheel rim. These gadgets deliver the data to an on-board computer.
Can you change the TPMS on your own?
The Tire Pressure Monitoring System, which notifies you when a tire is dangerously low on air, typically uses TPMS sensors embedded in the tires to detect low tire pressure. The majority of TPMS sensors use internal batteries that cannot be changed to power them.
The lithium ion batteries in a TPMS sensor have a lifespan of 5 to 10 years. The duration of the TPMS sensor batteries is difficult to predict because it depends on how many radio frequency broadcasts the sensors send out. The amount of driving you perform over time and the conditions you drive in will affect the sensor battery life. The TPMS battery life is less affected by cold conditions than by warmer ones. When compared to continuous pace, stop-and-go traffic has a greater effect on TPMS battery life. This is due to the fact that sensors send out more radio frequency broadcasts as a vehicle changes its speed.
The system will issue a malfunction warning when a TPMS sensor’s battery runs out, which will be visible as a blinking TPMS light on your dashboard. After 60 to 90 seconds, the light may either continue to flash or turn solid. Be a repair appointment as soon as you can if you receive this warning, but also check the tire pressure in each tire right away to make sure you have safe inflation all around.
You can change each individual TPMS sensor separately if one of them malfunctions and needs to be replaced. The other sensors, on the other hand, are probably on the verge of failing as well if the failure was brought on by a dead sensor battery. You might wish to proactively replace all the sensors so you have brand-new sensor batteries all around when you take into account the time and hassle of taking your car off for a sensor replacement.
Is TPMS on the tire or rim?
When the air pressure within the tire lowers, your car’s tire pressure monitoring system (TPMS) will sound an alarm and notify the driver. This is an electronic system that links the monitor on the dashboard of the car with the sensor that is mounted on the rim to display whether the tires are adequately inflated or not.
The TPMS will alert the driver with a flat tire warning light if the tire starts to lose air pressure. This indicates that the tire’s proper inflation level is not being maintained for whatever reason; whether as a result of tire or valve damage, the tire will need to be reinflated and repaired.
These sensors make sure the tires don’t deflate to dangerously low levels, which, if one is not careful, could further harm the tire, the rim, and even the TMPS unit. Due to this, they have been a necessary component of automobile production in the US since 2008.
The service life of tires will be shortened by rapid tread wear caused by improper tire inflation. Lower inflation extends their footprint, endangering their ability to drive safely and increasing pressure buildup while they perform, which will destroy their ability to use gasoline efficiently. The tires’ wet weather performance will also suffer from the broader footprint, which will also lengthen the distance between stops. In other words, it will harm the car’s performance and safety when driving.
What distinguishes TPMS from low tire pressure?
How do the TPMS light and the tire pressure light differ from one another? They both mean the same thing, right? Actually, not quite.
The low-pressure tire indicator might be compared to a low fuel indicator for your tires. If this indicator flashes, you must immediately fill your tires. The TPMS light, on the other hand, displays the pressure in each tire and could not alert you to an issue that demands your urgent attention.
Driving safely or maybe getting into a dangerous accident depends on knowing the difference between these two markers. To help you understand what the TPMS light and tire pressure light on cars imply when they start blinking, we’re going to look at some of those differences and share with you our own personal experiences with them.
Our professionals have years of experience fixing a variety of auto issues. This includes tire problems and guiding perplexed drivers toward understanding the significance of these and other dashboard signs.
What occurs if TPMS sensors are not replaced?
Customers who ask you to turn off their TPMS light just and leave the underlying problem unattended can put you and your business at unnecessary risk. Without addressing the problem, you are breaking the NHTSA’s “make inoperative” clause, which makes shops legally obligated to disable the TPMS. It is your duty to let the customer know this and to decline service if they don’t want the problem handled properly.
It is strongly advised to replace all sensors at once if a single sensor has reached the end of its useful life. When one sensor fails, the others are likely to follow suit quickly, just like with headlights. The same holds true for replacing an impact sensor or damaged valve stem. Your consumers should be aware of this since it will assist you give their vehicle the finest care possible. They also find it convenient.
The TPMS sensors must always be reactivated and calibrated for drivers who change their tires as the seasons change. If you don’t do this, the car’s TPMS won’t function properly and could turn on the TPMS light.