How To Reset Tire Pressure Sensor Hyundai Santa Fe?

Usually found somewhere under the steering wheel, the reset button for the tire pressure monitoring system. Till the tire pressure monitor system light blinks three times, keep the reset button depressed. The sensors should reset about 20 minutes after you restart the vehicle.

In This Article...

On a 2021 Hyundai Santa Fe, how do you reset the tire pressure indicator?

On a Santa Fe 2022, how do you reset the tire pressure light?

Drive the vehicle for around 10 minutes at 50 mph.
Turn the ignition key to the “On” position without starting the automobile.
After three seconds, or when the light has flashed three times, let go of the TPMS reset button.
To reset and calibrate the sensor, start the engine and let the vehicle run for 20 minutes.

The reset button for the tire pressure monitor is often located under the steering wheel on Hyundai Santa Fe vehicles.

You could also wonder why the tyre pressure indicator is still on after the tires have been inflated. If your tire pressure monitoring system is malfunctioning or there is a persistent leak, the air pressure warning light may continue to glow even after you have inflated your tires.

Use a pressure gauge to confirm that the tire is properly inflated to the recommended air pressure if the TPMS warning light comes on again after you’ve inflated it.

Why, after filling the tires, does my tire pressure light remain on in a Hyundai?

If you’ve inflated your tires, but the air pressure warning light continues to flash, your tire pressure monitoring system is malfunctioning or you have a gradual leak. A bright TPMS warning light indicates a problem with a tire pressure sensor, assuming there isn’t a leak in your tire. One of them might be damaged, the lithium-ion battery might be dead, or the TPMS itself might have an internal problem. You’ll need to get your Tire Pressure Monitoring System repaired in any of these scenarios.

Quick Tip: Recheck the tire to ensure it is inflated to the correct air pressure if the TPMS warning light illuminates again after you have inflated it. Low tire pressure indicates an air leak, which requires repair or tire replacement.

Driving with having a faulty tire pressure sensor is it safe?

No, it is not safe to drive with the TPMS Light on. It indicates that one of your tires is either under- or over-inflated. The recommended tire pressure for your vehicle can be found in the owner’s manual or on a sticker on the door, trunk, or fuel door. This may result in excessive tire wear, perhaps result in tire failure, and result in a blowout that is hazardous to you and other motorists on the road. For detailed instructions on how to check your TPMS system, make sure to consult your owner’s manual. Different manufacturers may have altered how their TPMS lights activate.

What is the Hyundai Santa Fe’s TPMS?

Hyundai vehicles are equipped with TPMS, or tire pressure monitoring systems, which may detect low tire pressure in any of the car’s four tires and issue an alert. According to the table below, a TPMS from one of two manufacturers is installed as a component of the valve assembly in every Hyundai vehicle.

According to the table below, a TPMS from one of two manufacturers is installed as a component of the valve assembly in every Hyundai vehicle. The tire pressure monitor ECU/receiver receives the data from the sensor, which detects the pressure and temperature inside the tire, together with the TPMS’s distinctive ID.

If the TPMS ID is stored with the ECU, the placard pressure is checked with it, and if there is a pressure difference, a warning light is illuminated on the dash-mounted display.

My tires are in good condition, so why is my low tire pressure sign on?

While the tires appear to be in good condition and the low tire pressure light is ON, you can:

simply press a button to reset the machine and observe the results; or
The sensors need to be changed since one or more of them are damaged.

After starting the vehicle, the low tire pressure warning light ought to turn on for a few seconds. The light ought to be turned off right away.

Drive your car, preferably to the closest gas station or tire shop, to check the air pressure in each tire if the low tire pressure warning light is still on.

Typically, a tire with an air pressure that is 10% to 15% low will turn on the warning light. The air pressure inside the tires also tends to drop in cold or icy conditions. Short trips in the car will warm up the tires and raise the pressure in them.

But if the low tire pressure warning light is still on and all the tires are adequately inflated and warmed up, move on to the next step.

Take this opportunity to get out the owner’s manual. The TPMS reset button may be found on the console or in the glove box, depending on the make and model of your car.

Here are the steps to take after finding the TPMS reset button:

Don’t start the engine after turning the key to the ON position.
For at least three seconds, press and hold the TPMS reset button before letting go. The system will switch off the warning light and produce a beep or other audible alert.
To finish the reset process, start the engine and drive the vehicle for 30 to 1 hour at a minimum speed of 19 mph.
It’s time to check or replace the TPMs sensors if the warning light comes back on.
To get the system tested, drive to the nearest tire store or dealership.

If your car has TPMS, avoid making it a practice of resetting it every time the low tire pressure warning light comes on.

Your safety is considered during the system’s design. The pace of technological advancement means that the TPMS sensors get better with each new model. However, you should make it a practice to check the tire pressure each time you get in the car in order to get the most out of what you have.

Use a different method than the TPMS to check the tire pressure. A quick visual check is sufficient to establish the existence of a flat.

Here’s a helpful hint: just in case, always have a tiny tire pressure gauge in the glove box. You may check the real tire pressure with this straightforward gadget before the TPMS activates.

Take your vehicle to the shop so they can “re-learn” the sensor with a specific tool if your TPMS light is still on. These tools are available online, but they are not inexpensive. I would advise researching the Autel TS501.

Should the TPMS be reset after purchasing new tires?

After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.

Why do my car’s tires, which are good, state they have low tire pressure?

defective TPMS sensor Additionally, these sensors are powered by onboard batteries, which have an approximate lifespan of 5 to 7 years. The TPMS sensor may malfunction and illuminate the low tire pressure signal even when the tires are in good condition due to low battery power and aging-related wear and tear.

AutoZone is able to check TPMS sensors.

You can determine if your tire pressure monitoring system is corroding or failing within your wheel with routine inspection; if so, you will need to replace it. For your repair, AutoZone carries every tire pressure monitoring system item you’ll need, enabling you to drive again efficiently and safely.

In what location is the TPMS sensor?

Where is the location of the tire pressure sensor? It is affixed to the interior of the rim from inside the tire. The tire pressure sensor is a little cylinder that you can see if you take the tire off the rim.

How does the TPMS identify each tire?

The anti-lock brake system’s wheel speed sensors are often used by an indirect TPMS. On-board computer systems can employ these sensors to compare wheel revolution rates between individual wheels as well as to other vehicle operation data, such as speed.

The computer can determine the relative size of the tires on your car based on how quickly each wheel rotates. The computer determines that a tire is underinflated when a wheel starts spinning more quickly than normal and warns the driver accordingly.

So a system that monitors tire pressure indirectly does not genuinely detect tire pressure. The same kind of measurement you may observe with a tire gauge is not being processed electronically. An indirect tire pressure monitor only counts the rotational speed of your tires and sends instructions to the computer to activate the indication light when something seems off with the rotation.

Is TPMS on the tire or rim?

When the air pressure within the tire lowers, your car’s tire pressure monitoring system (TPMS) will sound an alarm and notify the driver. This is an electronic system that links the monitor on the dashboard of the car with the sensor that is mounted on the rim to display whether the tires are adequately inflated or not.

The TPMS will alert the driver with a flat tire warning light if the tire starts to lose air pressure. This indicates that the tire’s proper inflation level is not being maintained for whatever reason; whether as a result of tire or valve damage, the tire will need to be reinflated and repaired.

These sensors make sure the tires don’t deflate to dangerously low levels, which, if one is not careful, could further harm the tire, the rim, and even the TMPS unit. Due to this, they have been a necessary component of automobile production in the US since 2008.

The service life of tires will be shortened by rapid tread wear caused by improper tire inflation. Lower inflation extends their footprint, endangering their ability to drive safely and increasing pressure buildup while they perform, which will destroy their ability to use gasoline efficiently. The tires’ wet weather performance will also suffer from the broader footprint, which will also lengthen the distance between stops. In other words, it will harm the car’s performance and safety when driving.

Has the 2020 Santa Fe got TPMS?

We will examine the most popular 2019 cars, SUVs, minivans, and trucks during the coming months. We’ll concentrate on the top-selling SUVs in the US in 2019 during the month of April.

All American-made automobiles must have direct or indirect TPMS systems fitted as of 2008 as a result of the TREAD Act’s 2007 mandate.

The direct TPMS system is used in the production of the Hyundai Santa Fe. If one or more tires on a direct TPMS system indicate low tire pressure, the TPMS sensors will communicate this information to the vehicle’s ECU. Each tire pressure or an indicator light (low-line TPMS system) will be displayed on the dashboard.

How can I activate the TPMS light?

When the tire pressure light blinks three times, release pressure on the TPMS reset button. For the sensors to reset, start the car and let it run for 20 minutes. The button to reset the tire pressure monitor is under the steering wheel.