Set the key to the “On” position in the ignition with the car off, but don’t push the starter. Once the TPMS light has flashed three times, let go of the tire pressure monitor reset button. Start the engine and give the sensor 20 minutes to refresh.
In This Article...
How To Reset The Tire Pressure Sensor On The Hyundai Sonata For Models From 2007 to 2018
Driving the vehicle for at least 10 minutes at a speed of 50 mph or higher is the simplest way to reset the tire pressure sensor on every Hyundai Sonata vehicle.
You must manually reset the tire pressure light if it remains on after 10 minutes of driving. From 2007 to 2018, all Hyundai Sonata models can be repaired using the following procedure.
Locate the TPMS reset button in step two.
Step 3: Hold down the tire pressure monitoring reset button while waiting for three consecutive flashes of the tire pressure warning light.
Step 5: To fully reset the sensor, start the vehicle and let it run for 20 minutes.
Step 6: The tire pressure light ought to go out after the TPMS sensor has been manually reset.
How does a Hyundai Tucson 2021 re-set the tire pressure indicator light?
The Hyundai Tucson is a fantastic vehicle, and if there is a problem with the tires, you will get a warning sign on your LED screen.
The graphic will clearly show you the problem the automobile has identified as well as which tires require attention.
Once the tire pressure has been adjusted to the proper PSI You might observe that the sensors’ recalibration can take some time.
You might want to calibrate the tire pressure monitoring device by following the straightforward instructions below if you believe the light should have turned off but hasn’t:
- Take a long drive while maintaining a constant speed of 50 mph; this will reset the pressure system and turn off the light.
Check out these more suggestions to try if this one doesn’t work:
- The TPMS reset button may need to be identified; it is typically found under the steering wheel. Check your user manual for its location if you can’t find it.
- Once you’ve found it, turn on the ignition of the automobile, but do not start the engine. When the button blinks three times, let go of it.
- The sensor may need to refresh for 20 minutes or so before you may start the car.
Other pointers for resetting the TPMS light are as follows:
- All tires, including the spare, should be steadily inflated to slightly over the recommended PSI. Then totally deflate each tire. Once this has been accomplished, properly PSI-inflate the tires.
- It may be necessary to unhook the battery cable from the sensor, start the vehicle, and honk the horn for a few seconds in order to deplete the sensor’s power. This will release any remaining power in the car.
- When you’re done, re-connect the battery, and the TPMS should be fixed.
Visit a Hyundai dealership so that they may conduct a thorough sensor health check if you’ve noticed that the light is still on.
On a 2021, how do you reset the tire pressure light?
models with buttons on the steering wheel:
- Click MENU.
- Make the choice Customize Settings.
- Decide on TPMS Calibration.
- Choosing Initialize.
- Choose Yes.
- Click MENU to leave.
Models devoid of a touchscreen:
To make and enter selections in the Driver Information, use the steering wheel buttons.
- Select it after scrolling to the screen for the vehicle settings.
- Choose Calibrate.
A TPMS button may also be located to the left of the steering wheel on some earlier versions. Press and hold the button until the warning light blinks twice if your car has one.
Why, after filling the tires, does my tire pressure light remain on in a Hyundai?
If you’ve inflated your tires, but the air pressure warning light continues to flash, your tire pressure monitoring system is malfunctioning or you have a gradual leak. A bright TPMS warning light indicates a problem with a tire pressure sensor, assuming there isn’t a leak in your tire. One of them might be damaged, the lithium-ion battery might be dead, or the TPMS itself might have an internal problem. You’ll need to get your Tire Pressure Monitoring System repaired in any of these scenarios.
Quick Tip: Recheck the tire to ensure it is inflated to the correct air pressure if the TPMS warning light illuminates again after you have inflated it. Low tire pressure indicates an air leak, which requires repair or tire replacement.
How can I disable the tire pressure indicator?
When the tire pressure light blinks three times, release pressure on the TPMS reset button. Start the car and let it run for 20 minutes to let the sensor reset. Under the steering wheel is normally where you’ll find the reset button for the tire pressure monitor. If you can’t find it, consult the owner’s manual for your vehicle.
My tires are in good condition, so why is my low tire pressure sign on?
While the tires appear to be in good condition and the low tire pressure light is ON, you can:
- simply press a button to reset the machine and observe the results; or
- The sensors need to be changed since one or more of them are damaged.
After starting the vehicle, the low tire pressure warning light ought to turn on for a few seconds. The light ought to be turned off right away.
Drive your car, preferably to the closest gas station or tire shop, to check the air pressure in each tire if the low tire pressure warning light is still on.
Typically, a tire with an air pressure that is 10% to 15% low will turn on the warning light. The air pressure inside the tires also tends to drop in cold or icy conditions. Short trips in the car will warm up the tires and raise the pressure in them.
But if the low tire pressure warning light is still on and all the tires are adequately inflated and warmed up, move on to the next step.
Take this opportunity to get out the owner’s manual. The TPMS reset button may be found on the console or in the glove box, depending on the make and model of your car.
Here are the steps to take after finding the TPMS reset button:
- Don’t start the engine after turning the key to the ON position.
- For at least three seconds, press and hold the TPMS reset button before letting go. The system will switch off the warning light and produce a beep or other audible alert.
- To finish the reset process, start the engine and drive the vehicle for 30 to 1 hour at a minimum speed of 19 mph.
- It’s time to check or replace the TPMs sensors if the warning light comes back on.
- To get the system tested, drive to the nearest tire store or dealership.
If your car has TPMS, avoid making it a practice of resetting it every time the low tire pressure warning light comes on.
Your safety is considered during the system’s design. The pace of technological advancement means that the TPMS sensors get better with each new model. However, you should make it a practice to check the tire pressure each time you get in the car in order to get the most out of what you have.
Use a different method than the TPMS to check the tire pressure. A quick visual check is sufficient to establish the existence of a flat.
Here’s a helpful hint: just in case, always have a tiny tire pressure gauge in the glove box. You may check the real tire pressure with this straightforward gadget before the TPMS activates.
Take your vehicle to the shop so they can “re-learn” the sensor with a specific tool if your TPMS light is still on. These tools are available online, but they are not inexpensive. I would advise researching the Autel TS501.
How is tire pressure fixed?
- Take off the cap on the valve stem. Remove the plastic cap that covers the valve stem by unscrewing it.
- To determine the current pressure, use a tire pressure gauge.
- Verify your car’s recommended tire pressure.
- Apply an air pump to the tires’ inflation.
- Tire inflation at the closest gas station
What does the Hyundai Sonata’s TPMS light mean?
Your Hyundai Sonata’s tire pressure monitoring light turning on indicates that one or more tires are either under- or over-inflated. To keep you safe while driving on the road and to prevent any damage to your tires, car tires must be filled to a specified PSI.
A Hyundai Sonata should have a PSI of 34. The tire pressure light on your car’s dashboard will turn on if the tire pressure monitoring system determines that the tire pressure is either too high or too low. The tire pressure sensor needs to be reset after your tires have been inflated to the recommended PSI.
If you don’t know how to reset the tire pressure sensor on a Hyundai Sonata, this page contains all the instructions you require. For detailed instructions on how to reset the TPMS on every Hyundai Sonata model from 2007 through 2020, keep reading.
How do you reset the Hyundai TPMS?
Usually found somewhere under the steering wheel, the reset button for the tire pressure monitoring system. Till the tire pressure monitor system light blinks three times, keep the reset button depressed. The sensors should reset about 20 minutes after you restart the vehicle.
Why is the light on my tire still on?
When the TPMS warning light illuminates, proceed with caution. This indicates that at least one of your tires may be at least 25% under-inflated.
*The simplest way to get the most accurate reading is to check the tire pressure before you drive on it when the tire is “cool.” If your TPMS light is on, first check that you have correctly reset your TPMS by following these instructions.
Will my TPMS light automatically turn off if I fill my tires with air after it illuminates?
Several minutes after reinflating the tires to the prescribed pressure, the TPMS light ought to go out.
What happens if I adjust the tire pressure but the light on my tire pressure gauge still doesn’t go out?
The only place that can fix a computer issue that causes the TPMS warning light to turn ON and flash ON for one second and OFF for three seconds is the dealership service center. When the TPMS warning light illuminates and remains on, one or more tires may have low tire pressure. The light ought to go out once the tire is inflated to the recommended tire pressure listed on the door placard. Always check the pressure in all of your tires because one or more of them may not be at the proper pressure.
On a Kia Sorento 2021, where is the TPMS reset button located?
Hold down the pressure warning reset switch (in the glove box or under the steering wheel) until the TPMS telltale light blinks three (3) times.
After a tire rotation, does the TPMS need to be reset?
These sensors measure the air pressure and transmit the information to the dashboard of your car. The batteries can last up to 10 years, and there is no need to reset them after rotating tires or making inflation changes. They provide precise pressure readings.