Usually found somewhere under the steering wheel, the reset button for the tire pressure monitoring system. Till the tire pressure monitor system light blinks three times, keep the reset button depressed. The sensors should reset about 20 minutes after you restart the vehicle.
In This Article...
Tire Pressure Sensor Reset
Identify the TPMS system type.
If the direct system is employed by your 2019 Hyundai Santa Fe, resetting the tire pressure sensors might only require pressing a reset button on the dash or navigating a menu as described in your owner’s handbook. If your 2019 Hyundai Santa Fe has an indirect system, it must be reset by a dealer or one you have personally purchased using a magnet or scanning equipment. In order to reset some systems, the ignition must be turned on while the reset button is pressed and held down for three seconds within the glove box.
Pump up the tires.
Ensure that all tires are inflated appropriately. All tires must be fully inflated because you are resetting the sensors to “zero,” or else the sensors won’t be properly calibrated and their readings will be off.
Evaluate the battery.
If the sensor in your 2019 Hyundai Santa Fe is powered by a battery, make sure it is not dead. The battery should be changed every five years. Since the battery is integrated, in certain cases this necessitates replacing the complete sensor unit.
Make the transponders new.
Every wheel has a unique transponder. Each responder’s location changes when the wheels are rotated, and the TPMS needs to learn their new locations. Although this relearning process varies depending on the vehicle, you can get more information in the TPMS chart in your manual or online. If the valve stems double as tire pressure sensors, it is a good idea to swap them out when purchasing new tires.
Apply the magnet technique.
Press the lock and unlock buttons on the key fob when the key is in the ignition but the engine is not running. Placing a magnet over each valve stem after the initial chirp will cause the horn to chip for each valve in the following order: left front, right front, right rear, and left rear. Make that the driver information center is showing the pressure values.
Utilize the scan tool approach.
The owner’s manual’s TPMS Reprogramming Procedure menu prompts can be followed if no sensors are being replaced.
On a Santa Fe 2022, how do you reset the tire pressure light?
- Drive the vehicle for around 10 minutes at 50 mph.
- Turn the ignition key to the “On” position without starting the automobile.
- After three seconds, or when the light has flashed three times, let go of the TPMS reset button.
- To reset and calibrate the sensor, start the engine and let the vehicle run for 20 minutes.
The reset button for the tire pressure monitor is often located under the steering wheel on Hyundai Santa Fe vehicles.
You could also wonder why the tyre pressure indicator is still on after the tires have been inflated. If your tire pressure monitoring system is malfunctioning or there is a persistent leak, the air pressure warning light may continue to glow even after you have inflated your tires.
Use a pressure gauge to confirm that the tire is properly inflated to the recommended air pressure if the TPMS warning light comes on again after you’ve inflated it.
On a 2022 Tucson, how do you reset the tire pressure light?
- Put the car in park.
- Start the engine.
- Until the Settings menu shows on the screen, continually press the Mode button on the steering wheel.
- To scroll to the Tire Pressure screen, press the downarrow key.
- Each tire’s pressure should be checked.
- The screen will display the low-pressure tire.
Why does my tire pressure light come on in Hyundai when my tires are fine?
Several cars now come with a built-in tire pressure monitoring system (TPMS). An indication light will flash on your dashboard if the air pressure in your tires drops below the recommended level.
The information system in the dashboard may have a menu that shows you which of the four tires is malfunctioning. The TPMS indicator may be on in a number of circumstances, however your tires may not require replacement or upkeep.
If this occurs and all of your tires seem to be in good condition. This light may illuminate even if your tires are in good condition for a number of different reasons. The decrease in outdoor temperature is one explanation. To double-check and confirm it, it is advisable to maintain a tire pressure gauge in the automobile.
How can I turn off the tire pressure warning light?
When the tire pressure light blinks three times, release pressure on the TPMS reset button. Start the car and let it run for 20 minutes to let the sensor reset. Under the steering wheel is normally where you’ll find the reset button for the tire pressure monitor. If you can’t find it, consult the owner’s manual for your vehicle.
Should the tire pressure light be reset?
Only after checking the tire pressure in each wheel should you try to reset the light. When your tires are properly inflated, the light might turn off by itself. Driving at 50 mph for roughly 10 minutes should help the tire pressure sensor reset if it doesn’t go off right away.
Can a tire pressure sensor be self-resetting?
After you have inflated your tires, you can reset the TPMS Warning Light on some cars by pressing a button or switch on the instrument panel. On some cars, after a short distance has been driven following tire inflation, the TPMS system will automatically reset itself and turn off the TPMS Warning Light.
My tire pressure is fine, so why won’t the light go off?
How to Reset the Tire Pressure Light Try the following if your TPMS light is still on after you have inflated your tires to the recommended pressure: 10 minutes at a speed of 50 mph would be plenty. When you start the car again, the TPMS light should not be on because the tire sensors should have been reset.
What is the Hyundai Santa Fe’s TPMS?
Hyundai vehicles are equipped with TPMS, or tire pressure monitoring systems, which may detect low tire pressure in any of the car’s four tires and issue an alert. According to the table below, a TPMS from one of two manufacturers is installed as a component of the valve assembly in every Hyundai vehicle.
According to the table below, a TPMS from one of two manufacturers is installed as a component of the valve assembly in every Hyundai vehicle. The tire pressure monitor ECU/receiver receives the data from the sensor, which detects the pressure and temperature inside the tire, together with the TPMS’s distinctive ID.
If the TPMS ID is stored with the ECU, the placard pressure is checked with it, and if there is a pressure difference, a warning light is illuminated on the dash-mounted display.
Do tire sensors automatically reset?
Additionally, once the car has been driven for a while, the TPMS system will reset itself. A technician can change the inflation pressure, rotate, or replace sensors.
Should the TPMS be reset after purchasing new tires?
After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.
I have a low tire pressure light on. Can I drive?
Is Driving Secure? You should be able to continue driving safely for a few more miles until you can add air if your tire pressure is only slightly low. Extremely low tire pressure can cause tires to fail. This could lead to a blowout, which could be quite deadly.
What distinguishes TPMS from low tire pressure?
A tire pressure monitoring system (TPMS) is built into your car and is intended to monitor the air pressure in each tire. The Low Tire Pressure indicator on your dash goes on automatically when the system detects a low tire. Until the tires are checked and the pressure is adjusted, this light will remain on.
On the other hand, the TPMS light is intended to turn on when there is an issue with the monitoring system itself. For instance, if a sensor in a wheel malfunctions, the TPMS light will illuminate and remain on until the issue has been resolved.
The maintenance process is not replaced by the TPMS system. Even if the indicator is not on, you should physically check your tire pressure at least once every month.
The informative nature of the aforementioned claims warrants independent verification. kindly visit our
Has the 2020 Santa Fe got TPMS?
We will examine the most popular 2019 cars, SUVs, minivans, and trucks during the coming months. We’ll concentrate on the top-selling SUVs in the US in 2019 during the month of April.
All American-made automobiles must have direct or indirect TPMS systems fitted as of 2008 as a result of the TREAD Act’s 2007 mandate.
The direct TPMS system is used in the production of the Hyundai Santa Fe. If one or more tires on a direct TPMS system indicate low tire pressure, the TPMS sensors will communicate this information to the vehicle’s ECU. Each tire pressure or an indicator light (low-line TPMS system) will be displayed on the dashboard.
When pressure is high, will the TPMS activate?
Examine the tire pressure in each of your four tires as soon as the TPMS Light illuminates. If a tire is under-inflated, fill it up with air until it meets the manufacturer’s recommendations, which may be located on the inside of the driver-side door panel. Additionally, if the tire pressure is too high, the TPMS Light can illuminate. Check the pressure in each of the four tires if this is the case, then deflate as necessary.
Any of the following three possibilities for the TPMS light to turn on are:
When the TPMS light illuminates while you are moving, at least one of your tires likely has an inaccurate air pressure. Check the tire pressure and locate the closest gas station. Underinflated tires can wear out prematurely, limit fuel efficiency, and pose safety risks if driven on over an extended period of time.
TPMS flashes on and off: Changing temperatures may be a blame for the TPMS Light occasionally flashing on and off. The light may go out after the car warms up or when the temperature rises during the day if the pressure dips at night and rises during the day. The weather is causing the pressure in the tires to fluctuate if the light turns back on as the temperature drops. It is a good idea to gauge the tires and add or remove air as necessary.
TPMS light flashes for a minute or so after you turn on your car, then stays on: If the TPMS Light flashes for a minute or so after you turn on your car, then stays on, the system is not working properly. Your car has to be inspected as quickly as possible by a professional. If you must drive, exercise caution because the TPMS system will no longer warn you if your tires are underinflated. If you have to drive before a professional can examine your automobile, check the pressure in each tire with a gauge and add more if necessary.