Set the key to the “On” position in the ignition with the car off, but don’t push the starter. Once the TPMS light has flashed three times, let go of the tire pressure monitor reset button. Start the engine and give the sensor 20 minutes to refresh.
In This Article...
How Do You Reset A Hyundai Elantra’s TPMS?
You may reset the tire-pressure monitoring system in your Hyundai Elantra once you’ve found the TPMS.
The following steps will show you how to reset the TPMS on a Hyundai Elantra:
1. Turn the ignition to the “ON” position and insert the key.
2. Avoid starting the car.
3. Hold down the TPMS reset button while waiting for the tire pressure light to blink three times.
4. Let go of the TPMS button.
5. Start the vehicle.
6. Permit the sensor to reset for 20 minutes.
Your tire-pressure monitoring system will be reset by following these instructions. After putting air in your tires, it’s crucial to reset your TPMS since it keeps your knowledge of your tire pressure accurate. When your tires need to be inflated, the tire pressure monitoring system will let you know by turning on the tire pressure light.
Why, after filling my Elantra’s tires, does the tire pressure light remain on?
Even when the tires are fully inflated, the tire pressure light may occasionally remain on. This could be a result of the TPMS needing to be reset. It might take up to 20 minutes after the TPMS has been reset for the light to turn off. You can also try driving for 10 minutes at speeds greater than 50 mph. If there is a problem with your automobile battery, the tire-pressure light can keep flashing.
Why does my tire pressure light come on in Hyundai when my tires are fine?
Several cars now come with a built-in tire pressure monitoring system (TPMS). An indication light will flash on your dashboard if the air pressure in your tires drops below the recommended level.
The information system in the dashboard may have a menu that shows you which of the four tires is malfunctioning. The TPMS indicator may be on in a number of circumstances, however your tires may not require replacement or upkeep.
If this occurs and all of your tires seem to be in good condition. This light may illuminate even if your tires are in good condition for a number of different reasons. The decrease in outdoor temperature is one explanation. To double-check and confirm it, it is advisable to maintain a tire pressure gauge in the automobile.
How do I reset the TPMS on a 2018 Hyundai Elantra?
Usually found somewhere under the steering wheel, the reset button for the tire pressure monitoring system. Till the tire pressure monitor system light blinks three times, keep the reset button depressed. The sensors should reset about 20 minutes after you restart the vehicle.
Why won’t my tire pressure warning light turn on?
When the TPMS warning light illuminates, proceed with caution. This indicates that at least one of your tires may be at least 25% under-inflated.
*The simplest way to get the most accurate reading is to check the tire pressure before you drive on it when the tire is “cool.” If your TPMS light is on, first check that you have correctly reset your TPMS by following these instructions.
Will my TPMS light automatically turn off if I fill my tires with air after it illuminates?
Several minutes after reinflating the tires to the prescribed pressure, the TPMS light ought to go out.
What happens if I adjust the tire pressure but the light on my tire pressure gauge still doesn’t go out?
The only place that can fix a computer issue that causes the TPMS warning light to turn ON and flash ON for one second and OFF for three seconds is the dealership service center. When the TPMS warning light illuminates and remains on, one or more tires may have low tire pressure. The light ought to go out once the tire is inflated to the recommended tire pressure listed on the door placard. Always check the pressure in all of your tires because one or more of them may not be at the proper pressure.
How do you reset the Hyundai TPMS?
When the tire pressure light blinks three times, release pressure on the TPMS reset button. For the sensors to reset, start the car and let it run for 20 minutes. The button to reset the tire pressure monitor is under the steering wheel.
Will the tire pressure light automatically turn off?
Tire pressure can be impacted by overnight temperature variations or by cold winter days. The low-pressure indicator may then display as a result of this. The pressure in your tires can change by up to 10 PSI when there are significant temperature changes between day and night.
After about 20 minutes of driving, the light may turn off on its own when the right inflation level stabilizes and the air in your tires warms and expands.
In any case, you ought to have your air checked immediately. Your tires are at least 25% underinflated, according to the TPMS light. This poses a risk to your safety, especially if the load is close to your vehicle’s maximum load capacity. There is a higher possibility of tire failure, degraded handling, and increased tire wear and tear. Your fuel economy may also suffer.
Why is the light on my tire still on?
If your tires are properly inflated yet the warning light continues to illuminate, you may have a leak or a TPMS issue in one or more of your tires. To determine if a tire has a leak is not difficult. Simply double-check the air pressure in each of your tires with your tire gauge. If all of the tires have the proper air pressure, one or more tire pressure sensors are likely to be at fault, necessitating repair work on your tire pressure monitoring system. You’ll need to replace or repair the tire if you notice that one or more of your tires’ air pressures have fallen.
Why do my car’s tires still have low pressure?
Don’t ignore the tire-pressure warning light if it turns on; you might be getting a flat. A tire’s tendency to lose around a pound of air pressure every month and a pound for every 10 degrees of temperature drop can cause low pressure, as can leaks.
How soon after tire filling will the light turn on?
Within twenty minutes, the light ought to turn off. While the car is off, disconnect the positive battery cable. To release the last of the power, turn on the engine and press the horn for three seconds.
Should the TPMS be reset after purchasing new tires?
After changing or rotating your tires, or after adding new sensors, you should always reset your TPMS. Even after you have inflated your tires, some sensor manufacturers advise restarting the device. By teaching the primary TPMS system to identify the sensors in their new locations, resetting the TPMS is frequently referred to as retraining the system. TPMS reset procedures vary from vehicle to vehicle and typically involve a specific sequence of ignition and pedal actions, a configuration change in your dashboard menu, or the use of a TPMS Reset Tool.
What distinguishes TPMS from low tire pressure?
A tire pressure monitoring system (TPMS) is built into your car and is intended to monitor the air pressure in each tire. The Low Tire Pressure indicator on your dash goes on automatically when the system detects a low tire (it looks like a tire with an exclamation point in it). Until the tires are checked and the pressure is adjusted, this light will remain on.
On the other hand, the TPMS light is intended to turn on when there is an issue with the monitoring system itself. For instance, if a sensor in a wheel malfunctions, the TPMS light will illuminate and remain on until the issue has been resolved.
The maintenance process is not replaced by the TPMS system. Even if the indicator is not on, you should physically check your tire pressure at least once every month.
The informative nature of the aforementioned claims warrants independent verification. kindly visit our
Has the 2018 Elantra has TPMS?
All American-made automobiles must have direct or indirect TPMS systems fitted as of 2008 as a result of the TREAD Act’s 2007 mandate.
Hyundai produces the Elantra, Elantra GT, and Elantra Touring with a direct TPMS system. If one or more tires on a direct TPMS system indicate low tire pressure, the TPMS sensors will communicate this information to the vehicle’s ECU. Each tire pressure or an indicator light (low-line TPMS system) will be displayed on the dashboard (high-line TPMS system).
How do you deactivate TPMS?
Turn the key to the “on” position with the car off, but don’t let it run. When the Toyota tire pressure sensor blinks three times, hold down the TPMS reset button until it stops blinking. Start the car, then let it run for 20 minutes to let the sensor reset. Under the steering wheel is typically where you’ll find the TPMS reset button.
Can I drive with my TPMS on?
To avoid seeming like Debbie Downer, we’ll simply say no. Driving around with your TPMS light on is not safe. You can’t tell how quickly your tire is losing air or how long it has been over- or underinflated without doing a tire examination. The best course of action is to check the current inflation level of each tire with a tire pressure gauge.
When the tire inspection light appears while you are driving, slow down and get to the closest gas station or service facility.
When pressure is high, will the TPMS activate?
Examine the tire pressure in each of your four tires as soon as the TPMS Light illuminates. If a tire is under-inflated, fill it up with air until it meets the manufacturer’s recommendations, which may be located on the inside of the driver-side door panel. Additionally, if the tire pressure is too high, the TPMS Light can illuminate. Check the pressure in each of the four tires if this is the case, then deflate as necessary.
Any of the following three possibilities for the TPMS light to turn on are:
When the TPMS light illuminates while you are moving, at least one of your tires likely has an inaccurate air pressure. Check the tire pressure and locate the closest gas station. Underinflated tires can wear out prematurely, limit fuel efficiency, and pose safety risks if driven on over an extended period of time.
TPMS flashes on and off: Changing temperatures may be a blame for the TPMS Light occasionally flashing on and off. The light may go out after the car warms up or when the temperature rises during the day if the pressure dips at night and rises during the day. The weather is causing the pressure in the tires to fluctuate if the light turns back on as the temperature drops. It is a good idea to gauge the tires and add or remove air as necessary.
TPMS light flashes for a minute or so after you turn on your car, then stays on: If the TPMS Light flashes for a minute or so after you turn on your car, then stays on, the system is not working properly. Your car has to be inspected as quickly as possible by a professional. If you must drive, exercise caution because the TPMS system will no longer warn you if your tires are underinflated. If you have to drive before a professional can examine your automobile, check the pressure in each tire with a gauge and add more if necessary.