The battery in your Hyundai key fob is simple to change. A replacement CR 2032 3V battery is all that is required. They typically cost between $3 and $5 for a pack of 5. Wearing latex gloves is advised because you will be contacting a motherboard during this process, which could result in unintended harm.
- Remove the emergency key from the fob’s base.
- Between the release button and the key slot, insert the key.
- Turn the key until the fob pops open as if you were unlocking a door.
- Open the fob while facing the buttons downward (otherwise they will fall out).
- Remove the barrier and motherboard, then set aside the button-side of the fob.
- Remove the dead battery from its mount using the key.
- Place the + side of the new battery in its bracket.
- Replace the fob’s button-half, motherboard, and barrier.
- Set the release button peg in the appropriate hole.
- Reassemble the fob with a snap.
You’re done now! Press any button to put your Hyundai Smart Key to the test. If all was done correctly, a tiny red light should flash over the unlock button.
In This Article...
Questions and Answers
Hyundai Tucson’s remote key fob is powered by one CR2032 battery. The cost of CR2032 batteries ranges from around $5 depending on the brand, size, and type that you choose to purchase. Yes, you can bring an old battery to the store.
Most of the time, a remote key fob doesn’t require reprogramming following a battery change. Check the voltage of the new battery again if your key fob isn’t working. Read the user’s manual or speak with a local dealer if it is not helpful.
The battery in your 2019 Hyundai Tucson key fob can be changed by you. The hardest step is prying open the cover of the keyless entry fob. With our detailed instructions, it’s fairly simple.
Depending on the make, the cost of a car service to replace the battery in a keyless entry remote can range from $30 to $500.
The Hyundai Tucson’s key fob batteries should be replaced every three to four years, though this will depend on usage and manufacturing quality. Replace the batteries in your remote key fob if the signal strength has decreased before it stops opening doors and causes you trouble.
If your Hyundai’s doors require several clicks to unlock or lock, there is a low key battery indicator on the dashboard, the key fob’s buttons are broken, or the battery is older than four years, you probably need to replace the battery within the keyless entry remote. The battery that is currently in place is almost certainly dead, however if that doesn’t solve the issue, a new or repaired fob is required.
What type of battery does a key fob for a 2017 Hyundai Tucson take?
A CR2032 battery powers the majority of Hyundai key fobs. Once you have a new Hyundai key fob replacement battery in your possession, insert it into your key fob exactly where the old one was. Check to see if the battery is in contact with each connection.
I can’t get my Hyundai key fob to open.
You must first depress the metal button or tab to release the actual key before you can open the key fob on a Hyundai. The fob will then pop open once you insert the key into the hole and move it around. Despite being somewhat high-tech, your key fob is robust.
Where is the Hyundai Tucson’s smart key holder?
This information caught my attention. I think it would also benefit our Palisades!
Fix 1: While tapping the brake, push the Start button using the rear or end of the dead key fob. Fix 2: Place the dead key fob, buttons facing up, in the Smart Key slot (located in the locations specified below), and depress the brake while pressing the Start button.
Slots for Smart Keys: There are three places where these slots can be found: 1. on the front of the center console; 2. behind a panel right below the infotainment control knob; or 3. on the left side of the glovebox when it is open.
Why won’t my key fob operate now that the battery has been changed?
The most typical fix for a broken key fob is a battery replacement. However, replacing the batteries may not always be the best course of action. Therefore, your key fob might not operate even after a battery change for various reasons.
Handling the key fob circuit carefully is the first step in fixing the issue. Do not use your bare hands to contact the key fob circuit if you are not familiar with handling electronics. Call a professional right away to quickly diagnose and resolve the issue.
The following are additional causes for the key FOB’s malfunction:
Over time, a car remote’s button will inevitably wear out. When the button is depressed, the contacts notify the circuit board to carry out commands. The contacts may become separated from the buttons as they deteriorate. Pressing the buttons repeatedly is one of the greatest techniques to identify worn-out car buttons on car remotes.
Determine which of the following circumstances applies:
- Only certain button presses, or all button presses, function.
- One button operates while the other does not.
There is a problem with the automobile remote if the plastic that covers the key fob has also cracked. Open the key fob using basic tools, then inspect it for damaged contacts or crooked buttons. In the event that doesn’t work, get a new automobile key fob.
Your car remote might not function after changing the battery for another cause, which is the lock. Look for these indications to determine whether the lock or auto door has become faulty.
- Manual or key operation of the lock does not cause it to unlock or lock.
- Some door locks can be opened remotely, but not all.
- Without the doors opening, a signal has been transmitted, as indicated by the indicator light flashing.
- Door lock operates partially or not at all.
The automobile key may become damaged as a result of things like water, scratches, etc. The key fob may be damaged if it stops functioning right away after being trodden on, submerged in water, or opened. Other indicators to look out for include:
- Whether a backup key functions
- The buttons are stationary.
- The Key is clearly damaged.
A damaged key can be replaced with a new car key. The key fob can be reprogrammed with assistance from the Colorado Springs Locksmith specialists.
There is a good likelihood that the battery change reset a car remote. When certain buttons are pressed, the key fob can also be reset. Therefore, the failure of many key fobs is a good indication that the automobile key remote has been reset. There are two indicators to watch out for:
- No spare remotes operate.
- car remote completely quits functioning
After changing the battery, does the key fob need to be reprogrammed?
After changing the battery, you typically do not need to reconfigure the key fob. However, you might need to reprogramme it by re-pairing it with your vehicle if you’ve replaced not only the batteries but also some of the internal cabling and electronics.
How is the Hyundai Smart key pry opened?
The case ought to open easily. In order to start, look for a little notch or imprint down the side of your key fob if you drive an older Hyundai car. Then, spin the key fob in either way with a coin or flat-bladed screwdriver to gently pry it open from the notch.
What occurs when the battery in your key fob runs low?
The transmitter’s range decreases as the fob battery gets weaker. This implies that for the key fob to operate, you must be close to the vehicle. When a smart key fob is in your pocket or handbag for automobiles with push-button starts, the car might not always detect it if the battery is low.
What does the Hyundai key fob’s hold button do?
What does auto hold accomplish? It prevents your automobile from rolling away accidently when it is moving or stopped, thanks to the ABS/ESC hydraulic unit.
Can I change a key fob on my own?
Yes, a replacement automobile key can be obtained without the original. Since people frequently misplace their car keys, replacing a misplaced car key is an easy operation. Nevertheless, depending on the key type, it could be pricey.
A key fob is a little electronic gadget that you can use to remotely lock and unlock your car. Other capabilities of the fob could include a remote engine starter, a trunk opening, or a proximity system that allows you to open your car without taking the fob out of your pocket.
Depending on how sophisticated the key technology is, replacing car keys can be expensive. An old metal key can be duplicated for less than $10 at a hardware store. On the other hand, the most recent smart keys must be ordered from a dealer and might cost between $200 and $500.
Your car key’s battery can be changed easily by opening it up, identifying the battery type, and going to the store. If you’re unsure of how to open the remote, it pays to consult your owner’s manual because you don’t want to force anything open and break it.
Today’s automobile keys are more secure and capable thanks to technology, but the gain isn’t free. The majority of modern keys feature complex electronic parts that must be configured before usage.
You may be able to buy an after-market key fob via a locksmith or online if your automobile is more than five years old. These sorts of fobs range in quality, but they are less expensive than other options.
You might be able to program a replacement yourself, depending on the make and type of your vehicle. The steps for programming a key fob yourself can differ: Owner’s manuals from certain automakers include instructions. In many circumstances, information can be available online. The catch is that in order to complete the process quickly or at all, you might need two functional key fobs.
It’s wise to acquire and program a backup remote before you require it. Additionally, a lot of used-car buyers (particularly auto dealers) will pay more for a vehicle with at least two functional key fobs or sets of keys.
A misplaced automobile key can indeed be replaced by a locksmith. If you have the option of receiving your replacement key from a locksmith or the dealership, the latter may be less expensive. Before making a choice, be sure to inquire about prices with your nearby vehicle dealership.
Hyundai vehicles can be operated without a key fob.
Once the engine is going, the automobile will still work without the key fob. Additionally, switching from park to drive is trouble-free even when the key is not available.
Can a key fob with a low battery prevent a car from starting?
Yes, a key fob with short battery life may prevent your automobile from starting. The key fob for your automobile is an electrical gadget with a battery inside that powers signals sent from the key fob to your car. Your car’s computerized systems get alerts in accordance with the key fob commands you press, and the vehicle subsequently reacts as necessary.
This function depends on the battery in your car’s key fob; if it runs out, you might not be able to start your car without a jumpstart. Your ability to start your car may be affected if the battery in your Honda keyless remote is low.
How long should the battery on a key fob last?
How Long Are Key Fobs Good For? The battery in your car’s fob or remote will eventually need to be replaced, just like any other battery. A car fob battery should typically last three to four years.
Why doesn’t my automobile recognize my key fob?
Key fob battery failure The most frequent cause of a keyless entry system failing to send signals is a faulty battery in the key fob. Use the extra key fob to unlock the car and turn on the ignition if one is available. Use the key that is included in the spare fob if it is not available to unlock the door.