The battery in your Hyundai key fob is simple to change. A replacement CR 2032 3V battery is all that is required. They typically cost between $3 and $5 for a pack of 5. Wearing latex gloves is advised because you will be contacting a motherboard during this process, which could result in unintended harm.
- Remove the emergency key from the fob’s base.
- Between the release button and the key slot, insert the key.
- Turn the key until the fob pops open as if you were unlocking a door.
- Open the fob while facing the buttons downward (otherwise they will fall out).
- Remove the barrier and motherboard, then set aside the button-side of the fob.
- Remove the dead battery from its mount using the key.
- Place the + side of the new battery in its bracket.
- Replace the fob’s button-half, motherboard, and barrier.
- Set the release button peg in the appropriate hole.
- Reassemble the fob with a snap.
You’re done now! Press any button to put your Hyundai Smart Key to the test. If all was done correctly, a tiny red light should flash over the unlock button.
In This Article...
Find the seam where the two halves of the fob meet.
The majority of key fobs open by snapping together two sections in a clamshell shape. You can split the two pieces along a seam; occasionally, there will even be a notch there. If your automobile still requires you to turn the ignition switch, be careful not to hang anything else from the keyring than the fob because the weight of your house keys could damage the ignition cylinder, which could be dangerous.
I can’t get my Hyundai key fob to open.
Start by removing the metal key from a Hyundai that is not too old by pressing and holding the metal tab or button. Then, insert the metal key into the minuscule opening and turn it in either way to release the back cover of your Hyundai key fob. The case ought should then open.
How is the Hyundai Smart Key pry opened?
The case ought to open easily. In order to start, look for a little notch or imprint down the side of your key fob if you drive an older Hyundai car. Then, spin the key fob in either way with a coin or flat-bladed screwdriver to gently pry it open from the notch.
How are car keys changed?
visit a vehicle locksmith The replacement key made by an automobile locksmith will fit your particular vehicle. Additionally, if your replacement key fob needs to be programmed, an automotive locksmith may be able to help.
Where is the Hyundai Elantra’s smart key holder located?
This information caught my attention. I think it would also benefit our Palisades!
Fix 1: While tapping the brake, push the Start button using the rear or end of the dead key fob. Fix 2: Place the dead key fob, buttons facing up, in the Smart Key slot (located in the locations specified below), and depress the brake while pressing the Start button.
Slots for Smart Keys: There are three places where these slots can be found: 1. on the front of the center console; 2. behind a panel right below the infotainment control knob; or 3. on the left side of the glovebox when it is open.
How much does a new Hyundai key fob cost?
It’s more likely that you will be allowed to utilize an aftermarket key fob if your automobile is at least ten years old, according to CR’s Ibbotson. Many of these less sophisticated fobs can be configured by the consumer, a local technician, or an automotive locksmith.
Ibbotson advises making sure to phone your neighborhood garage first to confirm that they can do the task, as key-fob programming equipment levels can vary from shop to shop. For instance, a Maryland-based repair shop called Murray’s Auto Clinics informed CR that they are unable to program key fobs for any vehicle with push-button start or keyless entry.
We took our vehicle to M.J. Sullivan Hyundai in New London, Connecticut, where we were charged $120 for programming (one hour of labor), which is what they would have charged us if we had purchased the key fob from them.
Hyundai sent us a laser-cut mechanical backup key for $72.47, bringing the total cost to $272.42 (the car waited at the shop for two days); if we had ordered the key fob through the store, the total would have been $428.92).
For some makes and models, you can purchase a cheap aftermarket fob and program it yourself if your home unexpectedly gains a third driver, such as a teenager.
We purchased a fob from BestKeys from Amazon for CR’s 2008 Chrysler Town & Country minivan. Although it lacks the Chrysler branding on the back, it resembles the two original fobs that came with the minivan when it was new. The uncut mechanical key and internal circuitry were both included in the $14.30 price. (However, we didn’t see the need to shell out the cash to have a locksmith cut that third key.)
Chrysler customers can program a third key fob themselves if they already have two functional ones, just like GM owners can. The owner’s manual contains clear and straightforward programming instructions.
Why won’t my key fob operate now that the battery has been changed?
A dead battery is the most frequent cause of a key fob not functioning. Having said that, your keyfob might be having more serious issues. You might require a key fob replacement or perhaps auto door lock repair if your key fob stops operating after a battery change.
Is a key fob powered by a battery?
Key fobs are battery-operated in any case. The key fob battery is not required to start your car, but it is required for any remote controls that come with your automobile. You’ll need to buy a new battery when the old one wears out or dies.
If I change the battery, do I need to reprogram my key fob?
After changing the battery, you typically do not need to reconfigure the key fob. However, you might need to reprogramme it by re-pairing it with your vehicle if you’ve replaced not only the batteries but also some of the internal cabling and electronics.
What occurs when the battery in your key fob runs low?
The transmitter’s range decreases as the fob battery gets weaker. This implies that for the key fob to operate, you must be close to the vehicle. When a smart key fob is in your pocket or handbag for automobiles with push-button starts, the car might not always detect it if the battery is low.
Can I operate a vehicle with a low battery?
Will I be able to drive my truck safely after it warned me that the key fob 2 battery was low when I got in it? Does the key fob required to operate and drive my truck need to be present? Or is there a deeper problem with my car itself? It is not keyless entry or anything of the sort; I have a key. Can I simply carry on with my tasks while using a dead remote?
hello there Prior to 2009, the majority of automobiles equipped with a FOB remote control included a physical key that was used to manually unlock doors and start the ignition. The FOB is more of a luxury than a necessity. The FOB is essential to the vehicle’s operation if it has a keyless or push-button starter, so you would need to replace the battery before it was fully depleted. In spite of the fact that you shouldn’t require the key chain remote’s functionality to operate the car, it’s always a good idea to maintain it charged in case you do.
The informative nature of the aforementioned claims warrants independent verification. kindly visit our
How often should the battery in my key fob be changed?
Car key fobs are so practical that it’s simple to ignore them. But did you realize that regular maintenance is required for your key fob? Batteries for key fobs should be changed every three to four years, though this will depend on how frequently they are used and how well they are made.
You’d wish you had taken better care of your key fob if it were to abruptly cease working while you were far from home. Avoid being stranded and having to pay for a tow because your key fob isn’t working properly. Here are some red flags that could indicate that it’s time to replace your key fob batteries before it’s too late.
Will a dead key fob prevent a car from starting?
If your key fob isn’t detected inside the car, the keyless entry system won’t start the engine. The system probably won’t be able to tell when the key fob is inside the car if it has a dead battery, which will prevent the engine from starting. By pressing down while placing the fob on the start engine button, you can get past this problem. Even though this should enable your engine to start, it is still beneficial to change the fob batteries whenever you have the opportunity.
After a warning, how long do car key batteries last?
Under normal conditions, the remote control battery in your automobile should last between three and six months. Knowing the battery’s lifespan can help you be ready to replace it if necessary because batteries do not last forever.
The remote battery in your car should last between three and six months, however it could last less depending on several factors including inappropriate usage, storage, etc. Consult a qualified auto technician to determine why the remote starter battery in your car isn’t lasting as long as it should.
Does anything need to be reset following a battery change?
Yes. Your settings will need to be reset. The dealer will typically do it for free, but no guarantees can be made. If you replace a battery and anything was connected to the old one, such as the hose you mentioned, you must reinstall it. Everything is always put back on the same way I took it off. If you find yourself in need of help, think about calling YourMechanic. One of our mobile specialists may visit your house to service your batteries and make sure it was installed correctly. Thanks for reading, and good luck.