It should be noted that the method presented here will work with many various car makes and models. This should apply if your license plate bracket is fastened on with plastic rivets. Chevy Equinox, Cruze, Ford Explorer, Fusion, Chevy Silverado, Subaru, etc. are few examples.
It shouldn’t take more than ten minutes to complete something this simple. Personally, I believe the front license plate makes the car look cleaner, and fortunately, local regulations in my area only call for one rear license plate.
As you can see from the photographs below, it’s quite simple. In order to get access the four plastic rivets holding the holder to the bumper cover, you basically need to remove the plate itself. Simply slowly drill the middle of the rivets using a bigger drillbit. You might need to use some needlenose pliers or another tool to sort of hold the outer edge of the rivet from spinning with the bit if the rivets turn as you’re drilling. Use caution; although it could be enticing to use your fingers, resist the urge.
First, a “before” photo
In order to remove the four plastic rivets, carefully drill them out with a larger drill bit (at least 1/4″), the larger the better up to 3/8″.
Just be careful not to drill through the bumper; you’re simply wanting to remove the rivet.
You should notice this after carefully drilling; take note that the drill bit did not even make contact with the bumper. At this point, the plastic front portion of the rivet separates from the rivet:
The bumper won’t be damaged by using a large drill bit, as you can see from the last image, even if you go a little too deep. However, the plastic plate holder will begin to suffer damage. Therefore, a larger drill bit is preferable. Do the same for each of the four plastic rivets.
My next action was to insert the back side of each rivet into the bumper cover and shake the cover until the rivets’ rear ends fell to the ground. This step is optional; to remove the last piece of plastic, I just used a little awl, but you might equally well use a small screwdriver. Just be careful not to scratch the bumper paint.
Here are the backs of those rivets. Oh well, I only succeeded in convincing 3 of the 4 to resign.
Clean ‘er up; as you can see, the holder has left a very slight mark underneath. I can definitely buff it out, but from another viewpoint, it looks okay.
Well, good luck with your T-Bird or Cougar. Sadly, there are still 4 holes in the bumper cover, but that is the how things are. I intend to fill the holes with little plastic plugs that I will purchase, paint body color, and insert.
In This Article...
What if, in Texas, my car lacks a front license plate holder?
How many license plates must your car have to abide with Texas law? Is there a one-plate requirement or a two-plate limit? Should you make holes in your car’s front bumper to attach a front license plate, or will a rear plate suffice? You may have done a thorough Google search on license plate laws if you are reading this essay out of frustration. Learn what the Texas Transportation Code says about license plates and how it affects you as a driver in Texas.
In Texas, do I require a front license plate? Yes. According to Texas law, every car must have license plates on the front and back of it. Texas currently levies a $200.00 punishment for failing to display a front license plate.
What size screws go into license plates?
A common screw size for license plates on numerous cars is 1/4-14-3/4 inch, which is also the screw size used for the license plate screws on RAM trucks. Ottospeed Rustproof License Plate Screws are a great screw size that work well in all RAM vehicles to fasten license plate hardware.
They are common and fit practically all nylon/plastic screw retention vehicles thanks to their hex head. They are excellent for replacing screws that are not long-lasting since they last for a very long time.
The Ottospeed Rustproof License Plate Screws are excellent and entirely prevent rusting thanks to their 316 marine-grade stainless steel.
Can I mount my front license plate on the dashboard in Texas?
There are laws to keep you safe whether you are traveling on the interstate or parking to pick up a passenger. However, rumors could impair your judgment.
Will sent us the initial email. Is it against the law in Texas for automobiles and trucks to only use the center lane on the freeway? he enquired.
“The general flow of traffic allows for movement in either lane, the inside middle or the right lane. They are not required by law to just use the middle lane, “said Sgt. Standifer.
How about stopping in a travel lane, though? Is it legal for an Uber or Lyft to park and wait in the lane on the main road to wait for passengers? Belinda questioned the VERIFY team.
Texas Transportation Code 545, which regulates halting, standing, or parking in specific locations, is our source for this one.
A vehicle parked at the curb of a street, a junction, or a crosswalk cannot have its operator park on the roadway side, according to the legislation. A passenger or some goods must be picked up or dropped off “immediately.”
Therefore, the position and amount of time that a vehicle is halted determine whether or not parking in a travel lane is permitted.
Deborah, a happy new-car owner, wrote to the VERIFY team with the following: “The front of it lacks a license plate. According to what I’ve been told, individuals no longer place them at the front of some vehicles, and police no longer pay attention to it.”
“You must have a license plate on both the front and rear of the car in the state of Texas.”
Many individuals have it there because they don’t want to drill holes in the front bumper, but since it’s not there, law enforcement has a good reason to pull them over.
You may also receive a citation if the Texas state motto or any other letters are obscured or cut off by your license plate frame, Sgt. Sandifer says.
In California, is a front license plate required?
You might be asking, “Do I need a front license plate in California,” as you prepare to drive your new vehicle on the streets of Los Angeles. Yes, it is the answer. Although some motorists prefer the streamlined appearance of a vehicle without a license plate, driving legally in California requires both a front and rear license plate.
Is a front license plate required in the US?
Most jurisdictions in the US require cars to have license plates on the front and back of the vehicle. It aids in the identification of the car used in a crime or traffic infraction by law authorities. You must have a front plate on your automobile if you reside in one of those states.
“It is simpler to find stolen cars when the plates have two positions (front and back). This is especially valid for police agencies that make use of license plate reading technology “says Steve Albrecht, a former police officer for San Diego.
What is the cost of a ticket in California for having no front license plate?
What is the regulation on license plates in California? The state automobile code mandates that license plates be visible from both the front and back of a vehicle. A $25 fix-it ticket is the consequence.
Is there a front license plate in Florida?
ORLANDO, Fla. – News 6 traffic safety expert Trooper Steve Montiero responds to viewer inquiries about traffic laws each week, assisting citizens in the Orlando region in improving their driving skills via increased knowledge.
Florida is not one of the 31 states that mandate that you have two license plates on your car, according to Trooper Steve. The only part of your vehicle that needs a license plate is the back, according to Florida law.
Drivers are allowed to mount a vanity plate on the front of their car, according to Trooper Steve.
Including an out-of-state license plate is permitted, he added. “Anything from a logo expressing anything you would be a fan of is permissible.” Keep in mind that Florida does not permit any offensive language on license plates, and that a plate from another state cannot be a legitimate license plate.
Regarding the authors:
Trooper Steve, a.k.a. Steven Montiero, joined the News 6 morning team in October 2017 as its Traffic Safety Expert.
Montiero, a native of Central Florida and a distinguished combat veteran, joins the station after serving an eight-year term with the Florida Highway Patrol.
Can you attach a license plate to Velcro?
To answer your concern, the Velcro WILL hold up quite fine. However, if you ever want to detach the component from the paintwork again, there may be a problem. The clearbra, though, would fall off in its place, so it wouldn’t be an issue if you had one.
In Texas, what is the penalty for having no front license plate?
The response: Thirty-one states need front license plates for cars. One of those is Texas. The main motives are security and preventing crime. On security cameras, a car is easier to identify when it has a front license plate. Authorities are far more likely to be able to identify a car on security tape if it has both front and rear license plates when they are looking into a crime involving a vehicle (such as smash-and-grab or other sorts of robberies involving vehicles, hit-and-run accidents).
According to Texas Transportation Code Section 504.943, it is a misdemeanor crime that is punished by a fine of up to $200 if you fail to install and show a license plate on the front outside of your car. In Texas, some drivers opt not to show their front license plate. If you are one of them, be aware that you are giving authorities a justification to stop you and may very probably face a fine.
Do you have a pressing concern regarding H-Town? Send it our way, and we’ll look into finding the solution.
Nevada: Is a front license plate required?
According to Nevada law, all vehicles excluding motorcycles and trailers are required to always show their back license plates. If the vehicle is built to accommodate a front plate or if the maker provides an add-on bracket or frame, you must show both plates.
Front plates are only optional in the following circumstances: 1) the vehicle wasn’t built to accommodate one; and 2) the manufacturer didn’t supply an add-on bracket or another way to show the front plate.
A (NRS 482.275)
DMV provides two plates (except motorcycles and trailers). If the second plate is not on display, it is the owner’s duty to store it and turn both plates in at the appropriate time, surrendering or returning both plates to the department.
License plates must always be plainly visible and firmly affixed to the vehicle so that they cannot swing around. They must also be mounted at a height of at least 12 inches above the ground, measured from the bottom of the plate. It must be kept clean of foreign objects and in a clear, legible condition.
According to license plate standards, plates must be seen in daytime at a distance of 100 feet. When illuminated by normal headlights at night, plates must be readable from 110 feet away. A decal with the month and year of expiration must be visible on the rear plates. A (NRS 482.270)
To help guarantee that license plates are legible and in good shape, the DMV reissues the majority of plates every eight years. See A Reissued License Plate.