When using the Assist Mode on the cluster, you can check the tire pressure.
In This Article...
How can I reset the low tire pressure light on my 2017 Hyundai Elantra?
The first thing you should do if the tire pressure warning light on your 2017 Hyundai Elantra is on is check your tires. As stated on the plaque on the driver’s door jamb, make sure they are all inflated to the recommended tire pressure. You can proceed to reset the TPMS light once all of your tires have been inflated. While the car is running, you should press and hold the TPMS reset button on the dash. Hold the button down until the light flashes three times, then release your grip. After that, you should continue to drive for at least 10 minutes to give the sensor time to calibrate and read the new pressures.
I don’t have a reset button on my 2017 model. My flat tire was fixed, but the light remained on. After speaking with the service department at the local dealer, I learned that the light will turn off after around 20 miles of driving. When I done that, the light turned off.
Turn the ignition key to the “on” position and press the tpms button, which is often found beneath the dash, until the tpms light blinks multiple times to reset the tire pressure monitor or tpms system in your 2017 Hyundai Elantra vehicle. Your vehicle’s tpms system should be reset after starting it and letting it run for at least 20 minutes.
2009–2017 TPMS Tip Featured Elantra, Elantra Coupe, and Elantra Touring from Hyundai
Mitchell 1 contributes TPMS knowledge to Modern Tire Dealer, a highly regarded journal that produces editorial content targeted at independent tire dealers. This story is being shared on our blog along with a link to the Modern Tire Dealer website, where you may read it in its entirety. The TPMS information in this page can also be found in our ProDemand(r) auto repair information software’s reset procedures tab, along with other crucial reset procedure information for the chosen car.
NEED FOR SPECIAL TOOLS? Yes, a TPMS module on a Hyundai GDS (Global Diagnostic System).
The 2011–2017 Hyundai Elantra, 2014 Elantra Coupe, and 2009–2012 Elantra Touring all have tire pressure monitoring systems (TPMS) that use wheel-mounted tire pressure sensors to keep track of the air pressure in the four road tires. The system accomplishes this by using a receiver, four radio frequency (RF) tire pressure sensors, two warning lights on the instrument panel, and a data circuit.
The low pressure warning light on the instrument cluster will turn on if tire pressure falls below the permitted threshold or if a quick leak is discovered. The TPMS warning indication will be illuminated if the system discovers a fault with the receiver or sensor, or if it discovers a defect that is external to the receiver or sensor. The light will remain on during the whole ignition cycle if the issue is deemed “important.”
There are two operating modes for the tire pressure sensor: stationary/rolling mode and sleep mode. The sensor will record temperature and pressure every four seconds while measuring acceleration every 60 seconds in the stationary/rolling mode. To save battery life, the sensor enters a low current consumption state during sleep mode and stops taking measurements. When new, all sensors are in this condition. The sensor won’t communicate unless the commence command asks it to or the speed of the car reaches 20 mph (32 km/h).
All tires must have their air pressure checked and changed to the specified cold pressure mentioned on the vehicle certification label (located on the driver’s door or door pillar) when the low tire pressure warning light illuminates. Repair the tire as necessary if it has been damaged. Make sure the alarm light is turned off. Check the tire pressure again if the warning light remains on. Turn the wheel a quarter turn and wait another four minutes if the tire pressure is satisfactory. There is a TPMS issue if the Hyundai Elantra tire pressure light is still on or the TPMS warning indicator is lighted.
NOTE: It must be started if the tire pressure sensor is replaced. Rotation of the wheels and tires has no impact on the TPMS. Check the air pressure in each tire and make any necessary adjustments when the low tire pressure warning light illuminates.
How are tire pressures checked?
- Remove the cap covering the tire’s air valve, and store it safely away.
- For a few seconds, firmly press the tire gauge against the exposed valve stem.
- Check the air pressure display.
- Compare this value to the tire pressure that is advised.
- Change the air valve cap on the tire.
Why does my tire pressure light come on in Hyundai when my tires are fine?
Several cars now come with a built-in tire pressure monitoring system (TPMS). An indication light will flash on your dashboard if the air pressure in your tires drops below the recommended level.
The information system in the dashboard may have a menu that shows you which of the four tires is malfunctioning. The TPMS indicator may be on in a number of circumstances, however your tires may not require replacement or upkeep.
If this occurs and all of your tires seem to be in good condition. This light may illuminate even if your tires are in good condition for a number of different reasons. The decrease in outdoor temperature is one explanation. To double-check and confirm it, it is advisable to maintain a tire pressure gauge in the automobile.
Do Hyundai’s warranties include tire pressure sensors?
The tire pressure sensors should be covered by your Hyundai’s 5-year/60,000-mile new vehicle limited warranty if you haven’t already replaced them.
How does the tire pressure symbol appear?
The gauge cluster on an automobile’s dashboard is normally where the tire-pressure warning lights are positioned. Warning lights typically have an exclamation point and/or the letters “TPMS” and look like a cross section of a tire in yellow or amber. One may be seen immediately to the left of the speedometer in the image above.
Has the Hyundai Elantra TPMS?
TRW Automotive and Pacific Industrial Corp. are the companies behind the production of the Hyundai TPMS.
The tables below display the models to which they are fitted:
- Accent – Sensors for TPMS
- Toyota Prius – TPMS Sensors
- Sonata – Sensors for TPMS
- Azera – Sensors for TPMS
- Tucson – Sensors for TPMS
- Santa Fe – Sensors for TPMS
- Sensors for TPMS in Veracruz
- TPMS sensors for Entourage
- TPMS Sensors by Tiburon
Grey denotes a lack of TPMS, indirect TPMS, or a discontinued model.
What does the Hyundai Elantra’s TPMS light mean?
Once your Hyundai Elantra has new tires installed, you will need to reset the TPMS. Your TPMS will keep track of the tire pressure and alert you when a tire needs to be inflated. After changing tires, rotating your old ones, and inflating your tires, you should always reset your Hynudai’s TPMS.
How do I reset the TPMS on a 2018 Hyundai Elantra?
Usually found somewhere under the steering wheel, the reset button for the tire pressure monitoring system. Till the tire pressure monitor system light blinks three times, keep the reset button depressed. The sensors should reset about 20 minutes after you restart the vehicle.
What distinguishes TPMS from low tire pressure?
A tire pressure monitoring system (TPMS) is built into your car and is intended to monitor the air pressure in each tire. The Low Tire Pressure indicator on your dash goes on automatically when the system detects a low tire. Until the tires are checked and the pressure is adjusted, this light will remain on.
On the other hand, the TPMS light is intended to turn on when there is an issue with the monitoring system itself. For instance, if a sensor in a wheel malfunctions, the TPMS light will illuminate and remain on until the issue has been resolved.
The maintenance process is not replaced by the TPMS system. Even if the indicator is not on, you should physically check your tire pressure at least once every month.
The informative nature of the aforementioned claims warrants independent verification. kindly visit our
How does the TPMS identify each tire?
The anti-lock brake system’s wheel speed sensors are often used by an indirect TPMS. On-board computer systems can employ these sensors to compare wheel revolution rates between individual wheels as well as to other vehicle operation data, such as speed.
The computer can determine the relative size of the tires on your car based on how quickly each wheel rotates. The computer determines that a tire is underinflated when a wheel starts spinning more quickly than normal and warns the driver accordingly.
So a system that monitors tire pressure indirectly does not genuinely detect tire pressure. The same kind of measurement you may observe with a tire gauge is not being processed electronically. An indirect tire pressure monitor only counts the rotational speed of your tires and sends instructions to the computer to activate the indication light when something seems off with the rotation.