Tire pressure on a Hyundai Elantra is 33 PSI.
In This Article...
How are tire pressures checked?
- Remove the cap covering the tire’s air valve, and store it safely away.
- For a few seconds, firmly press the tire gauge against the exposed valve stem.
- Check the air pressure display.
- Compare this value to the tire pressure that is advised.
- Change the air valve cap on the tire.
Are there tire pressure sensors in the 2017 Hyundai Elantra?
Mitchell 1 contributes TPMS knowledge to Modern Tire Dealer, a highly regarded journal that produces editorial content targeted at independent tire dealers. This story is being shared on our blog along with a link to the Modern Tire Dealer website, where you may read it in its entirety. The TPMS information in this page can also be found in our ProDemand(r) auto repair information software’s reset procedures tab, along with other crucial reset procedure information for the chosen car.
NEED FOR SPECIAL TOOLS? Yes, a TPMS module on a Hyundai GDS (Global Diagnostic System).
The 2011–2017 Hyundai Elantra, 2014 Elantra Coupe, and 2009–2012 Elantra Touring all have tire pressure monitoring systems (TPMS) that use wheel-mounted tire pressure sensors to keep track of the air pressure in the four road tires. The system accomplishes this by using a receiver, four radio frequency (RF) tire pressure sensors, two warning lights on the instrument panel, and a data circuit.
The low pressure warning light on the instrument cluster will turn on if tire pressure falls below the permitted threshold or if a quick leak is discovered. The TPMS warning indication will be illuminated if the system discovers a fault with the receiver or sensor, or if it discovers a defect that is external to the receiver or sensor. The light will remain on during the whole ignition cycle if the issue is deemed “important.”
There are two operating modes for the tire pressure sensor: stationary/rolling mode and sleep mode. The sensor will record temperature and pressure every four seconds while measuring acceleration every 60 seconds in the stationary/rolling mode. To save battery life, the sensor enters a low current consumption state during sleep mode and stops taking measurements. When new, all sensors are in this condition. The sensor won’t communicate unless the commence command asks it to or the speed of the car reaches 20 mph (32 km/h).
All tires must have their air pressure checked and changed to the specified cold pressure mentioned on the vehicle certification label (located on the driver’s door or door pillar) when the low tire pressure warning light illuminates. Repair the tire as necessary if it has been damaged. Make sure the alarm light is turned off. Check the tire pressure again if the warning light remains on. Turn the wheel a quarter turn and wait another four minutes if the tire pressure is satisfactory. There is a TPMS issue if the Hyundai Elantra tire pressure light is still on or the TPMS warning indicator is lighted.
NOTE: It must be started if the tire pressure sensor is replaced. Rotation of the wheels and tires has no impact on the TPMS. Check the air pressure in each tire and make any necessary adjustments when the low tire pressure warning light illuminates.
On a Hyundai Elantra, how do you reset the low tire pressure indicator?
Usually found somewhere under the steering wheel, the reset button for the tire pressure monitoring system. Till the tire pressure monitor system light blinks three times, keep the reset button depressed. The sensors should reset about 20 minutes after you restart the vehicle.
Why does my tire pressure light come on in Hyundai when my tires are fine?
Several cars now come with a built-in tire pressure monitoring system (TPMS). An indication light will flash on your dashboard if the air pressure in your tires drops below the recommended level.
The information system in the dashboard may have a menu that shows you which of the four tires is malfunctioning. The TPMS indicator may be on in a number of circumstances, however your tires may not require replacement or upkeep.
If this occurs and all of your tires seem to be in good condition. This light may illuminate even if your tires are in good condition for a number of different reasons. The decrease in outdoor temperature is one explanation. To double-check and confirm it, it is advisable to maintain a tire pressure gauge in the automobile.
Where is the reset button for tire pressure?
Under the steering wheel is typically where you’ll find the TPMS reset button. Consult the owner’s manual for your car if you can’t find it. All tires should be inflated to 3 PSI more than what is suggested, then completely deflated. Include the spare tire as well, as it can feature a sensor.
How does the tire pressure symbol appear?
The gauge cluster on an automobile’s dashboard is normally where the tire-pressure warning lights are positioned. Warning lights typically have an exclamation point and/or the letters “TPMS” and look like a cross section of a tire in yellow or amber. One may be seen immediately to the left of the speedometer in the image above.
Has the Hyundai Elantra TPMS?
TRW Automotive and Pacific Industrial Corp. are the companies behind the production of the Hyundai TPMS.
The tables below display the models to which they are fitted:
- Accent – Sensors for TPMS
- Toyota Prius – TPMS Sensors
- Sonata – Sensors for TPMS
- Azera – Sensors for TPMS
- Tucson – Sensors for TPMS
- Santa Fe – Sensors for TPMS
- Sensors for TPMS in Veracruz
- TPMS sensors for Entourage
- TPMS Sensors by Tiburon
Grey denotes a lack of TPMS, indirect TPMS, or a discontinued model.
How can I tell if my tires lack air?
- Pull your car onto a flat, shaded area.
- Remove the dust caps from the valve stems of the tires.
- For a limited period of time, firmly press the tip of your tire gauge against the valve stem of the tire.
- If the reading from the tire gauge appears to be unnaturally high or low, such as 85 psi or 1 psi, you should repeat the previous procedure, making sure that the tire gauge’s tip is correctly making contact with the valve stem.
- Press the gauge tip against the valve stem until you hear air leaking out if the recorded reading from the tire gauge is higher than the manufacturer’s suggested rating. Once more, check the tire pressure.
- You must re-inflate the tire if the reading is lower than advised. You’ll need to drive your automobile someplace where there is an air compressor if you don’t have one at home. There may be one at a gas station, but not all do. Driving with a flat tire is dangerous and can harm the wheel itself.
- Press the air hose’s tip firmly against the valve stem to fill the tire. You’ll hear air entering the tire subtly. Check the connection between the air hose and the valve stem of the tire again if you hear air leaking or spraying out.
- Once you believe you have added or released enough air, use the gauge to repeatedly check the pressure.
- Dust off the valves and replace them.
Rastetter underlined the need of keeping dust caps on when driving in the winter since they can prevent flat tires if water enters the valve stem and freezes within the tire.
Check the pressure in your spare tire while you’re at it. You don’t want to have a flat tire and then discover that the new tire is also flat.
Include these actions in your daily routine. Both your car and your wallet will profit from it. For more information, see the video below.
Is there a TPMS on the 2017 Hyundai Elantra?
All American-made automobiles must have direct or indirect TPMS systems fitted as of 2008 as a result of the TREAD Act’s 2007 mandate.
Hyundai produces the Elantra, Elantra GT, and Elantra Touring with a direct TPMS system. If one or more tires on a direct TPMS system indicate low tire pressure, the TPMS sensors will communicate this information to the vehicle’s ECU. Each tire pressure or an indicator light (low-line TPMS system) will be displayed on the dashboard.
What exactly does TPMS on my Hyundai Elantra mean?
System for Monitoring Tire Pressure (TPMS) – page 32 Let the customer know how the TPMS works. – One or more tires are under-inflated when lighted. – When there is a problem with the TPMS, it blinks for about a minute before staying lit.
How can I fill my tires with air without a gauge?
Paying close attention to the little things pays off when it comes to autos. To ensure long-term durability, it entails getting every component in tip-top form. But occasionally, we must complete tasks without the aid of any tools. More particular, there may be instances where we need to fill tires without a gauge. Let’s find out if you’re wondering how to go about doing that.
It’s not required to use a tire pressure gauge to inflate your tires. It aids in obtaining measurements as accurately as feasible. It’s not the end of the world, though, if you don’t have it when the time comes to inflate your tires. Still, whenever you can, you should check the tire pressure. Without a tire inflation gauge, you can:
- Drive as close as possible to the air compressor at your neighborhood gas station.
- Before filling the tires, make sure they are cold.
- The tire’s valve caps should be opened.
- On the machine, adjust the pressure setting. You’ll need to exert personal control over it if this isn’t a possibility.
- Put the nozzle of the air compressor up against the valve stem.
- For 5 to 10 seconds, inflate.
- Check your tire with your eyes or your hands.
- Reinstall the valve caps.
It is feasible to inflate your tires without a gauge. But some specifics will need to be clarified. You cannot precisely fill your tires with air without a tire pressure gauge. Using a few tests, you can get close. Continue reading if you want to learn more about this and other things.
Let us first state that we hope you find the links provided here beneficial before you continue reading. We may receive a commission if you buy something after clicking on one of the links on this page, so thank you!
Where is the button to reset the TPMS tires?
When the tire pressure light blinks three times, release pressure on the TPMS reset button. Start the car and let it run for 20 minutes to let the sensor reset. Under the steering wheel is normally where you’ll find the reset button for the tire pressure monitor. If you can’t find it, consult the owner’s manual for your vehicle.
Driving with the TPMS light on is it safe?
To avoid seeming like Debbie Downer, we’ll simply say no. Driving around with your TPMS light on is not safe. You can’t tell how quickly your tire is losing air or how long it has been over- or underinflated without doing a tire examination. The best course of action is to check the current inflation level of each tire with a tire pressure gauge.
When the tire inspection light appears while you are driving, slow down and get to the closest gas station or service facility.