Here are the official guidelines that my dealer’s service department had written out for me. Most likely, you won’t ever need to perform this. I made a mistake and unintentionally emptied the fluid from my trans. The manual advises replacing ATF every 60k miles if your vehicle sees heavy use.
About 5 liters of transmission fluid are required. Use only the type that is listed in your owner’s manual’s back. My dealer charged me $20 per liter for this. A lengthy, narrow funnel will also be required. When performing this service, the instructions advise replacing the gaskets on all 3 plugs.
First, take out the transmission drain plug from the transmission case’s bottom. Aproximately 5 liters of fluid will be drained. Give the liquid time to drain completely.
Third step: Remove the filler eyebolt I discovered that the square slot in the middle of the eyebolt was the ideal size for my socket wrench extension.
Step 4: Place your funnel into the opening and begin carefully pouring liquid. I discovered that if I proceeded too quickly, it loved to back up and overflow. I needed around 30 minutes to insert all the fluid without having it back up and spill out the aperture. The service counter man advised putting only 4.5 liters at least until you can check the level, even though the instructions ask for 5 liters.
Checking the fluid level is now necessary. This is easier, according to the instructions, with the car on a lift.
Step 2: Use the GDS to confirm that the A/T oil temperature sensor is 50–60 C (12–140 F) warm.
3. At idle, carefully move the selector lever from P to D, then back to P. Repeat. Spend at least two seconds in each position.
Step 4: Lift the car, then take out the oil level check plug from the transmission case’s front side.
Step 5. The oil level is correct if a thin, constant stream of oil emerges from the overflow (level check) plug. An excess fluid level situation exists if extra oil leaks out in a heavy stream. If no oil comes out, there is a shortage and more fluid needs to be added.
Step 6: Reinstall the eyebolt on the filler aperture after tightening the overflow/level check plug after the level is proper. (4.9 to 5.9 NM) Torque
Step 7: Since fluid is corrosive to paint, clean up any fluid that has gotten on painted engine bay surfaces.
In This Article...
When should a Hyundai Elantra have its gearbox fluid changed?
With regards to Transmission Fluid Change The majority of brand-new cars come with automatic transmissions. There is therefore not much maintenance must be done. However, the majority of owner’s manuals advise changing the gearbox fluid approximately every 90,000 miles.
A 2011 Hyundai Elantra’s gearbox fluid may be checked in a few simple steps.
- Access location for transmission fluid: remove dipstick.
- Check Level: To check the level, insert the dipstick and remove it.
- Add Fluid – Select the proper type of fluid and add it.
- Replace the dipstick by repositioning the dipstick and cap.
How do you check the Hyundai’s transmission fluid?
- Make sure the engine is slightly warmed up before checking the gearbox fluid.
- Find the dipstick for the transmission fluid.
- Touch the fluid after removing the dipstick.
- Before repositioning the dipstick, clean it with a rag.
On a Hyundai Elantra, where is the transmission dipstick located?
According to our investigation, your car lacks a gearbox fluid dipstick. These transmissions are made to require no maintenance. Your car most likely includes a check valve on the bottom of the transmission that may be used to check the transmission fluid. We advise having a mechanic check your transmission fluid using a hydraulic lift or an underground bay because your automobile must be level while the fluid is examined. A professional should handle any fluid leaks for this sort of transmission.
Over 100,000 movies by Hans Angermeier teach drivers how to remedy issues with their vehicles. He has extensive knowledge of fundamental repair techniques for the majority of cars on the road.
For a Hyundai Elantra, how many quarts of transmission fluid are needed?
In order to thoroughly clean and wash out the system, a 2017 Hyundai Elantra transmission flush also needs about 10 gallons of fluid.
A Hyundai Elantra’s transmission has a filter, right?
Transmission filter for a 2021 Hyundai Elantra A gasket, pickup tube, and rubber seal are all still there in your 2021 Hyundai Elantra and may need to be changed along with the filter. Every 30,000 or 50,000 miles, the transmission filter on your 2021 Hyundai Elantra needs to be changed.
Is there power steering fluid in a 2010 Hyundai Elantra?
According to our study, your car features an electronic power steering system. These systems don’t have any power steering fluid to leak because they employ an electric motor rather than a hydraulic system.
What much of transmission fluid do I require?
Changing the fluid is a nasty process because there is no drain stopper, but you can do it yourself if you want to. You must get under your car to access the pan at the transmission’s base in order to replace the fluid.
You need a very large catch pan because when you loosen the pan, liquid will start to drip out in all directions. Additionally, you should be aware that the transmission’s old fluid isn’t completely drained away when the pan is removed. There will still be around a third of the old fluid in the torque converter. Since the converter lacks a drain plug, you’re really only performing a partial fluid exchange. Nevertheless, a partial fluid change is preferable to none at all.
Depending on the application, a normal fluid replacement will call for 3 to 6 quarts of ATF, a fresh filter, and a pan gasket (or RTV sealer) for the transmission pan. Before being installed again, the pan needs to be carefully cleaned. This entails thoroughly cleaning the pan’s inside of all fluid remnants and removing all signs of the previous gasket from the sealing surface. Don’t forget to clean the transmission’s mounting flange as well.
Before tightening the bolts on the new filter, make sure it is mounted exactly where the old one was, and that any O-rings or other gaskets have been properly positioned. The bolts should next be tightened to the manufacturer’s specifications.
Be careful not to let any dirt or debris enter the dipstick tube when adding fresh fluid to the transmission. It is advised to use a long-neck funnel with an integrated screen.
AVOID OVERFILLING THE TRANSMISSION. Foaming fluid from excess fluid can result in irregular shifting, oil starvation, and transmission damage. ATF may potentially leak through the transmission seals as a result of having too much fluid.
Until the dipstick indicates full, add a half-quart at a time. The dipstick should be checked when the fluid is hot, the engine is idling, and the gear selector is in Park, so the transmission isn’t actually full yet. Start the engine, move the car around the block, then check the fluid level again while it is idling and top off the tank as necessary.
How much synthetic oil can a 2010 Hyundai Elantra handle?
You can select between conventional and synthetic oil for the Hyundai Elantra. The best choice is conventional oil because it is more economical.
How much oil does a Hyundai Elantra require?
For the Hyundai Elantra, you can anticipate using around 4.2 quarts, but make sure to double-check the details in your owner’s handbook. Change the oil well cap. Use your dipstick to check the oil level before you clean up. If the volume is inadequate, gradually add more oil and keep checking until the level is adequate.
Are there gearbox issues with Hyundai?
You may be having transmission problems if you operate a 7-speed dual-clutch Hyundai, and you are not the only one. Since 2011, our law firm has defended consumers who have experienced Hyundai gearbox issues. These issues now also affect 2016 and 2017 models, in particular the 2017 Hyundai Elantra Eco, 2017 Hyundai Sonata Eco, 2016–2017 Hyundai Tucson, and 2016 Hyundai Veloster Turbo. Hyundai Tucson transmission issues were first covered by us in a 2012 article, and we have since successfully resolved many situations involving them.
Common Hyundai gearbox issues include stalling, power loss, lack of acceleration, and difficulties shifting ratios. Several automobile websites, including Car Complaints, Consumer Reports, and It Still Runs, have written on these problems.
If your Hyundai is having transmission issues, we advise visiting a nearby Hyundai dealer as soon as possible. After every visit, make sure to have repair bills to verify the vehicle’s mileage, days out of service, your complaint, and the fix. These invoices need to be stored securely. When it comes to supporting your assertion with evidence, they are crucial.
Please contact us if you have any questions about a Hyundai that has transmission problems; we’ll be happy to help you out or direct you to someone who can. It’s critical to assert your rights without “stalling” when dealing with Hyundai transmission issues.
Does Hyundai advise flushing the transmission?
To preserve optimum performance, Reliable Hyundai advises changing your automatic transmission fluid every 20,000 to 25,000 miles.
The amount of oil a 2010 Hyundai uses
Oil to use with my 2010 Accent Filtered, 3.5 quarts Check the oil level after refueling. Get your Accent the best synthetic oil. Filtered, 3.5 quarts Check the oil level after refilling.
Uses Hyundai 100% synthetic motor oil?
Full synthetic motor oil is pre-filled in all Hyundai vehicles before they leave the manufacturer and arrive at our showroom. As a result, it is advised to keep using synthetic oil to give your car’s engine the best possible protection. Our dealership has switched to Quaker State Full Synthetic solely to give you the most value and protection for your car, keeping it in top running condition.
The advantages of Quaker State Full Synthetic Oil include:
- Engine Cleaner & Less Wear
- Engine Durability
- increases fuel efficiency
- Start-up and Extreme Temperature Ranges