Remove the bulb from the headlight assembly by rotating it counterclockwise. Place the new bulb in. The little tab on the side of the bulb prevents it from going in any other direction. Once it is in, turn it 1/4 turn in the direction of the clock to secure it.
In This Article...
Instructions
Put the park position on the gear shifter. Remove the key and turn off the ignition. Under the dashboard, release the hood by pulling. Position yourself in front of the Elantra and release the hood clasp. Detach the hood.
The headlamp bolts must be removed. There are three bolts that need to be taken out: two 10 mm bolts and one 12 mm bolt.
Cut the power to the wires. Pull the electrical wire plug away from the headlamp by applying pressure to it. With the headlight removed, the location of the wiring socket for the headlamp is illustrated below.
Take the headlamp assembly off the car. Pull the headlamp assembly for your Hyundai Elantra forward. Be careful, as doing so could result in damage to the front bumper.
- Reverse the steps when installing a new headlight assembly.
- The headlamp bolts should be hand tightened. The plastic clips may break if the headlamp bolts are overtightened.
Replace Headlight Bulb Service
Hyundai Elantra headlight bulb replacements typically cost $109, which includes $14 for parts and $95 for labor. Prices may change based on where you are.
What headlight bulb size is required for a 2013 Hyundai Elantra?
Bulbs for a 2013 Hyundai Elantra Two headlight bulbs are needed for each headlight assembly. The high-beam headlight uses an H1 bulb, while the low-beam headlight uses an H11 bulb. These are made to be direct replacements for the parts in your automobile.
What is the price of a Hyundai headlight?
Depending on the type and if bulbs are included or not, a Hyundai Elantra headlight replacement can cost anywhere from $50 to $1000. Enter the appropriate vehicle information into our search engine to ensure that you are obtaining the appropriate fit.
Can you adjust your own headlights?
When you feel the silicone O-ring seat, push the new bulb in firmly without touching the glass. To secure it in place, turn the bulb (or retaining ring). The electrical harness must be reconnected.
It’s simple to change a headlight bulb. You can replace both of yours in approximately 30 minutes and save $30 in labor (always replace them as a set). The best part is that your owner’s handbook usually always contains a complete description of how to install headlights.
For clear access to the bulb in some modern automobiles, the entire headlight system must be removed from the car (Photo 1). Install the new bulb after removing the old one (Photos 2 and 3). Reinstall and secure the headlight assembly after that.
Is it challenging to replace a headlight?
Even if you have the most expensive wheels, if your headlights aren’t working, it won’t mean much (and as we know from numerous movies and cop shows, a burned-out light will lead to an unwelcome stop by a highway patrol car). Thankfully, changing a headlight bulb is a rather simple procedure.
Tools required:
- brand-new light bulb(s) Make sure you purchase the appropriate bulb type for your car (your local auto parts store should be able to match a bulb with your make and model)
- alcohol-based tissues and wipes (to clean and hold the new bulb)
- tool for Phillips screws
Instead of from the front of the automobile, you’ll access your headlight bulb via the engine compartment. Locate the headlight close to the front of the car by opening the hood. It will be housed in a bulb holder and connected to the bulb by a power connector, which typically has three wires.
Depending on your vehicle, the power cables are connected to a plug at the base of the headlamp and secured by a plastic catch, a metal clip, or a screw cap. Push down on the little lever at the top of the plastic catch as you take the plug out. Hold onto the metal clip as you draw it up and away if you’re dealing with one. When working with a screw cap, turn it counter-clockwise to unscrew it.
Holding onto the base of the old bulb, you should be able to remove the back of the headlight holder after the wires have been severed. In some circumstances, you might need to slightly spin the bulb to release it.
Use tissues or gloves to handle the replacement bulb; you don’t want your skin’s oils to get on it. Before you install it, you should give it a thorough cleaning with an alcohol wipe. When the bulb is prepared, insert it into the plug’s base. No rubber gasket will be seen if it has been placed properly. The headlight holder and power wires can be plugged back in when the bulb has been installed. Make sure to switch on your headlights to test the bulb.
Working with your headlights differs slightly from changing your rear tail lights, which include your brake lights. On some models, you may unscrew the housing that houses the bulb from the outside, while on other models, you have to do so from inside the trunk. To access the bulb after unscrewing the housing, you might need to work with tabs, screws, or tiny knobs on the tail light cover (make sure not to lose the screws if you need to remove them). The electrical wiring won’t need to be taken out, but be careful not to pull the housing out too much lest you rip the wires.
The bulb should be easy to remove by either pulling it out straight (as in most contemporary cars) or by pushing it in while simultaneously unscrewing. Replace the housing and reattach it when the replacement bulb has been installed (screws, tabs, knobs, etc.). Once more, be careful to test the bulb by turning the ignition on and using the brakes.
Will AutoZone replace the bulb in my headlights?
On the AutoZone website, I was able to find the replacement for my broken right headlight bulb. I was going to go there tomorrow to buy a new bulb, but I don’t think I can put it in myself, and I’m not sure if I should make an appointment with a mechanic. Does Autozone perform headlight bulb replacements for you?
In less than two minutes, find out if your auto insurance is being overcharged.
AutoZone can assist you in replacing a burned-out headlight bulb, but only if you bought the replacement bulb from their store and only if the procedure doesn’t involve disassembling the car.
While knowledgeable AutoZone staff members can assist you with a straightforward replacement, the store is not a substitute for a qualified mechanic. They won’t take apart or remove any of your car’s parts to service it.
Not all AutoZones will change your headlight for you, to add to that. You shouldn’t rely on your neighborhood AutoZone to assist you service your automobile because different locations may have different policies. Of course, you may always show up and inquire, but just to be on the safe side, you should probably schedule a repair appointment.
Jerry will automatically produce personalised quotations from more than 55+ top name-brand insurance carriers when you download the app and answer a few questions.
From the app, you can shop and compare prices, manage your policy, and even switch policies! Jerry handles everything, including getting in touch with your insurance, buying your new coverage, and dealing with the tedious paperwork.
Are the headlights on the 2019 Hyundai Elantra being recalled?
Several 2019 and 2020 Elantra (ADa) automobiles with halogen headlights may exhibit sporadic high beam activation. The service procedure to replace the left and right headlight assemblies and carry out aiming adjustments is provided in this advisory.
Are there daytime running lights on the 2013 Hyundai Elantra?
It’s possible that your 2013 Hyundai Elantra is the best car you’ve ever owned. Or perhaps you’re just having trouble keeping it highway-legal. Whatever the circumstance, Advance Auto Parts carries the Daytime Running Light (DRL) item you sorely require.