The battery in your Hyundai key fob is simple to change. A replacement CR 2032 3V battery is all that is required. They typically cost between $3 and $5 for a pack of 5. Wearing latex gloves is advised because you will be contacting a motherboard during this process, which could result in unintended harm.
- Remove the emergency key from the fob’s base.
- Between the release button and the key slot, insert the key.
- Turn the key until the fob pops open as if you were unlocking a door.
- Open the fob while facing the buttons downward (otherwise they will fall out).
- Remove the barrier and motherboard, then set aside the button-side of the fob.
- Remove the dead battery from its mount using the key.
- Place the + side of the new battery in its bracket.
- Replace the fob’s button-half, motherboard, and barrier.
- Set the release button peg in the appropriate hole.
- Reassemble the fob with a snap.
You’re done now! Press any button to put your Hyundai Smart Key to the test. If all was done correctly, a tiny red light should flash over the unlock button.
In This Article...
What type of battery does a key fob for a 2017 Hyundai Tucson take?
A CR2032 battery powers the majority of Hyundai key fobs. Once you have a new Hyundai key fob replacement battery in your possession, insert it into your key fob exactly where the old one was. Check to see if the battery is in contact with each connection.
How is a key programmed after a battery change?
Turn the key back to the “Off” position while holding down the lock button on the fob. At least three times, go through this process, finishing with the key in the “On” position.
This notifies the electronic control modules in your automobile that the signal is coming from your key in the ignition, and it then saves the information.
How can I reset my key now that my battery is new?
The majority of people use their key fob to unlock their car doors and trunk. But what occurs if the battery runs out? You might believe that getting a new key fob requires visiting a dealership or a locksmith, but did you know that you can simply reset it yourself?
This is how:
Find the little button on your key fob first. This is typically found on the fob’s backside.
2. For around 15 seconds, press and hold the button.
3. Release the button after 15 seconds, and your key fob should be reset!
The owner’s manual for your car should always be consulted if you have any issues or inquiries.
Simply press and hold the reset button for a few seconds if your key fob has one. Remove the battery cover and press the tiny reset button on the circuit board if your key fob lacks a reset button.
Where is the Hyundai Tucson’s smart key holder?
This information caught my attention. I think it would also benefit our Palisades!
Fix 1: While tapping the brake, push the Start button using the rear or end of the dead key fob. Fix 2: Place the dead key fob, buttons facing up, in the Smart Key slot (located in the locations specified below), and depress the brake while pressing the Start button.
Slots for Smart Keys: There are three places where these slots can be found: 1. on the front of the center console; 2. behind a panel right below the infotainment control knob; or 3. on the left side of the glovebox when it is open.
How do you unlock the Hyundai key fob?
By pressing and holding the metal tab or button, start by withdrawing the metal key. Next, insert the metal key into the little opening and turn it in either way to release the back cover of your key fob. The case ought to instantly open.
Why won’t my key fob function when I change the battery?
A dead battery is the most frequent cause of a key fob not functioning. Having said that, your keyfob might be having more serious issues. You might require a key fob replacement or perhaps auto door lock repair if your key fob stops operating after a battery change.
How much does a new Hyundai key fob cost?
It’s more likely that you will be allowed to utilize an aftermarket key fob if your automobile is at least ten years old, according to CR’s Ibbotson. Many of these less sophisticated fobs can be configured by the consumer, a local technician, or an automotive locksmith.
Ibbotson advises making sure to phone your neighborhood garage first to confirm that they can do the task, as key-fob programming equipment levels can vary from shop to shop. For instance, a Maryland-based repair shop called Murray’s Auto Clinics informed CR that they are unable to program key fobs for any vehicle with push-button start or keyless entry.
We took our vehicle to M.J. Sullivan Hyundai in New London, Connecticut, where we were charged $120 for programming (one hour of labor), which is what they would have charged us if we had purchased the key fob from them.
Hyundai sent us a laser-cut mechanical backup key for $72.47, bringing the total cost to $272.42 (the car waited at the shop for two days); if we had ordered the key fob through the store, the total would have been $428.92).
For some makes and models, you can purchase a cheap aftermarket fob and program it yourself if your home unexpectedly gains a third driver, such as a teenager.
We purchased a fob from BestKeys from Amazon for CR’s 2008 Chrysler Town & Country minivan. Although it lacks the Chrysler branding on the back, it resembles the two original fobs that came with the minivan when it was new. The uncut mechanical key and internal circuitry were both included in the $14.30 price. (However, we didn’t see the need to shell out the cash to have a locksmith cut that third key.)
Chrysler customers can program a third key fob themselves if they already have two functional ones, just like GM owners can. The owner’s manual contains clear and straightforward programming instructions.
If I change the battery, do I need to reprogram my key fob?
After changing the battery, you typically do not need to reconfigure the key fob. However, you might need to reprogramme it by re-pairing it with your vehicle if you’ve replaced not only the batteries but also some of the internal cabling and electronics.
The best way to start a car without a key
Remove the electronics from the plastic cover that is located underneath the steering wheel. Then, pound or drill a screwdriver into the ignition flaps until it is firmly in place. The screwdriver should then be turned in the same way as an automobile key. This will begin the vehicle.
What is the price of a key fob battery?
These batteries typically cost $10 or less, however some fobs need two. Since it just takes a few seconds, battery specialists and dealers frequently replace the batteries for free.
Hyundai vehicles can be operated without a key fob.
Once the engine is going, the automobile will still work without the key fob. Additionally, switching from park to drive is trouble-free even when the key is not available.
What occurs when the battery in your key fob runs low?
The transmitter’s range decreases as the fob battery gets weaker. This implies that for the key fob to operate, you must be close to the vehicle. When a smart key fob is in your pocket or handbag for automobiles with push-button starts, the car might not always detect it if the battery is low.
After a warning, how long do car key batteries last?
Keyless entry is a fantastic feature, but you can only benefit from it if you keep the technology up to date.
The little things in life can often mean the most, such as not having to search through your purse for your keys or using your key fob to raise and unlock the back doors so you can load groceries.
But what occurs if the fob breaks down? The key fobs for your car require maintenance just like the vehicle itself does.
When anything breaks down, Gary Freeman, owner of C & G Auto in Myrtle Beach, advised against replacing it right away.
“A replacement fob can be pricey; they can cost several hundred dollars, and once you have a replacement fob, they need to be programmed,” said Freeman.
He advises checking the battery as your first action. If you have to press the lock or unlock button on the remote numerous times before it locks or unlocks, it could be a sign that the battery is starting to lose power, according to Freeman.
According to his calculations, the keyless entry remote can be safely stored or hung up anywhere beyond the six to ten feet from which the automobile computer system can read the fob.
According to Freeman, the battery life for the majority of automotive key fobs is three to four years with regular use. Additionally, he claims that the battery life of your fob may be impacted by where you keep it. Freeman advises against hanging the fob near the car or leaving it in the car overnight.
“It (the key fob) does send a signal continuously, so it drains the battery in the key fob and its causing an excessive drainage on the battery of the automobile,” noted Freeman. “A computer is identifying that signal saying I’m ready to start.”
According to Freeman, if the key fob malfunctions, the automobile frequently won’t start because the computer system won’t acknowledge that the key fob is present in the vehicle.
“In most situations, the owners’ manual will clear that up for you, or practically any auto repair facility can replace that battery,” Freeman continued.
Key fobs: Do they have batteries?
The past ten years have seen a significant development in key fobs. Push start systems of today are an evolution of what was once only a convenient technique to remotely lock and unlock doors. Despite the fact that key fob technology is continually evolving, their power source has not changed. Batteries power key fobs and other auto remote controls. That implies that the battery inside them needs to be changed when it runs out of juice. Batteries Plus can assist if your key fob isn’t working as well as it once did. For answers to all of your questions about automobile remotes, including what kind of batteries they need, how long they last, and where to buy a replacement battery, continue reading.
Will a low key fob battery cause the check engine light to appear?
A bad battery will inevitably result in low voltage to the vehicle’s computer, which could turn on the check engine light. Before performing any additional diagnostic testing, the mechanic will test your car’s battery when you bring it in for service.
How long does the battery in a key fob last?
How Long Are Key Fobs Good For? The battery in your car’s fob or remote will eventually need to be replaced, just like any other battery. A car fob battery should typically last three to four years.
Is it possible to start a car without a key fob?
I don’t have a replacement car key and my purse was stolen yesterday. It starts with a push button. I need to start the vehicle so that I may take it to the dealer and obtain a new key. Without a key, how do I start the car?
In less than two minutes, find out if your auto insurance is being overcharged.
We regret learning that your handbag was taken. You will need to utilize a mobile app or hire a locksmith to start the car as you don’t have a spare key and a push-button ignition.
Try a handful of these techniques if you want to start the automobile without the key:
- Start the engine with the Caras smartphone application.
- Replace the electronic control unit (ECU), which, if it detects that someone is attempting to steal your car, disables certain parts of it. But this can cost $1,000 or more, so it’s a pricey repair.
- Just as you would if you had locked your keys in your car, dial a locksmith.
- Ask a dealer what the best cure is by getting in touch with them.
Always keep a spare key or key fob in a protected location in the future. You might also want to think about getting roadside assistance from Jerry or adding towing and labor coverage as an addition to your auto insurance policy.
You can access their nationwide network of more than 55,000 service providers through the Jerry appas industry-leading roadside help. A membership can be purchased for as low as $4.16 per month and includes services like towing, jumpstarts, key replacements, and lockouts!