The battery in your Hyundai key fob is simple to change. A replacement CR 2032 3V battery is all that is required. They typically cost between $3 and $5 for a pack of 5. Wearing latex gloves is advised because you will be contacting a motherboard during this process, which could result in unintended harm.
- Remove the emergency key from the fob’s base.
- Between the release button and the key slot, insert the key.
- Turn the key until the fob pops open as if you were unlocking a door.
- Open the fob while facing the buttons downward (otherwise they will fall out).
- Remove the barrier and motherboard, then set aside the button-side of the fob.
- Remove the dead battery from its mount using the key.
- Place the + side of the new battery in its bracket.
- Replace the fob’s button-half, motherboard, and barrier.
- Set the release button peg in the appropriate hole.
- Reassemble the fob with a snap.
You’re done now! Press any button to put your Hyundai Smart Key to the test. If all was done correctly, a tiny red light should flash over the unlock button.
In This Article...
What type of battery does a key fob for a 2016 Hyundai Tucson take?
A CR2032 battery powers the majority of Hyundai key fobs. Once you have a new Hyundai key fob replacement battery in your possession, insert it into your key fob exactly where the old one was. Check to see if the battery is in contact with each connection.
Why won’t my key fob function when I change the battery?
A dead battery is the most frequent cause of a key fob not functioning. Having said that, your keyfob might be having more serious issues. You might require a key fob replacement or perhaps auto door lock repair if your key fob stops operating after a battery change.
If I change the battery, do I need to reprogram my key fob?
After changing the battery, you typically do not need to reconfigure the key fob. However, you might need to reprogramme it by re-pairing it with your vehicle if you’ve replaced not only the batteries but also some of the internal cabling and electronics.
Where is the Hyundai Tucson’s smart key holder?
This information caught my attention. I think it would also benefit our Palisades!
Fix 1: While tapping the brake, push the Start button using the rear or end of the dead key fob. Fix 2: Place the dead key fob, buttons facing up, in the Smart Key slot (located in the locations specified below), and depress the brake while pressing the Start button.
Slots for Smart Keys: There are three places where these slots can be found: 1. on the front of the center console; 2. behind a panel right below the infotainment control knob; or 3. on the left side of the glovebox when it is open.
How is my car key fob reset?
- Take hold of all of your car’s remote starters.
- Place your ignition key in and select Accessory (or press the start button once without pushing the brake pedal).
- Your remote car starter’s Lock button should be pressed.
- After turning it on for five seconds, turn the key back to the “off” position (or press the start button again).
- The on-off cycle should be repeated a total of four times.
- You’ll hear a sound (a “ding,” “ping,” or “buzz”) on cycle number four when you choose the Accessory position. Right now, programming mode is active.
- Lock the remote by holding down the button (s).
- Turn off the car in ten seconds.
- Shut the door, exit the vehicle, and then try the remote.
- If so, that’s excellent!
- It’s time to call the dealership if it doesn’t.
How much does a new Hyundai key fob cost?
It’s more likely that you will be allowed to utilize an aftermarket key fob if your automobile is at least ten years old, according to CR’s Ibbotson. Many of these less sophisticated fobs can be configured by the consumer, a local technician, or an automotive locksmith.
Ibbotson advises making sure to phone your neighborhood garage first to confirm that they can do the task, as key-fob programming equipment levels can vary from shop to shop. For instance, a Maryland-based repair shop called Murray’s Auto Clinics informed CR that they are unable to program key fobs for any vehicle with push-button start or keyless entry.
We took our vehicle to M.J. Sullivan Hyundai in New London, Connecticut, where we were charged $120 for programming (one hour of labor), which is what they would have charged us if we had purchased the key fob from them.
Hyundai sent us a laser-cut mechanical backup key for $72.47, bringing the total cost to $272.42 (the car waited at the shop for two days); if we had ordered the key fob through the store, the total would have been $428.92).
For some makes and models, you can purchase a cheap aftermarket fob and program it yourself if your home unexpectedly gains a third driver, such as a teenager.
We purchased a fob from BestKeys from Amazon for CR’s 2008 Chrysler Town & Country minivan. Although it lacks the Chrysler branding on the back, it resembles the two original fobs that came with the minivan when it was new. The uncut mechanical key and internal circuitry were both included in the $14.30 price. (However, we didn’t see the need to shell out the cash to have a locksmith cut that third key.)
Chrysler customers can program a third key fob themselves if they already have two functional ones, just like GM owners can. The owner’s manual contains clear and straightforward programming instructions.
What occurs when the battery in your key fob runs low?
The transmitter’s range decreases as the fob battery gets weaker. This implies that for the key fob to operate, you must be close to the vehicle. When a smart key fob is in your pocket or handbag for automobiles with push-button starts, the car might not always detect it if the battery is low.
How often should the battery in my key fob be changed?
Car key fobs are so practical that it’s simple to ignore them. But did you realize that regular maintenance is required for your key fob? Batteries for key fobs should be changed every three to four years, though this will depend on how frequently they are used and how well they are made.
You’d wish you had taken better care of your key fob if it were to abruptly cease working while you were far from home. Avoid being stranded and having to pay for a tow because your key fob isn’t working properly. Here are some red flags that could indicate that it’s time to replace your key fob batteries before it’s too late.
How is the Hyundai Smart Key pry opened?
The case ought to open easily. In order to start, look for a little notch or imprint down the side of your key fob if you drive an older Hyundai car. Then, spin the key fob in either way with a coin or flat-bladed screwdriver to gently pry it open from the notch.
Key fobs: Do they have batteries?
The past ten years have seen a significant development in key fobs. Push start systems of today are an evolution of what was once only a convenient technique to remotely lock and unlock doors. Despite the fact that key fob technology is continually evolving, their power source has not changed. Batteries power key fobs and other auto remote controls. That implies that the battery inside them needs to be changed when it runs out of juice. Batteries Plus can assist if your key fob isn’t working as well as it once did. For answers to all of your questions about automobile remotes, including what kind of batteries they need, how long they last, and where to buy a replacement battery, continue reading.
Can a key fob be programmed without visiting the dealership?
Can a key fob be programmed without visiting the dealership? Yes, you can program the key fob’s locking and unlocking features without visiting the dealership. However, you might need to visit the dealership or a locksmith if you need to program the transponder in order to be able to start the car with the key.
Why won’t my key fob work with my car?
Key fob battery failure The most frequent cause of a keyless entry system failing to send signals is a faulty battery in the key fob. Use the extra key fob to unlock the car and turn on the ignition if one is available. Use the key that is included in the spare fob if it is not available to unlock the door.
Will a dead key fob prevent a car from starting?
Yes, a key fob with short battery life may prevent your automobile from starting. The key fob for your automobile is an electrical gadget with a battery inside that powers signals sent from the key fob to your car. Your car’s computerized systems get alerts in accordance with the key fob commands you press, and the vehicle subsequently reacts as necessary.
This function depends on the battery in your car’s key fob; if it runs out, you might not be able to start your car without a jumpstart. Your ability to start your car may be affected if the battery in your Honda keyless remote is low.