The battery in your Hyundai key fob is simple to change. A replacement CR 2032 3V battery is all that is required. They typically cost between $3 and $5 for a pack of 5. Wearing latex gloves is advised because you will be contacting a motherboard during this process, which could result in unintended harm.
- Remove the emergency key from the fob’s base.
- Between the release button and the key slot, insert the key.
- Turn the key until the fob pops open as if you were unlocking a door.
- Open the fob while facing the buttons downward (otherwise they will fall out).
- Remove the barrier and motherboard, then set aside the button-side of the fob.
- Remove the dead battery from its mount using the key.
- Place the + side of the new battery in its bracket.
- Replace the fob’s button-half, motherboard, and barrier.
- Set the release button peg in the appropriate hole.
- Reassemble the fob with a snap.
You’re done now! Press any button to put your Hyundai Smart Key to the test. If all was done correctly, a tiny red light should flash over the unlock button.
In This Article...
In a Hyundai key fob, what kind of battery is used?
A CR2032 battery powers the majority of Hyundai key fobs. Once you have a new Hyundai key fob replacement battery in your possession, insert it into your key fob exactly where the old one was. Check to see if the battery is in contact with each connection.
I can’t get my Hyundai key fob to open.
By pressing and holding the metal tab or button, start by withdrawing the metal key. Next, insert the metal key into the little opening and turn it in either way to release the back cover of your key fob. The case ought to instantly open.
Why won’t my key fob operate now that the battery has been changed?
A dead battery is the most frequent cause of a key fob not functioning. Having said that, your keyfob might be having more serious issues. You might require a key fob replacement or perhaps auto door lock repair if your key fob stops operating after a battery change.
After changing the battery, does the key fob need to be reprogrammed?
After changing the battery, you typically do not need to reconfigure the key fob. However, you might need to reprogramme it by re-pairing it with your vehicle if you’ve replaced not only the batteries but also some of the internal cabling and electronics.
How much does a new Hyundai key fob cost?
It’s more likely that you will be allowed to utilize an aftermarket key fob if your automobile is at least ten years old, according to CR’s Ibbotson. Many of these less sophisticated fobs can be configured by the consumer, a local technician, or an automotive locksmith.
Ibbotson advises making sure to phone your neighborhood garage first to confirm that they can do the task, as key-fob programming equipment levels can vary from shop to shop. For instance, a Maryland-based repair shop called Murray’s Auto Clinics informed CR that they are unable to program key fobs for any vehicle with push-button start or keyless entry.
We took our vehicle to M.J. Sullivan Hyundai in New London, Connecticut, where we were charged $120 for programming (one hour of labor), which is what they would have charged us if we had purchased the key fob from them.
Hyundai sent us a laser-cut mechanical backup key for $72.47, bringing the total cost to $272.42 (the car waited at the shop for two days); if we had ordered the key fob through the store, the total would have been $428.92).
For some makes and models, you can purchase a cheap aftermarket fob and program it yourself if your home unexpectedly gains a third driver, such as a teenager.
We purchased a fob from BestKeys from Amazon for CR’s 2008 Chrysler Town & Country minivan. Although it lacks the Chrysler branding on the back, it resembles the two original fobs that came with the minivan when it was new. The uncut mechanical key and internal circuitry were both included in the $14.30 price. (However, we didn’t see the need to shell out the cash to have a locksmith cut that third key.)
Chrysler customers can program a third key fob themselves if they already have two functional ones, just like GM owners can. The owner’s manual contains clear and straightforward programming instructions.
What occurs when the battery in your key fob runs low?
The transmitter’s range decreases as the fob battery gets weaker. This implies that for the key fob to operate, you must be close to the vehicle. When a smart key fob is in your pocket or handbag for automobiles with push-button starts, the car might not always detect it if the battery is low.
Can a key fob with a low battery prevent a car from starting?
Yes, a key fob with short battery life may prevent your automobile from starting. The key fob for your automobile is an electrical gadget with a battery inside that powers signals sent from the key fob to your car. Your car’s computerized systems get alerts in accordance with the key fob commands you press, and the vehicle subsequently reacts as necessary.
This function depends on the battery in your car’s key fob; if it runs out, you might not be able to start your car without a jumpstart. Your ability to start your car may be affected if the battery in your Honda keyless remote is low.
How long does the battery in a Hyundai Elantra last?
The typical battery life of a Hyundai Elantra is three to five years, but this might vary based on the weather, the driver’s behavior, the battery type, and other factors. Cleaning the terminals and posts of corrosion with the proper cleaning solution and a wire brush will help you extend the life of your Elantra battery.
Can I customize my Hyundai key fob myself?
Remember that in order for the key fob programming instructions to be effective, you must already have a key fob that has been pre-programmed to a previous Hyundai that you have owned. To have a skilled technician program the key fob to your car if you are buying a new Hyundai, you must go to a Hyundai service center.
Key fobs: Do they have batteries?
The past ten years have seen a significant development in key fobs. Push start systems of today are an evolution of what was once only a convenient technique to remotely lock and unlock doors. Despite the fact that key fob technology is continually evolving, their power source has not changed. Batteries power key fobs and other auto remote controls. That implies that the battery inside them needs to be changed when it runs out of juice. Batteries Plus can assist if your key fob isn’t working as well as it once did. For answers to all of your questions about automobile remotes, including what kind of batteries they need, how long they last, and where to buy a replacement battery, continue reading.
Are key fobs replaced by AutoZone?
AutoZone does offer key duplication services for cars made by Toyota, Ford, Honda, Dodge, GMC, Mercedes, Kia, and other manufacturers. These services include key duplication, transponder keys, key fobs, and vehicle key blanks.
Can a key fob be programmed without visiting the dealership?
Can a key fob be programmed without visiting the dealership? Yes, you can program the key fob’s locking and unlocking features without visiting the dealership. However, you might need to visit the dealership or a locksmith if you need to program the transponder in order to be able to start the car with the key.
Can I set up a key fob on my own?
Yes, a replacement automobile key can be obtained without the original. Since people frequently misplace their car keys, replacing a misplaced car key is an easy operation. Nevertheless, depending on the key type, it could be pricey.
A key fob is a little electronic gadget that you can use to remotely lock and unlock your car. Other capabilities of the fob could include a remote engine starter, a trunk opening, or a proximity system that allows you to open your car without taking the fob out of your pocket.
Depending on how sophisticated the key technology is, replacing car keys can be expensive. An old metal key can be duplicated for less than $10 at a hardware store. On the other hand, the most recent smart keys must be ordered from a dealer and might cost between $200 and $500.
Your car key’s battery can be changed easily by opening it up, identifying the battery type, and going to the store. If you’re unsure of how to open the remote, it pays to consult your owner’s manual because you don’t want to force anything open and break it.
Today’s automobile keys are more secure and capable thanks to technology, but the gain isn’t free. The majority of modern keys feature complex electronic parts that must be configured before usage.
You may be able to buy an after-market key fob via a locksmith or online if your automobile is more than five years old. These sorts of fobs range in quality, but they are less expensive than other options.
You might be able to program a replacement yourself, depending on the make and type of your vehicle. The steps for programming a key fob yourself can differ: Owner’s manuals from certain automakers include instructions. In many circumstances, information can be available online. The catch is that in order to complete the process quickly or at all, you might need two functional key fobs.
It’s wise to acquire and program a backup remote before you require it. Additionally, a lot of used-car buyers (particularly auto dealers) will pay more for a vehicle with at least two functional key fobs or sets of keys.
A misplaced automobile key can indeed be replaced by a locksmith. If you have the option of receiving your replacement key from a locksmith or the dealership, the latter may be less expensive. Before making a choice, be sure to inquire about prices with your nearby vehicle dealership.
What is the same as a CR2032?
A CR2025 battery is a primary, non-rechargeable lithium coin cell with dimensions of 20 mm in diameter and 2.5 mm in thickness. The CR2025 battery has a high voltage of 3V and, depending on the manufacturer’s specifications, a capacity of up to 170mAh. Similar to the CR2032, the CR2025 battery is a very popular lithium coin cell battery that is employed in similar quantities and for comparable purposes. In comparison to items that would utilize a CR2032, the CR2025 is somewhat more suited for usage in those that have less accessible mounting space. On the other hand, when used in identical applications, the CR2025’s lesser capacity (mAh) will result in a somewhat shorter service life than a CR2032.