ADVICE: Despite Honda’s claims, we considered the Rancher 420’s 3 quarts of oil capacity to be a tad excessive. Replace the fill cap, add 2.5 quarts, let the engine run for a few minutes, and then check the level. Don’t screw in the fill cap before checking the oil level in the engine.
In This Article...
Should an oil filter be prefilled?
Your personal preference and the kind of vehicle you drive will determine this. If you have a large, heavy-duty truck, pre-filling the filter makes the operation simpler; however, if you’re just changing the oil in a smaller automobile, it’s not required.
Do you fill your oil filter with oil?
You must add new oil after the old oil has been drained and the filter replaced. Under-filling the oil will interfere with the hydraulic pressure and lubrication of the internal parts of the car.
When should I change the oil in my ATV?
How frequently should the oil be changed should be your first concern. The reply is that it varies according to your ATV. Generally speaking, you should change the oil in your ATV once a year, or every 100 hours of use. To learn more about your particular ATV, though, make sure to consult your owner’s manual. As you read the instructions, make a note of the recommended oil and filter types and purchase them. Don’t just assume what you should get; utilize the necessary ATV oil change supplies if you want to maintain your vehicle operating properly. Consult your owner’s handbook for guidance on this choice.
A Honda Quad needs how much oil?
Step 1: Warm the oil by running the engine at idle for a minute. Next, remove the access panel lid from the left side panel and the dipstick to hasten the oil drain.
2. Place a drain pan underneath the engine, then take off the 17mm drain bolt and crush washer from the engine’s base. Look for signs of wear on the crush washer and replace it if necessary.
Step 3: After properly draining the old oil, reinstall the drain bolt and crush washer, and tighten the bolt to a tension of 18 foot-pounds.
Step 5: Remove the oil filter cover and the three 8mm bolts. Install the new oil filter after removing the old one.
6. Check the oil filter cover’s O-ring and replace it if necessary. Tighten the bolts to 7 foot-pounds before replacing the oil filter cover. Reinstall the seat and right-side fairing next.
Step 7: Add 3.2 quarts of Honda GN4 10W-30 oil—or any other 10W-30 oil intended for wet clutch systems—to the engine.
Step 8: Replace the dipstick, then let the engine idle for about 15 seconds to let the fresh oil circulate throughout the engine. After that, turn off the motor and give the oil a minute to stand.
Step 9: Take out the dipstick, clean it, and replace it in the crankcase without threading it. Check the oil level by removing the dipstick once more. Reinstall the dipstick and the access panel lid after topping off the oil if necessary.
All versions of Honda ATVs require the same or comparable steps to do an oil change. Watch the video below to learn how to replace the oil and filter on a Honda ATV, though, if you want a more in-depth look at an oil change on a Honda quad.