More than 85,000 2005 Honda Odyssey vehicles were subject to a recall in August 2005 after it was found that some front airbag impact sensors were improperly sealed during production. Due to corrosion brought on by water entering the sensor due to a lack of seal, the sensors may completely short circuit.
The frontal airbag may not correctly deploy in the case of a collision as a result, which can also result in the SRS warning light on the car illuminating. The chance of a catastrophic accident or death could consequently rise as a result.
If your Odyssey is affected by this recall, the problem will need to be fixed by having the front airbag impact sensors replaced at an authorized Honda service facility.
In This Article...
How do I turn off the SRS light?
The airbag light connects the seat belt system and the airbag system as part of the Supplement Restraint System (SRS) in automobiles (and vice-versa). When you turn on your automobile, the airbag light comes on for around seven seconds before going out, signifying that the internal system check was successful and finished. When the airbag light either never turns on or stays on while blinking, an issue exists. The airbag light needs to be reset at this stage.
Examining seat belt components, fixing bad clock springs, and replacing faulty sensors are a few techniques for turning off an airbag light. New bulbs or a fully charged battery are other options. While most repairs can be done without a professional, others may.
The following 10 steps will reset your airbag light:
- Turn on and off your ignition.
- Test drive your car when it has been restarted.
- Check the airbag switch for the passenger.
- Check to see if the seat belts are in place and functioning properly.
- Check to see if the passenger seat sensor is off.
- Use a scanner with the ability to reset the SRS or airbag light.
- Fix the broken airbag sensors.
- Replace or repair a broken clock spring.
- Check to see if the airbag is working properly.
- seek for a specialist’s help.
Although not exhaustive, the list above includes tried-and-true methods for tackling the problem. Some of them might not apply to your vehicle because compatibility is always based on the year, make, and model. It is recommended that you have your service manual on hand when carrying out any of these fixes. Always follow the manufacturer’s recommendations, too. Let’s get started on resetting your airbag light right away.
What exactly does SRS on my Honda Odyssey mean?
The supplemental restraint system is referred to by the SRS light. It has to do with your airbags. The light signifies that there is a problem and the system is disabled. To identify the issue and determine the best course of action, we must bring the car in for some testing.
What would activate the SRS light?
Your car’s internal computer has disabled the airbags if the SRS (Supplemental Restraint System) indicator remains illuminated. This indicates that there is a problem with the airbags. Although your airbags won’t deploy at random, they might not in the event of an accident, therefore it’s crucial to locate the issue and have it fixed by a qualified repair.
Your car’s SRS light will come on for around 6-7 seconds when you turn the key, then go out if it detects no abnormalities. You may have an issue with the airbags itself, a loose wire, a broken seat belt buckle, or an issue with the Engine Control Unit (ECU) if the SRS light remains on or starts flashing intermittently. To get you back on the road safely, our mechanics at My Auto Solutions in Buford, Georgia, provide airbag module reset, removal, and installation services.
Drive while the SRS light is on?
One should not ignore the airbag light or the SRS warning when they appear. It doesn’t necessary imply that the vehicle is unsafe to operate, but doing so is risky and akin to playing with fire. When this light is on, it indicates that your safety system isn’t functioning properly and, in some situations, that your airbags aren’t functional and won’t deploy in a collision.
Can I drive safely with my SRS light on? The answer is negative, as there is a significant risk if an accident were to occur, even if it is possible that the airbags may still deploy with the light on. We advise having a specialist examine it and identify the problem so that it may be corrected right away.
What is the cost of turning the airbag light back on?
Reset Airbag Light, at No. 1 This procedure typically takes several hours and costs a few hundred dollars, though depending on the car, it might cost as much as $600.
Can the airbag light be reset without a tool?
Without a scanner, most automobile models make it difficult to reset the airbag light. This is a safety warning since, when the airbag light appeared, you should always fix the problem. Fortunately, if you fix the issue, the airbag light will typically also turn off by itself in many automobile models.
However, in some older vehicles, the airbag light can be reset without a scanner by disconnecting the battery wires.
Make that there are no loose wires or rust in the connector plugs in the wiring system under the driver’s or passenger’s seat. Restart your car after spraying an electronic cleaner on the connecting plugs.
If you can’t detect any issues there, you should really invest in an OBD2 scanner or have a shop interpret the codes because otherwise you’ll have to guess what the issue is.
How much does servicing an airbag cost?
The cost of replacing an airbag can be significantly more than the airbag itself. They take a long time to replace, and the cost of replacing all the linked parts adds up quickly.
Expect to pay, on average, between $1,000 and $1,500 for each replacement airbag. Just the airbags themselves are included; other parts that require replacement are not. A replacement airbag module will cost an additional $600 and above.
Therefore, if your driver’s and passenger’s front airbags have deployed as a result of a frontal collision, you should budget about $3,000 to repair your airbag system. Getting your car roadworthy goes above and beyond bodywork! Is it cheaper to sell your car instead of paying these expenditures to fix it?
Of course, the overall cost of repair for replacing your airbags and/or your instrument panel may vary based on the year, make, and model of your car. As an illustration, the cost to repair the driver-side airbags on a Ford F150 ranges from $200 to $700. The cost of replacing the side passenger airbags in a Honda Civic ranges from $400 to $1,000. Depending on the manufacturer, cars like BMW, Nissan Altima, Toyota Camry, and others may be expensive or affordable.
SRS malfunction: what is it?
Have you ever seen a “SRS” light flash on your dashboard? Few Mercedes owners are aware of what this light signifies. Actually, its full name is Supplement Restraint System. This applies to things like airbags and your safety belts. Your airbags might not deploy in an accident if your SRS is malfunctioning. You can see why; it’s crucial to make sure these things are in good operating order!
- car on loan with extensive repairs
- master certified technicians for Mercedes-Benz
- the most recent diagnostic technology
- a three-year, 36,000-mile warranty
Our staff members are genuine Mercedes enthusiasts, and they will handle your car as if it were their own. Come and enjoy European auto repair with a personal touch, we cordially invite you.
What is the price of replacing an airbag sensor?
Depending on the automobile model and labor charges, the cost to replace an airbag sensor ranges from $100 to $600. A sensor for an airbag costs between $50 and $300, as does the labor.
Both the airbag sensor and its replacement are delicate parts. Even for an expert, correctly diagnosing and installing the airbag sensor can take up to two hours.
The airbag sensor itself is typically not very expensive; you may anticipate paying between $50 and $300 for a brand-new one. Never purchase aftermarket sensors; don’t take the chance. Always purchase OEM original, authentic items.
You can save money by replacing the airbag sensor yourself if you are highly confident working on cars and meticulously following the repair manual.
If you have even the least qualms regarding the replacement, have a pro handle it.
Keep in mind that it is a crucial component, therefore installing it properly is important in case of an accident. Additionally, if you make a mistake, there is a chance that all of the airbags in the car will deploy, which will cost thousands of dollars to fix.
What does SRS on the dashboard mean?
The technical name for the airbag system in your car is called the Supplemental Restraint System, or SRS. You’ve probably come across this moniker if you’ve looked for new car costs, used car valuations, or checked at car inspection checklists when buying or selling a car.
The SRS is a passive safety system, which means that neither the driver nor the passengers are required to operate it. Although airbag systems have been around since 1952, they were still uncommon in cars in the 1970s. Over time, airbag deployment mechanisms have changed and improved. Compared to the initial devices, modern SRS systems are significantly more complex, including algorithms and triggering mechanisms that help reduce unused installations.
Airbag control units receive sensor signals about things like the vehicle’s speed and the impact of a collision, which may trigger the deployment of additional restraint systems. Airbags and seatbelt pretensioners are a couple of these.
Does insurance provide replacement airbags?
Yes, the majority of policies will cover replacing your airbags if the other driver was at fault in the crash (in which case the at-fault driver’s liability insurance would cover it) or if you have collision insurance, which will cover damage to your car regardless of who was at blame.
However, certain vehicles with low cash values will be deemed a total loss by the driver’s insurance carrier if the airbags deploy due to the expensive cost of replacing airbags and installation charges (added to whatever other damage takes place). This implies that rather than paying for repairs, your insurance provider can decide to declare your car a total loss. Because of this, a driver may think of paying for airbag replacement and other repairs on their own, without contacting their auto insurer.
How can I check the code on my airbag light?
Diagnostic Codes for Airbags The airbag codes consist of two digits. To read the codes, count the flashes the light makes, then count them again after the pause. For instance, two flashes, a pause, and four flashes indicate a code 24 issue with your airbag system.
The SRS sensor isn’t there.
A comparable safety sensor is placed inside the vehicle’s passenger area, and the sensor is situated inside the engine. To assess whether the crash intensity exceeds a predetermined threshold and warrants the discharge of an airbag, this safety sensor is necessary.
Where is the SRS module?
- Locate the srs computer module first. Most often, it can be found on the floor in the middle of the dash or under the center console, which is located between the two front seats. The majority of GM vehicles have it under the driver’s or passenger’s seat.
- After waiting three minutes, cut the positive battery cable.
- The wiring plugs on the airbag control module harness are now safe to unplug.