Open the hood to reveal the brake fluid reservoir on the vehicle’s driver’s side, hidden behind a plastic cover. If you’re uncertain of what to check for, consult your owner’s manual. (It’s probably going to say “brake” on it.)
In This Article...
Procedure
- Hood is open. To release the hood, pull the release lever under the dashboard.
- On your BMW 3-Series, find the reservoir for the brake fluid. With a clean towel, wipe the brake fluid reservoir. On the driver’s side, the brake fluid reservoir is located below the plastic cover. To access the reservoir, you must take off the plastic top.
- Establish the Low/Max level. Check the BMW 3-Series’s brake fluid level. By observing the maximum and lowest markings on the reservoir’s surface, you can determine the brake fluid level at the moment.
- Add the brake fluid that is advised. When the level is below the MAX/Full mark, add brake fluid. Avoid overfilling the brake reservoir with brake fluid.
- 316i
- 318i
- 320i
- 323i
- 325xi
- 328i
- 330i
- 335i
- 320d
- 325d and M3
The 2004–2013 BMW 3-Series Check or Add Brake Fluid tutorial is intended to be useful. For additional assistance with your BMW, consult these troubleshooting and repair instructions.
On a BMW, where is the reservoir for the brake fluid?
Open the hood to reveal the brake fluid reservoir on the vehicle’s driver’s side, hidden behind a plastic cover. If you’re uncertain of what to check for, consult your owner’s manual. (It’s probably going to say “brake” on it.) Find the minimum and maximum lines on the reservoir’s outside.
On a BMW 328i, where is the brake fluid reservoir?
On the driver’s side, the brake fluid reservoir is located below the plastic cover. To access the reservoir, you must remove the plastic top.
BMW uses brake fluid, right?
For their remarkable quality and performance, BMW automobiles are adored. But your BMW needs routine maintenance and repair in order to operate at its peak efficiency. An essential step in that procedure is the brake fluid check.
Where is the reservoir for the braking fluid?
While you have the bonnet open, it’s good checking the amount of your brake fluid since the majority of other fluids, such as gearbox oil and power-steering fluid, don’t require monitoring outside of annual maintenance. If the level is low or dropping quickly, it can be a sign that there is a leak in the braking system that could be unsafe and result in brake failure.
The master cylinder, which is often found in one of the back corners of the engine compartment, has a reservoir for brake fluid on top of it. The brake fluid level should be close to the high marking on the reservoir, just like other auto fluids.
Check the owner’s manual or call NRMA motoring assistance at 13 11 22 for the proper sort if you need to top off the level.
What kind of brake fluid is required for a BMW?
It’s time for my two-year brake fluid flush, and because the car is no longer covered by a warranty or maintenance plan, this is the first time I’ll be doing it myself.
It’s an everyday driver. During rush hour, the interstate traffic is frequently stop-and-go. On the track never.
My concern is: For better protection, should I stick with the stock BMW brake fluid or should I swap to another brand? Or would it not be required?
DOT-4 brake fluid is used in every new BMW. Sometimes it is difficult to find, or you can only obtain synthetic DOT-3/DOT-4. I purchased some DOT-4 (“Super 4”) under the Pentosin (German) name at a business that sells vehicle parts for imports. A 1L can and a 1/2L can cost me $16.
Many individuals also utilize the ATE brand, specifically the ATE200 or the ATE super-blue (gold colored).
Thanks. I suppose my biggest concern was whether there was any legitimate justification for me to use something other than OEM brake fluid. especially while I’m driving like I normally do. Would using an aftermarket fluid give me any observable benefits?
In a day-to-day driving scenario, there will be no advantage to ANY DOT 4 over another. I’ve used Valvoline DOT3/DOT4 in numerous BMWs for about ten years. Cheap and simple to find (AutoZone).
If you’re not wasteful, one liter or quart should be sufficient. It wouldn’t hurt to purchase two so you have enough for top-off or the next time.
I also concur with this. Currently, I have Valvoline in both my Z3 and E90. I merely desired a change to something different. Since Pentosin is the original equipment manufacturer’s power steering oil, I assumed that their brake fluid would be adequate for the brake system. It wasn’t too expensive either.
I think Castrol LMA is BMW’s OEM. I was told that many years ago by a parts specialist at Tischer BMW, and I used it for my E30 for a very long period.
Under typical driving circumstances, we advise sticking to the authentic BMW fluid (found HERE).
Flushing is made a little bit easier by switching between blue and yellow on the ATE. Although there is nothing wrong with OEM for daily/street driving, ATE’s price is quite reasonable for a high temperature fluid.
BMW offers brake fluid coverage?
When carried out in accordance with the instructions in the vehicle’s maintenance manual, only the following maintenance tasks are covered by BMW Ultimate Care: Motor Oil. Motor Filter. brake liquid
How can I tell if the brake fluid in my BMW is low?
Look in your owner’s manual to find out how often your brake fluid needs to be replaced. When the brake warning icon appears on the dashboard, it might be time to check the brake fluid. Slow brake pedal response may also indicate that fluid needs to be checked.
Is replacing brake fluid covered by the BMW Service Pack?
a) Engine oil service, engine oil top-up, brake fluid (at third year only), vehicle inspection, air filter, microfilter, fuel filter (only for diesel models), and spark plugs are all included by BMW Service Inclusive.
What occurs if a BMW doesn’t update its brake fluid?
The brake reservoir, where the brake fluid is housed, will become contaminated with moisture if you don’t change your brake fluid as advised by the vehicle’s manufacturer.
Your braking fluid will inevitably become polluted with “debris buildup” as it ages. Your brake system’s many seals and hoses might gradually lose little amounts of rubber as they wear down. Additionally, rust particles may get up in your brake fluid as a result of metal components corroding and rusting due to moisture-rich brake fluid.
Your car’s ability to stop suffers substantially from not changing the brake fluid, which results in subpar braking performance. Most of the time, you can tell by pressing the brake pedal: if it feels excessively spongy, your brake fluid is probably about to fail. You may find that stopping your car requires more work and time, and in some situations, you may even need to pump the brakes in order to build up enough pressure for a secure stop.
If you’re moving at any speed, the uncomfortable idea that your brakes could completely fail is also a deadly one. This may occur if the boiling point of the braking fluid is reached while the vehicle is in motion, particularly if the boiling point was intentionally decreased due to moisture contamination.
What is the lifespan of BMW brake fluid?
The standard recommendation is to replace your brake fluid every two years (or 30,000 miles). Moisture can enter the brake fluid even while your BMW is parked in a garage and not being used, which can result in brake failure.
How do I refill my brake fluid tank?
- Put your car in a level spot.
- If the brake fluid reservoir cap is dirty, clean it to prevent debris from getting into the reservoir.
- Take off the cap. You may need to have brake fluid changed at a shop if the fluid is particularly black or contains debris because it may be past its expiration date.
- Brake fluid should be cautiously and gradually poured into the reservoir until the maximum fill indication is reached.
- Screw the reservoir cap back on firmly.
- Once parked on a flat surface, drive your car for a short while, sometimes braking, and then check the fluid once again to make sure the fill was successful.
Avoid spilling brake fluid on your car or the engine bay since it might damage paint. If you do, wipe it off thoroughly with water. Because it is oily, you can tell when the surface is completely clean.
How frequently should BMW brake fluid be replaced?
Most manufacturers recommend changing your brake fluid every two years, but there are other indications that your brakes require maintenance.
Will a mechanic be required to add brake fluid?
Can Your Car Just Add Brake Fluid? I’ll just say, yes. You can do this yourself without too much difficulty, even though you can have your automobile serviced by a qualified mechanic.
Can you combine brake fluids 3 and 4?
Yes, you can combine Dot 3 and Dot 4 brake fluid. Because both of these brake fluids are glycol-based, they are compatible with one another. It is not advised to fill your automobile with Dot 3 if it came with Dot 4 from the manufacturer, however the other way around is acceptable.
If your vehicle came equipped with Dot 3 and you frequently tow a trailer or drive up steep slopes, we strongly advise replacing it with Dot 4.
Can I drive if my brake fluid is low?
It is doable, but you must quickly refill the brake fluid. Without brake fluid, your brakes will either have an impact or stop working altogether since brakes are hydraulic devices that need on fluid to operate.
Just adding brake fluid is it okay?
You don’t need to add any brake fluid if your brake fluid level is at or above the “MIN” line. Once the reservoir cover has been gently removed, add brake fluid until the level is slightly below the “MAX” line if your fluid level is below the “MIN” line. Avoid overfilling.
How much does it cost to change the brake fluid?
To ensure safety, changing the brake fluid or performing a brake fluid flush should cost between $80 and $130 and be carried out by a qualified mechanic.
Depending on the sort of fluid you have and whether you want to change it yourself, these expenses may fluctuate. Brake fluid generally costs between $6 and $39 per quart, mechanics bill between $150 and 210 per hour, and changing the brake fluid in the majority of cars would set you back on average $100.
If the brake fluid is low, will the brake light come on?
Your car checks the bulbs when you turn it on. On the dashboard of your car, each bulb is lit up. It is turned on as each bulb passes its test. Any light that is illuminated, including the brake warning light, indicates a potential issue that has to be addressed.
The brake warning light is most likely caused by a slight drop in brake fluid level. When it is safe to do so, you should stop, find the brake fluid reservoir using your owner’s manual, and fill it with the appropriate brake fluid. As a result, the brake warning light ought to turn off.
If the brake system warning light is still illuminated, a brake fluid leak can be the cause. Press down hard on the brake pedal when your car is parked in a secure location. The pedal may be leaking if you notice that it slowly descends to the floor. Search for any areas of yellowish liquid under your automobile. If you spot any, you probably have a leak.
Your brake pads may need to be replaced if the brake warning light is still on after you’ve checked for leakage. Your brake pads may have worn out severely if you have this light on. Some automobiles do have a distinct brake pad wear warning light that resembles this.