Turn your key to the “on” or “run” position to reset the tire pressure sensor (TPMS) light on a 2006 BMW 325i. Simply keep pressing the reset button until the instrument panel’s tpms indicator light blinks slowly three times. Additionally, make sure that the tires are inflated to the recommended PSI since if not, the light will start to glow once more. If this does not work, you can drive the car over 50 mph for at least 10 minutes to adjust the sensor. The PSI is very important for your tires because it not only contributes to keeping your car’s fuel economy within acceptable bounds but also to extending the life of your tires.
Simply keep the reset button depressed until the tpms indicator light in the instrument panel blinks slowly three times on a 2006 BMW 325i to reset the tire pressure sensor.
In This Article...
jelliotlevy
The owner’s manual contains instructions. To reset the Flat Tire Monitor, you must operate the computer using the end of the directional signal lever. The crucial point that is not made obvious is that you must carry out this procedure with the car at a complete stop. If you are moving, the computer won’t show the flat tire monitor display. Therefore, you must complete the setup before driving away. The calibration task is then automatically completed. Every time you change the tire pressures, this calibration should be done again.
How can the low tire pressure light be turned off on a BMW?
Click car, vehicle status, tire settings, and tire pressure monitor from the home menu. Select to do a reset when the automobile is stopped and the engine is running. For the reset to be completed, you will need to take a little drive.
Why, when my tires are fine, BMW, is the tire pressure light on?
What it means: Your vehicle’s tire pressure will be too low and the BMW tire pressure monitoring system (TPMS) will notify you. When air pressure is 25% below the usual suggested pressure for your BMW model, the warning light turns on. Low tire pressure could put your BMW at danger for tire failure, excessive tire wear and tear, handling issues, and decreased fuel efficiency.
What to do if it comes on: Turn off your car and check the pressure in each tire if the TPMS light comes on when you start it. Ensure that the tires are inflated to the optimum pressure. The recommended tire pressure is printed in your owner’s handbook or on a placard inside the driver-side door of your car.
Find a gas station with air pumps, check the tire pressure, and add air as necessary if the TPMS indicator illuminates while you are driving. The TPMS light will also come on if your tire suddenly flattens as a result of damage. Pull over right away and inspect your tires if you see this light and experience a difference in how your car handles. Many BMW automobiles come with run-flat tires already mounted from the manufacturer with no spare tire. If so, move cautiously to a BMW service center in the area. You will need to hire a tow truck if you have fitted aftermarket tires that are not run flats.
It often denotes a TPMS malfunction if the indicator glows and flashes. The first step is to check the pressure in each of your tires once more and add air if needed. Your best option is to take it to a qualified BMW mechanic for diagnosis if the TPMS light is still on after adding air.
Note: Extreme weather changes can have an impact on tires, particularly in the colder winter months. It’s a good idea to inspect your tires each month.
What actions are required to turn off the light: If your tire pressure is too low, you should fill them up with air and then reset your TPMS (see the directions in your owner’s manual to do this). If this doesn’t work, you’ll need to visit your local BMW repair shop for an accurate diagnosis.
Can the BMW tire pressure monitoring system be turned off?
My incoming F30 will most likely feature TPMS pressure sensors, but since the winter wheels I purchased don’t have the sensors, can I disable the pressure monitoring system to avoid seeing an error message on the dash?
It won’t cost much more to add TPMS to each wheel, therefore you’ll need to pay the extra money. Not in my experience, at least. You may just take the TPMS from your old wheels and install it on your new ones if you’re getting rid of your stock wheels totally.
In the winter, I operate my winters without sensors. Nothing to worry about. I simply need to press the iDrive wheel during startup to acknowledge that the issue has been identified.
I had assumed that there would merely be an error, which would be bad enough, but pressing the idrive button each time I got into the car would be quite annoying! I’m hoping the fuse trick works flawlessly!
I don’t mind the double-press for the TPMS warning because you already have to press the iDrive on startup to accept the warning.
If pressing a button bothers you, the cost actually is not a huge deal because I was able to purchase secondhand OEM sensors for my 19’s for under $200.
According to what I can see for UK models, it isn’t even optioned. Wheel swapping is not a problem if you have the regular UK fit TPWS because we don’t have wheel sensors.
How can a tire pressure monitoring system be reset?
When the tire pressure light blinks three times, release pressure on the TPMS reset button. Start the car and let it run for 20 minutes to let the sensor reset. Under the steering wheel is normally where you’ll find the reset button for the tire pressure monitor. If you can’t find it, consult the owner’s manual for your vehicle.
How can I make my low tire pressure warning light come on?
When the tire pressure light blinks three times, release pressure on the TPMS reset button. For the sensors to reset, start the car and let it run for 20 minutes. The button to reset the tire pressure monitor is under the steering wheel.
How can my BMW 3 Series be reset?
The mechanic will reset the computer in your BMW after the service is complete so it can record your mileage and let you know when the car will need maintenance again in the future. However, the techniques listed below can help you if you maintain your own car but are unclear of how to reset the computer system.
- With the engine off, turn the key to the ON position.
- For TEN seconds, press and HOLD the ODOMETER button. It can be found at the Instrument Cluster’s extreme bottom LEFT corner.
- The dash screen will display FGSTNR along with a number. Your chassis number is this (See image example).
- The LAST FOUR numerals are added. Ex: 3+4+5+6= 18 (taken from the image above). Your UNLOCK CODE is going to be 18.
- Press and hold the ODOMETER button one more until the FGSTNR clearing area appears (you will still see numbers in the top section).
- Press the odometer button until the upper Menu area (entering code menu) reaches 19 after the bottom area has cleared; When you do, the text will appear at the bottom: Press the odometer button to enter your unlock code after turning the lock on (from the example above) This is seen in the bottom portion.
- The screen will appear as in the image above after a little period, at which point the menu will once again appear at the top. To access the number 21 menu, press the odometer button (also theentering code menu).
- On the screen’s bottom, it will say: RESET? To complete the reset, press the odometer button.
Your BMW’s computer has been restarted! The existing settings must now be added again, or new ones must be added.
**NOTE: Slowly repeat the procedures if you are unable to reset the BMW computer on your first attempt. If you’re still having trouble, ask the dealership for help or refer to your car’s owner’s manual.
My tire pressure is fine, so why won’t the light go off?
When the TPMS warning light illuminates, proceed with caution. This indicates that at least one of your tires may be at least 25% under-inflated.
*The simplest way to get the most accurate reading is to check the tire pressure before you drive on it when the tire is “cool.” If your TPMS light is on, first check that you have correctly reset your TPMS by following these instructions.
Will my TPMS light automatically turn off if I fill my tires with air after it illuminates?
Several minutes after reinflating the tires to the prescribed pressure, the TPMS light ought to go out.
What happens if I adjust the tire pressure but the light on my tire pressure gauge still doesn’t go out?
The only place that can fix a computer issue that causes the TPMS warning light to turn ON and flash ON for one second and OFF for three seconds is the dealership service center. When the TPMS warning light illuminates and remains on, one or more tires may have low tire pressure. The light ought to go out once the tire is inflated to the recommended tire pressure listed on the door placard. Always check the pressure in all of your tires because one or more of them may not be at the proper pressure.
What PSI should the tires on a BMW be?
To ensure a safe ride, you should check the tire pressure on your BMW. Although 32 PSI (pounds per square inch) is the recommended tire pressure for most BMW models, you should always double-check by examining the sticker on the inside edge of the driver’s door.
On a BMW, how do you reset the red exclamation mark?
Start the engine, then move through the obc until you find the word RESET next to the “flat tyre” sign. To choose, press the stalk’s tip. A tick should display after about 5 seconds of pressing and holding; just drive away, and it will reset itself. Don’t wait for any confirmation because there are no other signs that it has done it.
All owners and aficionados of BMW’s 1 and 2 series have their own forum community. Join the conversation regarding performance, customizations, classifieds, troubleshooting, maintenance, and more!
Will the tire pressure light automatically turn off?
Tire pressure can be impacted by overnight temperature variations or by cold winter days. The low-pressure indicator may then display as a result of this. The pressure in your tires can change by up to 10 PSI when there are significant temperature changes between day and night.
After about 20 minutes of driving, the light may turn off on its own when the right inflation level stabilizes and the air in your tires warms and expands.
In any case, you ought to have your air checked immediately. Your tires are at least 25% underinflated, according to the TPMS light. This poses a risk to your safety, especially if the load is close to your vehicle’s maximum load capacity. There is a higher possibility of tire failure, degraded handling, and increased tire wear and tear. Your fuel economy may also suffer.
Is driving permitted while the tire pressure light is on?
You should be able to find our store or an air pump if the light just came on and you need to get there. However, it is unsafe to keep driving while the light is on. This is why: When you drive your car with low tire pressure, you accelerate the premature and severe tire wear.