Registered
Read an interesting post about this. I want to know what happens if you disconnect the battery because I’m new to iDrive. or disable the iDrive’s control fuse?
I’m not sure, but you might not want to completely disconnect the batteries in a BMW without taking some precautions because I’ve heard that if the car loses all power, it might enter an anti-theft mode. I’m not sure because I don’t work on my autos.
Anyhow, that wasn’t the type of reset the OP was referring about.
When you lock the car and turn it off, iDrive completely shuts off for roughly 12 minutes. In most BMWs, you can restart the computer for the idrive system, navigation, etc. by holding down the volume button for 20 to 25 seconds constantly. The volume is only momentarily turned off when the volume button is pressed; the system is not restarted.
In This Article...
How can I restart the media player in my car?
First, press and hold the power button for a short period of time. Step 2: In some cars, you’ll see a list of features. Step 3: Tap on reboot to restart the radio after it has been turned off.
How can the BMW iDrive service be reset?
Find the tiny odometer button in the instrument panel’s lower left corner. until the service message shows, press and hold. When the message says “Reset,” let go of the button and press and hold it once more.
How is the BMW instrument cluster reset?
The Sel/reset button should be repeatedly pushed and released three times. The instrument cluster starts its internal evaluation. Every time the Sel/reset button is pressed again, all the gauges cycle through once more. If the vehicle speed reaches 1.5 mph, turn the ignition switch to the OFF position to end.
How can I restart my BMW now that the battery is new?
Here are the instructions so that you can see how crucial the BMW computer reset is after reading the preceding explanation.
- Once the lights and radio are turned on, first switch the ignition key of the BMW automobile to the accessory position. This must be completed prior to starting the car. Then, hold down the “Trip” button on the instrument panel for a few seconds until the red light appears.
- Once more, press and hold the “Trip” button until Reset appears.
- Press the same button a third time after that. The BMW computer will quickly reset now.
BMW automobile battery replacement and computer reset are both inexpensive procedures. The sooner you complete this, the easier it will be for you to operate your BMW vehicle. Despite all of these facts, this surgery should not be taken lightly. There are auto repair shops with qualified experts who adhere to the manufacturer’s warranty guidelines. To receive a safe and secure service, consult these businesses.
How do I clear the screen on my car?
While touch displays are beneficial, they are undoubtedly useless if they aren’t functioning. Here are some actions you can do to solve the problem with your caras touch screen in terms of troubleshooting:
- Get your touchscreen clean.
- Switching the touchscreen back on and off will restart it.
- From the settings menu, adjust the screen’s calibration.
- Reset the factory settings
If taking these actions doesn’t solve your problem, you might have a bigger problem that requires replacement or repair.
Depending on the replacement you select, the cost to have a professional replace your car’s touch screen might range from $100 to $300.
Since you’re spending the time to maintain your vehicle, use the Jerry app to find the best auto insurance at the lowest price.
After you download Jerry, all you have to do is respond to a few questions that will take you around 45 seconds to do, and you’ll get car insurance rates for coverage that is identical to your current plan right away. Customers of Jerry save $887 year on average.
How can I restart my vehicle’s music system?
- Your automobile stereo’s faceplate should be removed.
- Using a pointed device, such as a ballpoint pen, press the RESET button located on the front panel.
NOTES:
- These procedures may differ slightly based on the model number of the in-dash automobile audio receiver that you are using.
- To totally reset car stereos with Bluetooth wireless functions, you must follow the Bluetooth Initialize procedure.
Why is my BMW’s screen malfunctioning?
Since you are still covered by the warranty, take it to the dealership. Check to check if the computer on your automobile reboots after 20 minutes of sleep. The blank screen is a frequent issue, and it usually goes away after restarting the car. Since you are still covered by warranty, bring it to the dealer.
What does a car hard reset entail?
Even though they both appear to be able to eliminate the codes, a hard battery reset won’t take the place of a useful diagnostic tool. However, combining the two can save you a ton of time and effort in trying to identify the source of your electrical problems.
By performing a hard reset, you effectively start over. Once you’ve completed this, scan the car to look for any problems. If there is a hard code, it will either come back right away or after a certain number of kilometers.
It is extremely comparable to restarting your computer and running crucial malware removal software to assist you in getting rid of viruses and spyware. The similar idea can be used with automobiles. Both are useful in their own right, but when utilized in tandem, things can go forward more quickly.
Universal scan tools will work with the majority of automobiles. A less complex and more affordable scanner can assist with troubleshooting the check engine, but if other computer modules aren’t operating properly, you’ll need a more expensive scanner. Here is a list of my top scanners.
The specific error codes will be displayed by a diagnostic scan tool. You may find out exactly what that code signifies in detail and potential fixes by conducting a quick online search for it. On the scanner itself, certain scan tools provide service bulletins and recommendations, which is quite helpful.
How can I check the service on my BMW iDrive?
If your car has iDrive, you may retrieve the service history by going to Vehicle Information -> Vehicle Status -> Service Requirements -> Service History. You may see illustrations that outline each step on the left side of the page. You will also be able to see the dates of the most recent maintenance and the work that was done if your automobile was built after March 2009.
Additional methods for gaining access to your car’s history are as follows:
- You should check the warranty details, as a good reminder. This will inform you of any remaining coverage or associated benefits. as well as looking over the vehicle health report. This will give you a general idea of the situation and any problems that can arise.
Do you need to reprogram your BMW after changing the battery?
Let’s first focus on what BMW battery registration genuinely is before delving into the procedure. Battery registration, to put it simply, is the process of notifying your car that a brand-new battery has been installed. Importantly, it must be done every time you replace the battery in your BMW, model year 2002 or later.
The car adapts the amount of energy required to recharge to operate at peak levels as your battery ages and gradually loses its ability to charge. The battery needs more charging the older it is. By registering your battery, you can inform your engine control module (also referred to as DME — Digital Motor Electronics) that a new one has been installed. As a result, the vehicle will reset the old battery statistics and won’t attempt to overcharge the new battery under the assumption that the old one is still in place.
In addition to registering, you must also code your BMW computer. No matter how different or similar your new battery is from your previous one in terms of specifications, it will still be necessary each time you change it.
How can I watch Netflix on the screen in my BMW?
You can’t share and watch your favorite shows with your friends and family in the car since the screen on your phone is too small. The amazing thing about BMW is that you can use screen mirroring to stream Netflix from your Android or iPhone into the iDrive screen. BMW screen mirroring is an easy idea to understand.
With this technology, you may mirror the material on the screen of your phone on the iDrive display and stream audio through the vehicle’s speakers.
If you combine the screen mirroring module with your mobile device, you may instantly access your favorite apps, like Netflix to play a movie for your passengers. However, screen mirroring is only possible when the automobile is parked.
The steps are as follows for setting the screen mirror:
- Visit the car’s communication area.
- Decide on “Mobile Devices.”
- Tap or click “New Device” in the right section.
- Once you tap it, you’ll see a “Screen Mirroring” option; select that.
- Enter your phone after you’ve finished that. Turn on “Smart View” by slidding down on the taskbar. You can perform a screen mirror using this.
- When it detects BMW, you will see it on your phone and can tap it.
- Tap “Yes” to approve the connection on the car’s screen. Give it some time to click.
- Your phone will now appear on the screen precisely as it is, indicating that you are now connected. Only your phone may be used to control it; not your iDrive display. Finally, you may select Netflix on your phone, and it will start playing on the screen in your car.
The YouTube video embedded below demonstrates how to screen mirror Netflix in your BMW.
What iDrive version do I have on my BMW?
The iDrive system’s navigation is a crucial component that makes getting from A to B simple. But since roads and sites of interest constantly change, it’s critical to maintain your BMW’s GPS maps updated if you want to get the most out of your iDrive.
Many of the most recent BMW models include over-the-air (OTA) map updates, which use the vehicle’s integrated SIM card to automatically download the most recent map data. The procedure in these automobiles is comparable to updating your smartphone to the most recent iOS or Android version; all you have to do is restart your car after your iDrive has downloaded the data.
For vehicles that do not allow OTA updates, a manual upgrade is necessary. Previously, updating BMW navigation maps required changing a DVD holding the map data. More newer vehicles include built-in hard drives that hold the data, allowing you to update your map by overwriting the hard drive’s contents. You can accomplish this with BMW by connecting a USB stick with the updated map data to the USB port in your vehicle.
It’s a good idea to determine which map version you need, which relies on your iDrive system, before purchasing a new BMW map. Use the settings menu when your iDrive navigation is open to navigate to “Navigation system version,” where you can see the region, version, and year of your current GPS data.
I need to reset iDrive for a new owner.
A 2012 650i Convertible with 23K miles was recently purchased. It is preloaded with voice recordings and radio/navigation presets from the previous owner. Just a ton of info that has been preserved. Is it feasible to remove everything from this and transmit it in its original form?
Definitely helpful Google link I bet you’ve been waiting forever to pull that sleazy trick on someone.
I am aware of how to delete radio presets, but I would like to know how to delete everything, including navigation history, store data, radio content, all drivers, and all recorded music.
There must be a technique they employ to accomplish this when a car is traded to the dealer, right? They are unable to assign a tech to delete each and every item, and searching for everything takes hours.
Go to settings from the iDrive main menu. Position the iDrive controller to the right while in the settings menu. After that, move it to the right one more time to see the option to remove all personal information. I haven’t used it, but it’s in my car.