1. Bend one (short) side of an old credit card (or anything similar) at a 90-degree angle. 2. Place the card in the space between the a/c and the radio.
In This Article...
Equipment needed to remove the CCC head unit from a BMW E90:
- Screwdriver, flat
- Phillips screwdriver that is long
- Trim Disposer
Step 1: To begin, take off the upper trim, which is the wooden or plastic trim that has air vents on it.
The upper trim on both sides can be unlatched using the trim remover. If necessary, disconnect the cable on the back, then slide the trim out of the way.
Step 2: Next, take off the lower-trim, which houses the climate control. You can easily unlatch the lower trim with just your bare hands because the upper trim is out of the way. It should be simple to remove; little force is required, and a little wiggle might be helpful.
You’ll need to unplug the two connectors attached to its rear in order to fully remove it. Before you can remove the connectors, you must pull up on a little lever on each one.
3. Continue with the bottom trim, which has radio controls and configurable hotkeys. To unlock it once more, use the trim remover on both sides. Since the trim is merely a plastic cover, it should be simple to remove.
Step 4: The CCC unit should be visible after removing the bottom trim. Now remove all four screws using a Phillips screwdriver.
Step 5: In order to remove the CCC head unit without the shift getting in the way, you might need to put your car in Neutral. After that, slowly remove your CCC device.
Step 6: Five separate electrical connectors are added to the back of the CCC unit. Remove each connector one at a time.
Quadlock connector is at position 1. Apply pressure in the area and in the direction indicated by 1a to release the Quadlock. While pulling in the direction of the circular arrow 1b. You are turning a somewhat movable portion of the connector with this movement. The connector may now be pulled out by rotating it. Use a little push to now slowly pull the connector out.
A zoomed-in image of the quadlock connector being released and drawn out is shown in Figure 9 below.
Additionally, connectors 2 and 3 have a tiny piece that is keeping them from moving. Push a little bit in the area and the direction indicated by the yellow arrows in Figure 8. Pull the connector out gently as you do this.
We hope that our guide has made it easier for you to take the CCC head unit out of your BMW E90. If you have anything to add, do do it in the comments box below. We welcome feedback from our readers!
Looking at our other articles may help you find the answers to any queries you have concerning the iDrive system and various models that weren’t covered in this one:
- If you have the CIC version of the iDrive navigation, visit our CIC iDrive repair page.
Would you like to add anything more to this discussion? Please use the comment form below; we read every message that comes in. Your assistance in making this article more educational would be much appreciated by our readers.
– To begin, you must take off the center console’s plastic cover from below the A/C unit. Grab it firmly and drag it backwards in a straight line.
– The A/C unit (along with the trim) can now be removed. Simply pull it in your direction. It is secured on each side and end.
The console cover and A/C unit can be removed by unclipping the three connectors on the back of the A/C unit.
The two screws holding the radio in place should now be visible. Lift the radio out after loosening them. The main radio connector and the antenna connector should be unclipped.
– If you wish to eliminate the upper dashboard storage area Remove the entire dash trim first.
It is one piece, and multiple “male/female” style clips are used to fasten it to the dash. Start on the far right side and carefully insert a screwdriver below; it will gradually pop out.
The three torx screws fastening the dash compartment should now be visible. Simply loosen these and lift the compartment out.
I followed this process to install my TomTom XL in the dash. I used 12 volts that I got from the lighter cords.
I created a “slide mechanism” to permit a permanent TomTom installation that is hidden from the outside.
Hello, is it possible to display images of your artwork? I’m interested in your TomTom XL navigation system.
On a BMW, where is the radio code?
Look in your owner’s manual to find your BMW radio code. Even a white sticker on the front or back cover can have it. Once you have it, enter the code using the numbered radio buttons. You can now listen to your favorite stations while driving with the radio working again in your BMW.
Should I unplug the battery from my car before removing the radio?
For the first time, I’m upgrading the sound in my car. I want to know if disconnecting the battery is necessary before I begin while installing the stereo.
In less than two minutes, find out if your auto insurance is being overcharged.
It’s fantastic that you inquired because the battery must always be disconnected when installing a car audio.
To prevent electrocution, you should always make sure the battery is unplugged before working on anything electrical in your car. Start by cutting the battery’s ground wire, which is black, from the current stereo before disconnecting the battery. After that, you can start the replacement!
Jerry is an excellent place to start if you’re seeking for further methods to improve your car. Jerry, a registered broker with a highly regarded amazing app, gets the best and most economical auto insurance that is tailored to your car. Jerry then takes care of the inconvenience of purchasing new insurance and terminating your old coverage so you don’t have to after you’ve made your decision.
Jerry will set you up with brand-new insurance to go with your stereo in less than a minute.
How can I change the radio’s security code?
A few months back, I purchased a used car, and it has been functioning flawlessly. The radio has been acting strangely lately, and when I switch it on, CODE is now shown. How can I turn the car radio back on?
Your radio is locked if the CODE display is shown. If the car has just undergone maintenance, had other settings restored, or had the battery replaced, this is a typical occurrence.
You will need to enter a code to go beyond the car’s security system in order to open the radio. This code can be found in several places, most notably:
- in the owner’s guide. In the owner’s manual, look in the radio/stereo or security sections to find the code quickly.
- See whether the manufacturer has a database of stereo security codes by visiting their website.
- Find out whether your nearby dealership can give you the code or unlock it for you by going there.
The following measures should be used if you are unable to locate the code and the dealership or installation facility was unsuccessful in unlocking it:
- Just turn the ignition on, not the engine
- Turn off the radio.
- To reset the radio, press and hold the power button for a few minutes.
If this initially doesn’t work, hold the power and seek buttons down simultaneously or for a longer period of time. Hopefully, one of these techniques will get you jamming out once more right away!
Review your your insurance coverage and download the Jerry app while you wait for a technician to unlock your audio. Jerry is the quickest and best way to locate a car insurance plan that is specially tailored for you.
Jerry will handle the phone calls, paperwork, and renewals for your top option after giving you a thorough cross-analysis of the best plans across providers so you won’t have to. Even your old policy is cancelled!
With no code, how do I open my radio?
- Start the engine.
- If CODE appears on the screen, turn off the radio.
- For 40–50 seconds, hold down the Power/Volume button.
- In less than a minute, your radio should be unlocked.
What is the cost of removing a car stereo?
The labor expenses involved with any automotive work, including replacing a car head unit, are directly influenced by a variety of factors. Knowing how long it should take for them to install the car audio will help you avoid being overcharged.
Frequently, you can request a breakdown of costs. The receipt typically includes a labor section.
It takes between half an hour and an hour. A skilled auto electronics technician should be able to repair a car radio head unit in 30 to 60 minutes.
Hourly rates vary depending on the type of garage and the location; most independent auto shops charge between $70-$90 per hour, while most dealerships charge between $80-$125. Major companies like BestBuy and Walmart also install stereos, typically for a flat charge of around $100, although most people are unaware of this.
The cost of labor may also depend on your state and locality. According to a survey by CarMD, Vermont had the lowest labor costs and Colorado had the highest, with a difference of almost $35 in the hourly rate paid.
The majority of dealerships price between $80-$125 per hour, while the majority of small auto shops charge between $70-$90. Major companies like BestBuy and Walmart also install stereos, typically for a flat charge of around $100, although most people are unaware of this.
Has the 2007 BMW X5 Bluetooth?
The Positive The 2007 BMW X5 has a lot of positive aspects, but its handling stands out in particular. The car’s Bluetooth cell phone system functions flawlessly inside, and the music system sounds great and can play a variety of audio sources, including MP3s. The appearance of the electronic shifter is also intriguing and sculptured.
Has BMW got a secret key?
Have you ever locked yourself out of your BMW only to discover that your key fob’s battery is also dead? There, many of us have been. However, there is a shockingly simple solution—your key fob really contains a concealed key. A
Even if your key fob dies, you can still unlock your BMW. Simply slide the mechanical key out by holding and pressing the key release tab at the bottom of the key fob, close to the key chain. The driver’s side door can now be unlocked as usual using a conventional key. Congratulations! You’ve opened it and are now prepared to leave.