A BMW battery should only be charged using the jump start connectors found beneath the hood.
- Use the emergency key that can be located within the key fob to unlock the driver’s door.
- Open the hood by twice pulling the hood release.
- Under the engine bay, find the positive terminal.
- Connect your charger’s red clamp to this post.
- Look under the hood for the negative terminal. A marked copper post belongs to BMW. Connect the black clamp to one of the strut tower bolts if you are unable to locate the negative (ground) post.
- the kind of battery to use. On the battery’s top, the type of battery is printed. The battery will either be an AGM battery or a regular/lead acid/flooded battery. It is most likely an AGM battery if the battery has a black case. It is a standard or flooded battery if the battery has a white casing.
- Connect your charger to an extension wire or wall outlet.
- Allow the battery to charge or keep charging. While the battery is charged, do not leave the key in the ignition. It may take up to twenty-four hours to charge your BMW battery if it is completely drained.
The average time it takes for all BMW systems to “sleep” is between 15 and 30 minutes. The battery still loses 0.1–0.5A even when the car is in “sleep mode.”
In This Article...
namelessman
Despite the fact that I have not had any problems, my dealer advised me to replace my factory-original AGM battery, which is 6.5 years old.
My battery is 90Ah, 900 CCA, 900A, and rated for 160 RC minutes. According to online research, a decent battery should have a voltage of 12.6V or above.
the voltages displayed on the secret menu are:
After stopping the engine and turning on the ignition, the voltage gradually drops from 13.2V to 12.3V.
Testing:
My battery was examined by the mechanics, who found that its voltage held [email protected] to 12.7V at the terminal. So it appears that the system voltage for the iDrive display is 12.3V. (with load).
AAA mobile battery tech conducted the most effective test (who happened to be at auto shop). About the 6.5-year-old battery, his $700 B2Q tester reported the following:
Whoever advised me to replace the battery is unreliable, according to the AAA mobile technician!
Charging:
The CTEK MUS 4.3, which resembles the BMW logo charger available at dealers, operates at 14.7V or [email protected] But be aware that this charger’s RECOND mode may completely kill AGM batteries, so avoid using it.
Replacing:
My Approaches:
1. Sending emails to [email protected] at a speed of 10+ miles per hour while cruising to 14.8V
2. Alternator will be partially engaged until voltage reaches 13.2V to 13.3V if voltage during acceleration is 14.4V (battery not fully charged) (now the battery is fully charged).
3. My best opinion is that the alternator on [email protected] is the BMS mechanism to “condition” a full AGM battery after the voltage is 13.2V-13.3V (completely charged).
4. To top off, use a smart charger like CTEK that charges at 14.4V (or occasionally 14.7V).
How to repair a BMW battery
If you haven’t already changed the battery in your BMW and don’t know how to do it, here is a quick method. There are nine steps that make up the battery replacement process:
- Remove your key from the ignition after turning it off. Next, find your battery. In a BMW, where is the battery? The majority of the time, you can discover it within your trunk, either on the floor or on the right side. Located it? The battery liner should be removed.
- With a 10mm wrench, unplug the negative battery terminal right away, then store the cable.
- The cable must then be disconnected from the positive battery terminal. To complete the task correctly, lift up the red plastic cover and look for a 10mm nut; you must loosen it.
- The time has come to remove the brackets. Two brackets, one on top and one on the side, support the battery. First, you should unbolt the latter using two 13mm bolts.
- Take out the battery from the trunk, but be careful because it could be heavy.
- Take images of the battery’s model number and technical specifications before you install the new battery. When registering your battery, the BimmerTech expert will need this information very much.
- Now that the old battery has been removed, gently set the new one in its place. Just make sure the settings are correct.
- crucial step Secure the battery properly. You must reinstall the brackets in order to accomplish this, being careful not to overtighten them. If not, you could break the battery housing. Connecting a Liquid Lead-Acid battery to the vent house can stop the vent house’s gasses from accumulating within your trunk if you’re installing one.
- Finally, connect the battery terminals by connecting the positive battery terminal first, then the negative terminal, after cleaning the battery posts with a battery terminal brush.
NOTE: Purchase our Battery Registration service before you ever begin replacing or registering your battery, and choose a preferred date when you could replace and register the battery simultaneously. Make sure you can do everything in one day because battery registration is required following every battery change and needs to be done immediately after battery replacement.
Will my BMW battery charge?
You may be wondering how to charge your dead BMW battery. Actually, it’s fairly easy to do, and you only need a few things at home. You’ll need a charger made especially for BMWs to start. One is available online or at your nearby BMW dealership. Simply adhere to the provided instructions after you receive the charger.
There are typically two settings on BMW chargers: “slow” and “rapid.” Fast charging is only required if your battery is fully dead; slow charging is advised for regular use. Your battery should be ready to go after it has been charged.
You’ll need to utilize a battery charger to properly charge a dead BMW battery. First, attach the charger’s positive lead to the battery’s positive terminal. Next, join the charger’s negative lead to the battery’s negative terminal. The charger should then be turned on and left running until the battery is fully charged.
Where does a BMW battery charger connect in?
Either the BMW battery can be immediately accessed through the trunk or the engine compartment using the red power terminal and the ground to attach the battery charger.
How come my BMW asks to charge the battery?
When your battery is below the recommended state of charge, your BMW may issue one of three degrees of warning. Level 1: The car appears to be functioning normally, but there is a caution message that reads, “Charge Battery.” NO servicing is required at this time; this is merely a notification.
Do you require a unique charger for a BMW?
The Flexible Fast Charger comes standard on every BMW electric vehicle. This portable device enables optimum charging everywhere you go and is compatible with any 120V or 240V outlet. At a 240V plug, you can charge from 0% to 100% in approximately 12 hours.
The pinnacle of electric convenience is the optional BMW Wallbox. It delivers Level 2 charging at 9.6 kW charging speeds (around 30 miles per hour of charging, achieving its full charge in around 12 hours), and because to its durable and weatherproof design, it can be installed in your garage or outdoors.
It is not necessary to bring any additional equipment when charging at public charging stations. CCS (for DC Fast Charging) and J1772 are the names of the standardized charging technology used in North America (for L2 charging).
You have access to any CCS or J1772-equipped public charging station. Your BMW’s navigation system and the MyBMW App will both display CCS/J1772 plug-equipped public charging stations for you to use.
What is the price of a BMW charger?
Cost of a BMW home charging station The BMW home charger itself may be ordered directly from BMW for $999, however the cost of installation may vary depending on the amount of electrical work needed, as well as any updated components needed to suit your Roslyn home for a Wallbox
Can I change the battery in my BMW myself?
Do you not adore your BMW? And you intend to continue using it for as long as possible, right? Change your oil, replace your air filters, and do other routine maintenance on your BMW as needed to ensure its longevity. Maintaining the battery in your BMW, however, is the one item that contributes the most to flawless operation of your vehicle.
However, a lot of individuals ponder whether BMW battery replacement and registration are straightforward do-it-yourself tasks or require the services of a qualified specialist. We affirm that you can manage the replacement on your own. However, if you lack computer literacy, let us handle the registration process on your behalf.
Here, we’ll go over how to install a battery in a car, examine BMW battery registration in further detail, and provide additional information on the BMW battery reset process.
Can a BMW battery be jumped?
Following the positioning of both vehicles, here is how to jumpstart a BMW: Determine the positive and negative terminals on each battery by removing the covers. Connect the first red clamp to the red (positive/+) connector on your BMW car. Connect the second red clamp to the functional battery’s positive terminal.
What occurs when the battery in a BMW is low?
After you turn off your BMW, your battery continues to run for a while. After you leave, it will continue to run your radio, lights, clock, and even the security alarm for the car. Electrical issues with your BMW could cause some components to turn off while others, like your lights, remain on, draining your battery. When you leave your BMW, make sure all electric components are turned off.
Why is the battery in the trunk, BMW?
Instead of the more conventional engine-bay-mounted battery, the majority of BMW vehicles use a trunk-mounted battery. Because of the constrained engine bay space (a powerful engine must fit into a tiny space) and the need to maintain a weight distribution that is as close to 50/50 as possible.
BMW has two batteries, right?
Each of them has two batteries. Given that you don’t seem to own an E31, it’s kind of ironic that you titled your piece “You Own,” emphasizing the word.
How long will a BMW battery last?
You might be curious about how frequently to change your car battery to guarantee the finest performance around Corona, whether you own a brand-new BMW or an older model. A BMW battery will typically last three to five years.
Can you use the trunk to jump start a BMW?
The fact that jumpstarting procedures for a BMW are remarkably similar to those for any other brand surprises a lot of Greenwich drivers. Although many BMW batteries are located in the trunk, restart connectors are located underneath the hood.
Is it possible to recharge a car battery while it is still attached to the vehicle?
You can now connect your battery charger to the car’s battery once you are comfortable with its fundamentals. Either way will work to charge the battery, whether or not the battery is still inside the car. First, secure the battery’s positive post with the positive (red) clamp.
How long does it take to recharge a dead battery in a car?
To create the power required to charge your battery, your engine must turn at least 1000 revolutions per minute (RPM). Your battery will recharge more quickly at speeds of 55 MPH or higher since quicker speeds produce more RPMs. Most vehicles’ batteries can be fully recharged after around 30 minutes of highway drive. Remember that the typical wait time is 30 minutes. It can take even longer to recharge your battery if it is severely drained.