It’s easy to replace the battery in fobs that include removable batteries:
- Slide out the internal key blade by holding the button at the fob’s base.
- Utilize the tiny gap around the fob’s edge to pull off the backplate.
- Replace the battery with a comparable model, either a CR2450 or a CR2032, depending on your fob.
- Return the internal key blade and clip the backplate into position.
Older rechargeable fobs and diamond-shaped keys are glue-sealed and cannot have the battery changed. The fob can get hurt if you try to pry the backplate off in this situation.
In This Article...
Can I change the battery in my BMW key myself?
Although the battery in this key is not intended to be changed, it can be done by cutting the casing apart and soldering a new battery. You’ll need a VL2020 battery to swap out this BMW key battery. The manufacturer does not advise performing this operation.
How much does a new BMW key battery cost?
I recently visited the business. The key fob wouldn’t work to lock or unlock my car when I tried. My BMW key fob’s battery has to be changed.
In less than two minutes, find out if your auto insurance is being overcharged.
Batteries for key fobs typically last three to four years. Your current BMW key fob might need to be replaced, depending on the model.
You should replace the battery in your smart key or Comfort Access BMW key fob by following these simple instructions:
- Get a CR2032 battery from a department or auto store. It will cost you around $2 to buy it.
- By depressing the tab on your key fob, you can take the valet key off.
- To pry open your battery cover, use the key or a flathead screwdriver.
- Replace the old battery with the new one after removing the old one.
- Restore the key to its housing and close your key fob.
You have a non-comfort access key fob if you are unable to open it because it has an indent in the side. You must take a long drive to recharge your key fob battery because it can only be done through the ignition of your automobile.
Once the battery has been successfully replaced or recharged, make sure to test it by locking and unlocking the doors several times. To find out how much you can save on your auto insurance before you leave again, take a moment to glance at the Jerry app.
The Jerry app, a registered broker that provides end-to-end support, compiles reasonable rates, assists you in switching plans, and even assists you in terminating your old policy.
The BMW key uses what kind of battery?
The battery in your BMW key is a CR2032. the old BMW key fob batteries with care, then gently insert the new one after removing the key fob cover.
What happens if the battery in your BMW key dies?
You won’t be able to use keyless entry or remote unlocking if your BMW has Comfort Access if the battery in your key fob has died. You can still enter and manually start your automobile, though.
Press and hold the key release button at the remote fob’s base while unlocking the door of your car, then slide out the internal key blade. This can be used in place of a standard key to unlock your car. You can locate a little hole on the bottom of the handle if the keyhole is hidden on your car door. Use the key blade to pry off the trim panel and expose the keyhole by inserting it into the hole.
Once you’re inside, put your remote key fob in the ignition slot or, if your car doesn’t have one, press it up against the steering column’s key markings. If your key fob dies, you will still be able to start your BMW using the start/stop button on the dashboard.
Can a BMW key be recharged?
While in the ignition, BMW keys are charged. Inductive charging will be used to recharge the key’s battery from positions 1 (KL R) and 2 (Run). Simply connect an automotive battery charger to your car’s battery pos/neg if you have a low battery and want to recharge the key without driving. Jump-start the engine bay terminals, then turn the ignition to position 1 and leave the car running over night. Your car’s battery won’t discharge while the key is being charged thanks to the charger.
The time it takes to drive 30 miles to recharge a dead battery To fully recharge the battery, allow 15 key pushes and 30 hours of driving in total.
Can a BMW battery be replaced without reprogramming?
Let’s first focus on what BMW battery registration genuinely is before delving into the procedure. Battery registration, to put it simply, is the process of notifying your car that a brand-new battery has been installed. Importantly, it must be done every time you replace the battery in your BMW, model year 2002 or later.
The car adapts the amount of energy required to recharge to operate at peak levels as your battery ages and gradually loses its ability to charge. The battery needs more charging the older it is. By registering your battery, you can inform your engine control module (also referred to as DME — Digital Motor Electronics) that a new one has been installed. As a result, the vehicle will reset the old battery statistics and won’t attempt to overcharge the new battery under the assumption that the old one is still in place.
In addition to registering, you must also code your BMW computer. No matter how different or similar your new battery is from your previous one in terms of specifications, it will still be necessary each time you change it.
Do you need to reconfigure your BMW key fob after changing the battery?
BMW Key Fob Battery Replacement Programming a New BMW Key from Scratch Programming a new BMW key is typically quick and painless. When the key fob first gets to your home near Decatur or Pekin, you’ll still need to program it.
What does a BMW with a depleted vehicle key battery mean?
People typically drive shorter distances more frequently and with more accessories in colder weather (10degC). The battery can be heavily drained by heat, heated seats, heated steering wheels, the stereo, and spotlights, among other things. People will drive 5–10 minutes to the grocery store, stop the car, go shopping for 30 minutes, and then get back in the car to repeat the cycle. When stationary at a stop sign, some newer automobiles even have a feature called engine Start/Stop that is intended to save petrol. This feature turns off the engine but leaves the other consumers on. When they go home and turn off the car, it goes to sleep after a few minutes and when they turn it on again, the notice “increased battery discharge” pops up.
It can be challenging to maintain the battery’s charge when there are so many energy consumers, especially during cold weather.
It takes a lot of electricity to drive short distances while using all of these car accessories. As a result, the battery starts to deplete to the point where the engine computer detects that its current charge start is below the necessary minimum. The automobile might start the following time, but it might not have enough time to recover until it is driven for at least 45 to 60 minutes. Due to low voltage, this might result in a torrent of fault codes flooding the vehicle computer. The accessories will eventually start to turn off in order to conserve the battery for the following start and to give the alternator time to finish charging.
Do I need to reprogramme my car after changing the key battery?
A remote key fob needs to be associated with your vehicle particularly in order to be secure.
This stops people who drive the same make and model of automobile as you from using their remote to access your car. You’ll need to reconfigure the fob if changing the batteries has reset this connection or if it was somehow disrupted in order to get it to detect your car once more.
How can my BMW key fob be reset?
- Insert the key into the ignition.
- Turn it so that it is on.
- Then switch it off.
- Remove the key next.
- Finally, while maintaining pressure on your key fob’s unlock button, push the BMW logo button three times. After that, release the unlock button.
The cost of a BMW key fob
The price of a 2020 Toyota Sienna fob was comparable. Dealers, however, gave prices as low as $150 to replace a key fob for a 2017 Honda Accord. A number of BMW retailers claimed that the additional security features built into the 2020 X5 key fob justifies the roughly $500 they spend to replace and program one.
Why won’t my car key work now that the battery has been changed?
A dead battery is the most frequent cause of a key fob not functioning. Having said that, your keyfob might be having more serious issues. You might require a key fob replacement or perhaps auto door lock repair if your key fob stops operating after a battery change.
Can I change a key fob on my own?
You might be able to program a replacement yourself, depending on the make and type of your vehicle.
The steps for programming a key fob yourself can differ: Owner’s manuals from certain automakers include instructions. In many circumstances, information can be available online. The catch is that in order to complete the process quickly or at all, you might need two functional key fobs.
Therefore, it is wise to acquire and set up an extra remote before you require it. Additionally, it’s a wise move because most used-vehicle buyers, particularly auto dealers, would pay extra for a car that has at least two functional sets of keys or key fobs. Therefore, having a spare key will not only be useful when you need it, but it will also benefit you in the long run.
What happens if the battery in my key fob dies while I’m driving?
My car’s key fob seems to be coming in and going out, though. I know I merely need to replace the battery, but I don’t have much free time. What if the key fob entirely fails while I’m operating the vehicle?
This issue has been foreseen by automakers ever since the key fob was created. Nothing will happen if your key fob dies while you’re driving. Simply because the key fob is a locking and starting device only, the automobile will continue to run. The key fob has no influence over the ignition or engine once the automobile is moving.
If time is of the essence, you should be aware that changing the battery in your key fob just requires two minutes, albeit you will need to visit a general store or pharmacy to obtain the battery.
Why not change the battery in your car insurance at the same time as you replace the one in your key fob?
You can access a new quotation with just a few taps on your phone screen by downloading the Jerry app and answering a few questions.
Jerry assists you in finding and comparing rates from more than 50 leading suppliers in minutes as a licensed broker. Jerry can assist you with purchasing new insurance and even canceling your existing policy when you find a lower rate.
How often should the batteries in key fobs be changed?
Car key fobs are so practical that it’s simple to ignore them. But did you realize that regular maintenance is required for your key fob? Batteries for key fobs should be changed every three to four years, though this will depend on how frequently they are used and how well they are made.
You’d wish you had taken better care of your key fob if it were to abruptly cease working while you were far from home. Avoid being stranded and having to pay for a tow because your key fob isn’t working properly. Here are some red flags that could indicate that it’s time to replace your key fob batteries before it’s too late.